Transcript
CLS/TLS Auto trans Supercharger Checklist Customer / PO# :_______________________________________ Date / Assy. by:_________________________________________ Supercharger Kit Number
350-062
Fuel Pressure Regulator (Automatic)
(360-020-7)
(Refer to Drawing for Parts)
(355-200)
Main Blower Kit □ Blower w/ driveshaft ID#_______________ □ Drive Woodruff Key □ Pulley Nut □ Pulley Hardened Washer □ Blower Pulley (4”) □ Drive Shaft Mount □ Main Mount □ (4) Blower Mt. SHCS (6x35) □ Main Mount Adj. Bobbin
355-107 355-107-3 355-107-2 355-121T 355-119 355-111 355-110 802-2011 355-122
□ □ □ □ □ □
Tensioner Plate (2) Tensioner Plate Bolts (8 x 35) Tensioner Pulley Tensioner Spacer (Long) Tensioner Spacer (Short Tensioner Bolt (LH thread)
355-113 800-3019 352-070 355-114 355-115 800-8019
□ □ □ □ □
Blower Inlet Manifold Blower Inlet Manifold O-Ring (3) Inlet Mount Bolts (8 x 20) Inlet Mount Stud (8 x 25) Inlet Mount Nut (8mm)
355-101F 805-025 800-3003 801-1020 803-1020
General Parts Kit
(355-213)
□ Fuel Pump □ FPR Mtg Bolt (6x14)
360-010 800-2002H
□ Battery Box Assembly □ Battery Hold Down □ Battery Clamp Bolt (6x75)
355-124A 710-050CLR 800-2011
□ Radiator Overflow Bottle □ Upper Radiator Hose □ P/S Reservoir Bracket
355-126 355-155 355-128
□ □ □ □ □ □ □
340-055 800-3006 800-4017 805-022 805-027 901-152 806-040
ESM Unit V6 - preset to 2.80 v (2) cam seal bolts (8 x 30) Adj. Bobbin bolt (10 x 40) Cam Seal O-ring EGR valve gasket (PGE) (2) Throttle body gasket (6) Denso IK 22 Spark Plugs
□ Modified Fan shroud (Prod. Entry?) □ (3) Fan Shroud Screws (5x25) □ (3) Fan Motor spacers
901-158M 800-1001 355-137
□ Blower Outlet Manifold □ Manifold O-Ring □ (5) Blower Outlet Mt Bolts (8 x 20)
355-100F 805-024 800-3003
Ice Box Kit
300-130
□ Blower Support Bracket □ Blower Support Bolt (8 x 40)
355-118 800-3017
Fuel System Adapter Kit
(355-214)
Intake Manifold Kit □ □ □ □ □ □ □ □ □ □ □
Intake Manifold Inlet Elbow Bypass Valve Vacuum Barb Fitting Port Block-off Bolt (10/32 x 5/16) Washer, 10-32 NAS SS (Thick) Silicone hose (3” diam x 2” long) (2) Hose Clamps (#48) Intake Bolt (8x75) (3) Intake Elbow Bolts (8x25) MAP Sensor Block-off Plate MAP Block-Off O-Ring (2) MAP Block-Off Scews (4x16)
□ □ □ □
Intake Elbow (w/Fittings) Elbow, T/B to T/B Fitting, 10mm Trac Control Fitting, 13mm Trac Control
3” to 3” Rubber Bellow Silicone Hose (3” diam x 2” long) (3) TCS Bolts (8 x 50) TCS Elbow O-ring
Alternator Drive Kit □ □ □ □ □
355-103F 354-116 802-6020 804-0110 811-009 812-022 800-3018 800-3016 352-068 805-001 802-1004
(355-217)
TCS Adaptor Kit □ TCS Cast □ □ □
(355-211)
Alternator Pulley (3.0”) Alternator Blower Mount Drive Belt (#4040252) Long Alternator Shaft Spacer (2) Intake Elbow bolts (8x25)
(355-105F) 355-105 355-130 355-131
811-017 811-009 800-3015 805-026
□ □ □ □
12mm > AN6 Adaptor w/Washer Push on Hose End (-4AN) Fuel return hose (5/16” x 7.5”) (2) Fuel Line Hose Clamp #4
□ AN Fuel Hose(-6 90° x 12”) □ Push-on Hose -6 Black 12” □ (2) Push-on Hose End (-6 90°)
Coolant Bottle Hose (5/16” x 10”) T/B Water Hose (5/16” x 10.5”) T/B Water Hose (5/16” x 17”) TCS Water Hose (5/16” x 24”) TCS Water Hose (5/16” x 27”) Solenoid Vacuum Hose (5/16” x 36”) Bypass Valve Vacuum Hose (6.5”) FPR Vacuum Hose (9”) Valve Cover Vent Hose (1/2” x 19”)
Documentation Kit □ □ □ □ □
(816-014) 814-323-12” 814-322
(355-215)
Hose Kit □ □ □ □ □ □ □ □ □
813-005 814-308 811-001-7.5” 812-009
ESM Installation Instructions Instruction Sheet CARB sticker Warranty Card (2) CTE Decal (Small)
811-001-10” 811-001-10.5” 811-001-17” 811-001-24” 811-001-27” 811-001-36” 811-002-6.5” 811-002-9” 811-020-19”
(355-216) INS-091 INS-125 730-116 099 Warranty 730-109
(355-212) 355-135 355-112 350-058 355-120 800-3016
Revised: 02/26/08 NH
