Transcript
Room Controller E3X-MRCFP-04 E3X-MRCFP-13 E3X-MRCFP-22 These small transceivers respond to self-powered wireless occupancy sensors and light switches and other ILLUMRA RF transmitters. The Room Controllers may receive input from wired occupancy sensors to automatically turn off lights when no one is in a room. Additionally, the room controllers can extend the reach of wired sensors by wirelessly transmitting sensor status to other ILLUMRA receivers.
Simple Wireless Control Systems Manual or automatic ON and OFF controls Architectural lighting Daylighting Load shedding CA Title 24
Control The Way You Want It Wired or wireless occupancy sensors Self-powered wireless light switches Wireless light sensors More
Easy-To-Use Installs in minutes Easy coniguration Requires no switch leg wires
E3X-MRCFP-04
E3X-MRCFP-13
Range
Reliable Range 50-150 foot range (typical) Communicates with ILLUMRA switches Error checking ensures response only to appropriate wireless switches
One transmitter can control unlimited receivers within range Can act as a repeater to extend range
50-150 feet (typical)
Frequency
315 MHz
Power Supply Input Rating
8-30 VDC, 40 mA
Relay Driver
30 VDC max, 100 mA max ield conigurable
Repeater
ield conigurable
0-in/4-out
Channels
1-in/3-out
2-in/2-out
-13° to 140°F (-25° to +60°F)
Operating Temperature
-40°F to 140°F (-40°F to +60°F)
Storage Temperature Dimensions
2.88”(W) x 1.30”(H) x 0.67”(D) 7.32cm x 3.30cm x 1.70cm
Antenna
attached whip antenna (5.85”)
Save Energy, Time, and Money Create manual ON / Auto OFF or master OFF controls to eliminate energy waste. Avoid costly and time-consuming installation of hardwired controls. ILLUMRA receivers install quickly and easily without switch leg or traveler wires.
E3X-MRCFP-22
15 minutes (when motion detectors are learned)
Vacancy Timeout Radio Certiication
FCC (United States) SZV-TCM2XXC, I.C. (Canada) 5713A-TCM2XXC
Network Diagram LVRX-MICRO ROOM CONTROLLER WIRING DIAGRAM MANY SWITCHES, WIRED SENSOR AND/OR WIRELESS SENSOR, 1 RECEIVER, 3 ZONES
NWO-R12-R27NP1
+24VDC RED COMMON BLACK CONTROL ON BLUE HOLD ON YELLOW HOLD OFF BROWN NWO-R12-R27NP1
E3R-MICFP-13
OUT 3 OUT 2 OUT 1 IN 1 GND VCC
+24VDC RED COMMON BLACK CONTROL ON BLUE HOLD ON YELLOW HOLD OFF BROWN NWO-R12-R27NP1
+24VDC RED COMMON BLACK CONTROL ON BLUE HOLD ON YELLOW HOLD OFF BROWN
AC POWER 277V BROWN AC POWER 120V BLACK AC POWER NEUTRAL WHITE RELAY CONTACT RED RELAY CONTACT RED
AC POWER 277V BROWN AC POWER 120V BLACK AC POWER NEUTRAL WHITE RELAY CONTACT RED RELAY CONTACT RED
AC POWER 277V BROWN AC POWER 120V BLACK AC POWER NEUTRAL WHITE RELAY CONTACT RED RELAY CONTACT RED
GROUND GREEN OR BARE AC POWER WHITE
FIXTURE
AC POWER BLACK
GROUND GREEN OR BARE AC POWER WHITE
FIXTURE
AC POWER BLACK
GROUND GREEN OR BARE AC POWER WHITE
FIXTURE
AC POWER BLACK
BATTERY-FREE, WIRELESS SWITCHES
777 S. State St. Orem, UT 84058
BATTERY-FREE, WIRELESS SENSOR
BREAKER PANEL
HOT BLACK +24VDC
T: (801) 349-1200 F: (801) 653-4257
[email protected] [email protected] www.ILLUMRA.com
COMMON CONTROL OUTPUT
NEUTRAL WHITE GROUND GREEN OR BARE
ANY 3-WIRE 24VDC SENSOR
This device or certain aspects thereof is protected by at least one U.S. or international patent or has at least one such patent application pending.
ILLUMRA is a trademark of Ad Hoc Electronics, LLC. Other trademarks herein are the property of their respective owners. AHD0243A
1