Transcript
Installing the 0.75:1 lens These instructions outline the details for the installation of the 0.75:1 Front Projection Lens (P/N 125-105107-xx) and the safety cables that accompany it. These cables are necessary because this lens has a much higher mass than a typical lens. This lens is supported for these Matrix StIM projector models: 125-001102-xx, 125-001113-xx, and 125-001124-xx.
Kit includes •
0.75:1 Lens, qty. 1
•
Safety Cables, qty. 2
•
Washers Lock, qty. 4
•
Screw M6, qty. 4
Tools required •
5mm Allen key, included in the User Kit (P/N: 125-107109-xx)
Installation Caution! Failure to comply with the following could result in minor or moderate injury. • Before you begin, ensure that the projector is securely mounted and cannot move. The 0.75:1 lens is much heavier than other typical lenses and could potentially tip over an unmounted projector, causing injury.
1. Remove the rear lens cap from the lens. Keep the front lens cap on the lens.
Installing the 0.75:1 Lens Instruction Sheet 020-100656-01 Rev. 1 (12-2014)
1
Installing the 0.75:1 lens
2. Rotate the lens clamp to the open position.
3. Remove and retain the two security screws from the lens mount. This kit is equipped with screws in case there are none in the lens mount.
4. Remove and retain the two screws from the lower mounting point. This kit is equipped with screws in case there are no screws in the lower mounting point.
5. Align the lens interface plate with the lens mount.
Installing the 0.75:1 Lens Instruction Sheet 020-100656-01 Rev. 1 (12-2014)
2
Installing the 0.75:1 lens
6. Fully insert the assembly straight into the lens mount opening without turning and press with your hand to engage the magnetic lock. Caution! Failure to comply with the following could result in minor or moderate injury. • Ensure the lens is not inserted at an angle as this can cause damage. • This lens is much heavier than a typical projection lens, and the magnetic lock is not sufficient by itself to secure the lens. If the lens falls, it could result in injury.
7. Rotate the lens clamp to the closed position. 8. Attach the safety cable to the lens. Notice. Failure to comply with the following may result in property damage. • Security screws must be installed.
a. Align the O-ring bar parallel to the side of the lens and place it over the security screw hole. b. Place a washer over the hole, and fasten the security screw through the O-ring. c. Position the O-ring at the other end of the cable at the lower mounting point, position a washer over the hole, and fasten the screw through the O-ring.
Installing the 0.75:1 Lens Instruction Sheet 020-100656-01 Rev. 1 (12-2014)
3
Installing the 0.75:1 lens
9. With the other safety cable, repeat step 8 for the corresponding security screw and lower mounting point on the other side of the lens.
10. After aligning the boresight, tighten the boresight setscrews to a minimum torque of 7 in-lp.
For information on boresight alignment, see the Matrix StIM User Manual (P/N 020-100306-xx).
Installing the 0.75:1 Lens Instruction Sheet 020-100656-01 Rev. 1 (12-2014)
4
