Transcript
HOW TO USE RUGGED-EYES:
WIRED SD CAMERA PROTECTIVE HOUSING
CAMERA OFF (NOT CONNECTED TO DVR POWER SOURCE)
CAMERA ON = LEDs ON (DVR RECEIVING IMAGES)
WIRED CAMERA CONNECTOR INSERTED INTO DVR AV IN PORT = POWER TO CAMERA
MOUNTED WIRED CAMERA - CABLE PASSING INTO GOOSE NECK INSIDE THE POLE
VANTAGE POINT PRODUCTS USER GUIDE – RUGGED-EYES AND MEMOR-EYES – images and wording copyright © 2015
WIRED SD CAMERA & DVR MONITOR – QUICK GUIDE Step 1 Camera: Always make sure your Rugged-Eyes wired camera is clean and dry before use, including the cable and connector. Ideally, make sure the DVR is fully charged before use (be careful not to overcharge the unit). Step 2 DVR: Switch on your Memor-Eyes DVR before switching on the wired camera. To do so, simply press the “standby” button for 3 seconds to switch the DVR on (or off). Step 3 Camera: Once you have mounted the camera (and inserted the wire into the goose neck, and down inside the telescopic pole – if provided), insert the jack connector into the AV in port on the Memor-Eyes DVR monitor. If connected properly you will see images appear on the DVR screen, sent from the wired camera. Step 4 Camera: When the camera is connected to the Memor-Eyes DVR monitor, the LEDs will turn on, and stay on as long as the connection (physical and power) is maintained.
Step 5 DVR: Manipulate the wired camera as required for your inspection, and operate the Memor-Eyes DVR monitor as advised to see live images, take photos (screenshots), and start / stop recording video. Step 6 Camera and DVR: To switch off the wired camera, simply disconnect the connector from the AV in port on the DVR (or switch off the DVR). To switch off the DVR, press the “standby” button for 3 seconds.
VANTAGE POINT PRODUCTS USER GUIDE – RUGGED-EYES AND MEMOR-EYES – images and wording copyright © 2015
HOW TO USE MEMOR-EYES:
WIRELESS 5” LCD COLOUR MONITOR AND DVR SUNSHADE
ON / OFF
LEFT: UP / REWIND RIGHT: DOWN / FAST FORWARD
BACK: STOP RECORD / RETURN
SELECT: TAKE PHOTO / START RECORD
MODE SWITCH: 1. VIDEO 2. PHOTO (MIDDLE) 3. VIDEO / PHOTO FILE MENU
MINI USB PORT AV OUT PORT AV IN PORT
MICRO SD CARD PORT
VANTAGE POINT PRODUCTS USER GUIDE – RUGGED-EYES AND MEMOR-EYES – images and wording copyright © 2015
WIRELESS 5” LCD COLOUR MONITOR AND DVR (WITH INTEGRATED FLIPOUT SUNSHADE) FRONT OF DVR “On / Off” Button Video Button* (when side function mode switch is in top position) Photo Button* (when side function mode switch is in middle position) Select Button (*same as photo / video button) Back button (within menu screens) Right arrow button
Left arrow button
LEFT SIDE OF DVR Mini USB port AV out AV in Micro SD card slot Function mode switch
RIGHT SIDE OF DVR Antenna screw mount Reset port button UNDERNEATH DVR ¼”-20 female mount
DVR On / Off (3 second press) Single press to start recording Single press to pause recording Single press to re-start recording Press Back button to stop recording (automatically saves file in video file menu) Press to take photo (automatically saves file in photo file menu)
Single press to select a function in the settings menus, or photo / video file menus Return to main screen from front of menus (photo ready mode, video ready mode, or live view) Return back a page in the settings menus or photo / video menus Navigate through settings menus or photo / video menus Fast forward through video file (playing on screen) Select video receiver channel in manual mode (“MANU”) Navigate through settings menus or photo / video menus Re-wind through video file (playing on screen) Select video receiver channel in manual mode (“MANU”)
For charging DVR, and for data out to laptop / PC to view and download files Once downloaded, files are stored in the “DCIM” directory Headphone port Video out to second monitor (or similar) Receives video from and supplies power to the Rugged-Eyes wired camera Note correct position to insert SD card Accepts up to 32GB Micro SD Card Top position Video ready mode (back button takes you to settings menu) Middle position Photo ready mode (back button takes you to settings menu) Bottom position automatically takes you to Photo and Video file menus
External screw mount for antenna (also accepts other antenna types, i.e. dipole clover leaf) Inserting a blunt pin-like object in here will reset the DVR if software crashes
Female mount to receive male ¼”-20 screw mount
VANTAGE POINT PRODUCTS USER GUIDE – RUGGED-EYES AND MEMOR-EYES – images and wording copyright © 2015
CHARGING RESTRICTIONS It is very important that none of our products are overcharged, or charged at a rate unsuitable for the unit’s internal batteries. Rugged-eyes (wired camera):
This unit is powered by the Memor-Eyes internal rechargeable battery (see specification for performance). We recommend that you always power the wired camera from a fully charged Memor-Eyes DVR monitor.
