Transcript
INSTRUCTION GUIDE
SPECIALIZED TURBO CHARGERS (SBC-C02, SBC-C03, SBC-C04) THIS BRIEF INSTRUCTION GUIDE CONTAINS IMPORTANT INFORMATION. PLEASE READ CAREFULLY AND STORE IN A SAFE PLACE. WARNINGS AND SAFETY NOTES This guide is to be used in conjunction with the Specialized Turbo Bicycle Owner’s Manual that was provided with the Specialized Turbo. Please carefully read all warnings and notes in this instruction manual before using the bicycle. We recommend keeping the manual close to your bicycle, so that it is always at hand. Neglecting to follow the instructions and safety precautions can lead to short circuits, fire, electrical shock and/or serious injury. The charger is only for use with the Specialized Turbo. Use with any other bicycle will void the warranty, and can result in injury and/or death. Disconnect the charger from the Turbo bicycle before performing work of any kind (eg installation, maintenance, repair, transportation). Do not modify or disassemble the charger. Modification or disassembly that results in a short circuit, fire or malfunction will void any warranty claims. Do not overheat the charger. Protect the charger from excessive sun exposure, especially in hot summer months. Do not expose the charger to an open fire or to radiator heat. Do not throw the charger into an open fire or submerge in water. Subjecting the charger to these conditions can result in a fire or other damage. Charge the battery only within the temperature range of 0° C (32° F) to +50° C (122° F). Discharge the battery only between the temperature range of -20° C (-4° F) and +70° C (158° F). Store battery below +35 ° C (95° F). Before you switch the system on, ensure that the cover of the magnetic rubber plug is attached to the frame. The contacts below it are live with electricity when the system is switched on. Please only use the Specialized charger supplied with the bicycle or other chargers approved by Specialized. Check the charger before every use for possible damage to the charger itself, the cable or the plug: Never use a charger which you suspect is damaged or know is broken. Please read the instructions relating to the charger and battery before using it for the first time. The operating voltage is 100-240 V.
Cleaning The charger has to be switched off and separated from the battery before cleaning. Clean the ventilation grills if required with a dry cloth or a vacuum cleaner.
Using the charger During the charging process, the diode on the charger will glow red. When the battery is fully charged, the diode on the charger will turn green. The battery can now be put to use (fig.1&2). Charge the battery in a dry place and ensure there is sufficient ventilation. Do not allow the charger to come into contact with rain, water or moisture. Neither the battery nor the charger should be covered during the charging process. Please ensure that you do not have any flammable or dangerous substances in the charging room. Place the charger in a stable position so that it cannot fall over. When cleaning the charger, always first unplug the device.
1 SBC-C03
OFF ON
WARNING! This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
SBC-C02
SBC-C04
CHARGING
WARNING! Only use the Specialized chargers SBC-C02 / C03 / C04 with Specialized Turbo batteries SBC-B01 / B02 / B03. Do not use the chargers for other batteries, including non-rechargeable batteries. WARNING! If the red LED flashes during the charging process, a charging error has occurred. If this is the case, please remove the charger from the socket immediately and contact your Specialized authorized dealer to identify the fault. In this case, the bicycle, battery and the charger may no longer be used. However, you are permitted to use it as a conventional bicycle without electrical support. To allow you to use the bicycle in this case on public roads, you are obliged to use an external dynamo, such as a hub dynamo.
FULLY CHARGED PROBLEM
2
FULLY CHARGED
CHARGING
Charging process To charge the battery, you don’t have to take it out of the bicycle (fig.3). To do this, remove the magnetic rubber plug in the top right of the frame.
