Preview only show first 10 pages with watermark. For full document please download

Mx08fit880-02 - Jma Wireless

   EMBED


Share

Transcript

Product Specifications MX08FIT880-02 NWAV™ X-Pol Antenna | Octo-Port | 8 ft | 80° X-Pol, Octo-Port 8 ft 80o Form In Tighter with Smart Bias T (2) 698-798 MHz, (2) 824-894 MHz & (4) 1695-2180 MHz ▪ Excellent passive intermodulation (PIM) performance reduces harmful interference ▪ Fully integrated (iRETs) with independent RET control for low and high bands for ease of network optimization ▪ SON-Ready array spacing supports beamforming capabilities ▪ Suitable for LTE/CDMA/PCS/UMTS/GSM air interface technologies ▪ Integrated Smart Bias-Ts reduce leasing costs ▪ Optimized width for reduced wind loading Electrical Specification (Minimum/ Maximum) Ports 1,2 Ports 3,4 Frequency bands, MHz 698-798 824-894 ± 45⁰ ± 45⁰ 15.6 15.0 Polarization Average gain over all tilts, dBi Horizontal beamwidth (HBW), degrees1 Ports 5,6,7,8 1695-1880 1850-1990 1920-2180 ± 45⁰ 17.2 17.3 17.5 82 83 79 84 85 Front-to-back ratio, co-polar power @180⁰± 30⁰, dB >28 >28 >24 >24 >24 X-Pol discrimination (CPR) at boresight, dB >20 >20 >20 >20 >20 Vertical beamwidth, (VBW), degrees1 8.5 7.9 6 5.5 5.3 2-12 2-12 ≤ -16 ≤ -16 ≤ -15 ≤ -16 ≤ -18 25 25 25 25 25 1.5/ -14.0 1.5/ -14.0 1.5/ -14.0 Electrical downtilt (EDT) range, degrees First upper side lobe (USLS) suppression, dB1 Minimum cross-polar isolation, port-to-port, dB Maximum VSWR/ return loss, dB 0-9 1.5/ -14.0 1.5/ -14.0 Maximum passive Intermodulation (PIM), 2x 20W carrier, dBc -153 -153 -153 Maximum input power per any port, watts 300 300 250 Total composite power all ports, watts 1 1500 Typical value over frequency and tilt ©2017 JMA Wireless. All rights reserved. This document contains proprietary and confidential information. All products, company names, brands, and logos are trademarks™ or registered® trademarks of their respective holders. All specifications are subject to change without notice. Revised: March 21, 2017 MX08FIT880-02_v1 Page 1 Product Specifications MX08FIT880-02 NWAV™ X-Pol Antenna | Octo-Port | 8 ft | 80° Mechanical Specifications Dimensions height/ width/ depth, inches (mm) 95.9/ 15.4/ 10.7 (2436/ 391/ 273) Shipping dimensions length/ width/ height, inches (mm) 106/ 20/ 15 (2692/ 508/ 381) No. of RF input ports, connector type & location 8 x 4.3-10 female, bottom RF connector torque 96 in- lb (10.85 N-M or 8 ft-lbs) Net antenna weight, lb (kg) 55 (29.55) Shipping weight, lb (kg) 85 (38.64) Antenna mounting and downtilt kit 91900312 Net weight of the mounting and downtilt kit, lb (kg) 18 (8.2) Range of mechanical up/ down tilt -2⁰ to 12⁰ Rated wind survival speed, mph (km/h) 150 (241) Frontal, lateral & rear wind loading @ 150 km/h, lbf (N) 250 (1111), 173 (772), 250 (1111) Equivalent flat plate @100 mph and Cd=2, sq. ft. 5.74 Ordering Information Antenna Model Description MX08FIT880-02 8F X- Pol OCTO FIT 80⁰ 2-12⁰/ 0-9⁰ RET, 4.3-10 & SBT Optional Accessories 992100-CA030-SC Optional AISG jumper cable, M/F, 3.0 meters PCU-220 Primary control unit, USB ©2017 JMA Wireless. All rights reserved. This document contains proprietary and confidential information. All products, company names, brands, and logos are trademarks™ or registered® trademarks of their respective holders. All specifications are subject to change without notice. Revised: March 21, 2017 MX08FIT880-02_v1 Page 2 Product Specifications MX08FIT880-02 NWAV™ X-Pol Antenna | Octo-Port | 8 ft | 80° Remote Electrical Tilt (RET 1000) Information RET location Integrated into antenna RET interface connector type 8 Pin AISG connector per IEC 60130-9 RET interface connector quantity 2 pairs of AISG male/ female connectors RET interface connector location Bottom of the antenna Total No. of internal RETs low bands 2 Total No. of internal RETs high bands 1 RET input operating voltage, vdc 10-30 RET max. power consumption, idle state, W ≤ 2.0 RET max. power consumption, normal operating conditions, W ≤ 13.0 RET communication protocol AISG 2.0/ 3GPP RET & RF Connector Topology Array Topology 3 sets of radiating arrays Each RET device can be controlled either via the designated external AISG connector or RF port as shown below R1/R2 – 698-894MHz B1 – 1695-2180MHz B2 – 1695-2180MHz RET Device Band RF Port Band RF Port 1 698-798 1-2 1695-2180 5-6 2 824-894 3-4 698-798 1-2 824-894 3-4 1695-2180 7-8 RET Device Band RF Port 3 1695-2180 5-8 1695-2180 (B1) 1695-2180 (B2) 700 (R1) 850 (R2) ©2017 JMA Wireless. All rights reserved. This document contains proprietary and confidential information. All products, company names, brands, and logos are trademarks™ or registered® trademarks of their respective holders. All specifications are subject to change without notice. Revised: March 21, 2017 MX08FIT880-02_v1 Page 3