Memor-eyes:
Wireless DVR: 0-100% mains charged in 4 hours minimum (4 bars full battery displayed on screen), but ideally 6 hours for maximum charge. Unit can be charged for less than four hours, if required, but battery life will reflect this (as with any lithium based battery powered devices, do not overcharge the unit or you may permanently damage it). Just like your mobile phone, as with all lithium battery powered devices, even if unused for a period, the unit must be checked and re-charged to 100% capacity at least once every month, in order to be ready for use.
Lithium based batteries reach their optimum performance only once they have been fully charged, and fully discharged a few times. For instance, the battery may charge quicker, or last longer after the third of fourth recharge / discharge from new.
ENVIRONMENTAL RESTRICTIONS
0-40 degrees centigrade is the best working temperature for the wired camera. The wired camera is waterproof and submersible, but not for prolonged periods. The wireless DVR must not be used in areas of high temperature, high humidity. 0-40 degrees centigrade is the best working temperature for the wireless DVR. Do not leave the DVR in direct sunlight, whether the unit is on or off. The wireless DVR is not waterproof, or splash proof, and any moisture should be removed from the DVR body, screen and ports or this may cause a failure of operation.
VANTAGE POINT PRODUCTS USER GUIDE – RUGGED-EYES AND MEMOR-EYES – images and wording copyright © 2015
DATA STORAGE:
Please ensure that the micro SD memory card is inserted correctly, as indicated in the image on the wireless DVR. The memory card should be formatted the first time it is inserted into the wireless DVR, before use. We highly recommend that the user download the data held on the wireless DVR micro SD card at least daily, to reduce any risk of loss of data, however unlikely. Download the data by connecting the mini to standard USB cable (as provided) between the wireless DVR and your laptop / PC (or device that has a standard USB port). Most PC / MAC OS will automatically detect the connection, and open a suitable program for you to download, view and manage video and photo files (i.e. Picasa).
RUGGED-EYES Wired camera: Specification Overview Sensor chip: Sensor dimension: System: Horizontal resolution: Sensitivity: Lens and viewing angle: Video out LED illumination: LED activation: Battery power: Power requirement: Working current: Operating temperature: Size of camera (not cable) Full charge working time (LED’s on):
Rugged-Eyes wired Standard Definition (SD) camera Single chip 1/4 CMOS 3.58mm x 2.68mm NTSC: 720 x 480 // PAL: 728 x 576 Approx. 520TV Lines (TVL) 0.00 Lux / 5m 0.5mm f1.2 / 90 degrees 1.0 V p-p/75ohm 8 x 2200mcd LED = 17600mcd Always on when connected to Memor-Eyes DVR AV in port power Powered by Memor-Eyes DVR internal battery DC 5V – 24V (normally powered by Memor-Eyes DVR internal battery) DC 5V:70Ma (LEDs off) / 260Ma (LEDs on) // DC 12V:30Ma (LED off / 100Ma (LEDs on) -10 degrees C to plus 40 degrees C // less than 90% Relative Humidity 40mm (L) x 30mm (W) 4.5-5 hours (powered by fully charged Memor-Eyes internal battery)
VANTAGE POINT PRODUCTS USER GUIDE – RUGGED-EYES AND MEMOR-EYES – images and wording copyright © 2015
MEMOR-EYES: Specification Overview Wireless receiving:
Sensitivity: Wired receiving AV IN AV OUT LCD screen
Video resolution: Video compression: Play format: Photo format: Data Storage: Operating system:
Power:
Battery life:
Size: Weight:
Memor-Eyes wireless 5” colour monitor and DVR 2.4Ghz - over 8 channels – auto switching for optimum signal A1 = 2414MHz A2 = 2432MHz A3 = 2450MHz A4 = 2468MHz A5 = 2490MHz A6 = 2510MHz A7 = 2390MHz A8 = 2370MHz -88dB Via AV in port (Rugged-Eyes Wired Camera) TV System NTSC / PAL Output voltage: 3.6-4.2V TV System NTSC / PAL Size 5 inch diameter Active area: 108mm (W) x 64.8mm (H) LCD screen Resolution: 800x480 Pixels LCD screen Luminescence: 300 cd/M squared 720x576 720x480 MPEG-AVI 30 FPS MPEG-AVI JPEG External micro SD card TF card 1GB-32GB accepted PC Windows & Mac OS Port USB 2.0 Multi language Voltage DC 5V Current (receiving) 660mA Current (recording) 680mA Current (recording - off screen mode) 340mA AC adapter DV 5V 2A Built in Lithium rechargeable battery 3200mAh Approx’ 5 hours (on screen recording, receiving 2.4GHz signals from our wireless camera) Approx’ 4.5 hours (on screen recording, receiving data from, and supplying power to our wired camera) 131mm (L) x 90.5mm (H) x 18mm (W) (not including sunshade) 215 grams (without sunshade)
VANTAGE POINT PRODUCTS USER GUIDE – RUGGED-EYES AND MEMOR-EYES – images and wording copyright © 2015