Main charger
Travel charger
In order to ensure the best possible charging results, please remove the battery from the bicycle in cold conditions and charge it in a warm room (fig.4). Please charge the battery in temperatures between 0° C (32° F) and 50° C (122° F). Please refer to the Specialized Turbo Battery Instruction Guide for additional information. At temperatures outside this range, you can damage the battery which can lead to a loss of performance. You can attach the charging plug directly into the charging socket in the frame. The plug is held in place magnetically. Due to the special shape
1
of the charging socket and effective placement of two magnets, we ensure that the charging plug can only be connected to the socket in the correct position. The magnetic rubber plug can be attached to the down tube (fig.3) when the battery is being charged. 3
Li-ion Battery Charger
Battery with rubber plug for transport
4
MODEL: MDA11542002000 (SBC-C02) INPUT: 100-240V ,1.6A (MAX.) ~ 50/60Hz OUTPUT: 42.00V 2.0A -
+ T
RED LIGHT MEANS CHARGING GREEN LIGHT MEANS CHARGE-FULL OR DISCONNECT
LISTED
E340833 4EK5 Class 2 Battery Charger
BC
RoHS
CAUTION
RISK OF ELECTRIC SHOCK.DRY LOCATION USE ONLY.SEE INSTRUCTION MANUAL FOR USE
Charging the battery in the bicycle
Manufactured by Shenzhen Modiary Co., Ltd. Exclusively for Specialized Bicycle Components
Charging the battery out of the bicycle
MADE IN CHINA
NOTE: Battery charger decal subject to change depending on charger model.
Charge the battery in a dry and warm place. Please also ensure that there is sufficient ventilation. The heat created during the charging process has to be able to escape from the charger.
WARNING! Check the charger before every use for possible damage to the charger itself, the cable or the plug: Never use a charger which you suspect is damaged or know is broken. Please read the sticker on the charger before using. Place the charger and the battery on a level, non-flammable surface. Plug the charger plug into the socket (100 - 240V), using the appropriate plug for the country’s standards. Connect the charger plug with the socket on the battery. While the battery loads, the red LED on the charger glows red and the green LEDs on the battery flash (the number of LEDs flashing will increase as the charge level in the battery increases). When the battery is fully charged, the green LED on the charger glows green, and the green LEDs on the battery turn off (refer to fig.1 & 2 on page 1). If you use the optionally available Specialized travel charger, the color of the LED will switch from red (charging process) to green (charging process complete). Approximate charging time of an empty battery (Standard Charger / Travel Charger): SBC-B01
SBC-B02
SBC-B03
2.5 hours / 5 hours
3.5 hours / 7 hours
3.3 hours / 6.5 hours
After completing the charging process, the charger can remain connected to the battery without the danger of overcharging. However, we advise separating the charger and the battery after successfully completing the charging process as this helps to save electricity.
Disposal Used chargers should not be disposed of with domestic waste. In the EU, consumers have a legal obligation to return defective, unused or non-functioning chargers, while dealers, manufacturers and importers have an obligation to accept them. You can return used batteries to a recycling facility or to your Authorized Specialized Dealer. According to directive 2002/96/EC of the European Parliament on waste electrical and electronic equipment (WEEE), defective or chargers no longer in use, must be collect separately and disposed of in an environmentally friendly manner. Please inform yourself about the applicable national regulations in your specific state or country.
Technical Data RATED VOLTAGE (AC)
V
100-240
ALLOWABLE CHARGING TEMPERATURE RANGE
°C (°F)
0 - 50 (32 - 122)
CHARGING CURRENT (Standard / Travel)
A
4/2
WEIGHT (Standard charger, SBC-C03 / C04)
Kg
2.25 / 1.00
BATTERY CHARGING VOLTAGE (DC)
V
42
WEIGHT (Travel charger, SBC-C02)
Kg
0.65
BATTERY TYPE/OPERATING VOLTAGE
V
Li-Ion / 36
NOMINAL CAPACITY / ENERGY (SBC-B01)
Ah / Wh
9.5 / 342
50 (10S5P)
NOMINAL CAPACITY / ENERGY (SBC-B02)
Ah / Wh
14 / 504
50/60
NOMINAL CAPACITY / ENERGY (SBC-B03)
Ah / Wh
13 / 468
CELL COUNT FREQUENCY
SPECIALIZED BICYCLE COMPONENTS
Hz
15130 Concord Circle, Morgan Hill, CA 95037 (408) 779-6229 0000024258_IG_EN_R3, 06/14
2
Please note all instructions and notices are subject to change and updates without notice. This guide, and additional languages are available online at www.specialized.com. Please visit www.specialized.com for periodic tech updates. Feedback:
[email protected]
