Transcript
Standard equipment
Pit construction diagram 00703612A
2 Pit brackets, lengthwise 2 Pit brackets, crosswise 2 Cover strips 4 Nuts M8 DIN 934 4 Hex bolts M8x20 DIN 933 1 Locking plate 4 Dowels
METTLER TOLEDO MultiRange Dry and wet pit KC/MC/DC/KCS/MCS/DCS line Subject to technical changes © Mettler-Toledo (Albstadt) GmbH Printed in Germany 06/04 english
1. Determine location of weighing platform
4 Screws 4 Washers 1 Rubber grommet 1 Accessories bag with parts for scale installation 1 Pit construction instructions
KC/MC/DC/KCS/MCS/DCS line
Dry pit KC/MC/DC 113.7 KCS/MCS/DCS 93.7
2. Determine location of terminal
15
A Good, sufficient room to load pallets on the weighing platform
1
1 Set up terminal to ensure good access
C Wrong, unnecessary wear on weighing platform
Length of connection cable terminal 5 m (standard)
Note maximum static load: min. 1300 kg/25 cm 2
82.4
2
3. Prepare framework pit
2
Excavate framework pit as specified in the table below.
A
1
Pipe diameter min. 4 cm. Do not use a right-angled pipe, rather two pipes of 45°
A
Section A-A
11 cm > 4 cm
45°
45°
B
KC/MC/DC - Dry pit - Wet pit
165
140
KCS/MCS/DCS - Dry pit - Wet pit
140
X
Wet pit
20 30
1
130 20 30
KC/MC/DC 113.7 KCS/MCS/DCS 93.7 18
15 1
X 82.4
4. Concrete forming Assemble steel pit frame. When tightening the bolts ensure that the frame is flat. Check that the frame is rectangular.
2 2
Prepare stable wooden frame (see sketch for dimensions). The steel frame must fit the wooden frame exactly. Install wooden frame together with steel frame in the framework pit. The steel frame must be exactly horizontal.
B
A KC/MC/DC KCS/MCS/DCS
When concreting ensure that the wooden frame remains in place. Wet pit: After the pit base has set and the formwork removed, concrete the supports for the leveling feet of the weighing platform (see Dimension drawings).
1 Supporting surface for levelling feet of the weighing platform 2 Cable conduit
10
LxB
L
15
Only wet pit: Ensure appropriate gradient for drain water. Install recess with siphon as shown.
X
1
12
Excavate channel for cable conduit. The cable conduit ends in the base of the pit (see illustration).
113.7 93.7
X
12 A 82.4
Section X-X
1
1
B
12
C A
1 Supporting surface for levelling feet of the weighing platform 2 Cable conduit
10
B Unsuitable, difficult to access
Section B-B
20
B
Pit construction diagram 00703612A
5. Dimension drawings Dimensions in cm
