Preview only show first 10 pages with watermark. For full document please download

36210006_spec Sheet - Amphenol Antenna Solutions

   EMBED

Share

Transcript

Mounting Kit Installation Guide ANTENNA SOLUTIONS 36210006 2-Point Standard Mounting and Downtilt Bracket Kit Front Pipe Grip Installation Instructions 1. Attach the Antenna to the upper and lower Interface Brackets. Interface Bracket* *NOTE: A Stainless Steel Washer must be placed between Interface Bracket and antenna z-bracket at each connection site. 2. Assemble the Front Pipe Grips and Upper Scissor Bracket to the Interface Brackets using 3/8” locking hardware. Upper Scissor Bracket Rear Pipe Grip Downtilt Position Selector 3. Assemble Rear Pipe Grips with one 7” bolt to the Front Pipe Grips. Raise antenna to pipe. Insert second 7” bolt through Front Pipe Grips and tighten to pipe. Tighten the 7” bolts to 15Nm (11 ft-lbs) Do NOT over-tighten. Excessive torque loading will distort the Pipe Grip components. 4. Adjust the antenna to the desired downtilt position. After adjusting, find the holes in the Upper Scissor Bracket that align and install the 1/4” locking hardware to both sides. Tighten the 1/4” hardware to 15Nm (11 ft-lbs) Tighten the 3/8” hardware to 20Nm (15 ft-lbs) 5. Make all electrical connections and weatherproof with self-amalgamating tape. 1 of 1 Front Pipe Grip Rear Pipe Grip Interface Bracket* www.amphenol-antennas.com REV100312