Transcript
CDM-9803 In-Dash CD Player/CD Changer Controller F E AT U R E S Tuner MaxTune Tuner Preset Stations (FM:12/AM:6) Auto Memory Local/DX Selection Preset Address Indicator Up/Down Seek CD Player Digital Servo Music Sensor (Up/Dn) Forward/Backward Disc Play/Pause M.I.X. (Random Play) Music Scan/Repeat Regulated 1-Bit DAC CD-R/CD-RW Compatibility CD Changer Control Music Sensor Up/Down Forward/Backward Disc Play/Pause M.I.X. One (Random Play) Music Scan/Repeat General 50W x 4 High Power Amplifier 2 PreOuts Versatile Link Ready (M-Bus) Bass Engine® Subwoofer Level Control Bass Type Control Bass Center Frequency Control Bass Band Width Adjustment Treble Center Frequency Control BBE Processor Rotary Encoder Volume Control Separate Bass & Treble Control Fader & Balance Controls S.T.M.(Source Tone Memory) Audio Mute Black Face w/Green Illumination Buttons Anti-Theft Detachable Front Panel Detachable Trim Plate Power Antenna Lead Remote-on Lead
S P E C I F I C AT I O N S AM Tuner Tuning Range ..................................................................................530-1, 710kHz Usable Sensitivity (IEC Standard) .......................................................22.5µV/27.0dB FM Tuner Tuning Range.................................................................................87.7-107.9MHz Mono Usable Sensitivity........................................................9.3dBf (0.8µV/75 ohms) 50dB Quieting Sensitivity....................................................13.5 dBf(1.3µV/75 ohms) Alternate Channel Selectivity ........................................................................80.0 dB Signal-to-Noise (S/N).................................................................................65.0 dB Stereo Separation ......................................................................................35.0 dB Capture Ratio .............................................................................................2.0 dB CD Player Sampling Rate ..........................................................................................44.1kHz Signal-to-Noise (S/N)..................................................................................105 dB Channel Separation (1kHz) ............................................................................85 dB Dynamic Range (1kHz) ..................................................................................95 dB Total Harmonic Distortion (THD) .......................................................0.008% (at 1kHz) Frequency Response .............................................................................5-20k ±1 dB DAC Type / Number of DACs ......................................................Regulated 1-Bit / 2 Oversampling ...................................................................................8X/352.8kHz Wow & Flutter (%WRMS) ................................................................................B.M.L Bass Engine® Subwoofer Level Adjustment Range .........................................-15dB to 0dB (1dB steps) Bass Type (Selectable) .....................................................Off /Type1 / Type2 /Type3 Bass Center Frequency (Selectable)..................................60Hz, 80Hz, 100Hz, 200Hz Bass Band Width Adjustment (Q).................................4 choices (1=Wide, 4= Narrow) Bass Level Control Range ..................................................±14dB at 60Hz (2dB steps) Treble Center Frequency (Selectable) ..................10.0kHz, 12.5kHz, 15.0kHz, 17.5kHz Treble Level Control Range............................................±14dB at 10.0kHz (2dB Steps) General Power Requirement / Fuse Type ................14.4V DC (11 –16 V allowable) / 15A (ATC) Operating Temperature (°C/°F) .......................................60°C (140°F) to -10°C (14°F) Maximum Mounting Angle ...........................................................30° from Horizontal Maximum Power Output (Note 1) ..................................................................50Wx4 Continous Power Output (Note 2) ..................................................................23Wx4 Pre Output Voltage (Before Clipping) ................................................................2 volts Chassis Size (W x H x D)mm..............................................178mm x 50mm x 160mm Chassis Size (W x H x D)in...................................................................7"x2"x6-1/4" Nose Piece Size (W x H x D)mm ..........................................170mm x 46mm x 18mm Nose Piece Size (W x H x D)in........................................6-3/4" x 1-13/16"x 11/16" Weight ........................................................................................1.5kg (3lbs. 5oz) Note 1: Under maximum operating voltage and input signal, into 4 ohm loads Note 2: Per EIA-517 standard, 40Hz to 20Hz, 0.8%THD, with 14.4 volt DC Supply
Revision-B-10112002
2003 © Alpine Electronics of America, Inc. Specifications and design are subject to change without notice
Four Speaker Hook-Up Violet
Right Rear Speaker Output Lead (+)
Violet/Black
Two Speaker Hook-Up
Right Rear Speaker Output Lead (-)
Grey/Black Grey Green
Right Front Speaker Output Lead (-)
Right Speaker Output Lead (-)
Right Front Speaker Output Lead (+)
Right Speaker Output Lead (+)
Left Rear Speaker Output Lead (+)
Green/Black
Left Rear Speaker Output Lead (-)
White/Black White
Left Front Speaker Output Lead (-)
Left Speaker Output Lead (-)
Left Front Speaker Output Lead (+)
Left Speaker Output Lead (+)
Remote Turn-On (Blue/White - +12V Output 300mA Max.) Power Antenna Lead (Blue - +12V Output 300mA Max.) Ground Lead (Black) Ignition Lead (Red) Battery Lead (Yellow) Fuse Holder (15A)
A Power & Speaker
Subwoofer Activation
1
Output Connector Pin Configuration
8 7 6 5 4 3 2 1
Battery (Yellow)
To activate the subwoofer output. 1. Press and hold F/SETUP for 3 seconds
10 11
Rear Left (-) Output (Green/Black) Rear Left (+) Output (Green)
4
12
5
Front Right (+) Output (Grey)
13
6
Open
14
Rear Right (-) Output (Violet/Black) Rear Right (+) Output (Violet) Open
2.Press the track Up/Down to select Sub (Subwoofer)mode.
7 8
Open Ignition (Red)
15 16
Remote-On (Blue/White)
3.Press BAND to select Sub ON.
Power Antenna (Blue)
Wire Harness Part No. -
4. After setting is completed. press F/SETUP to return to normal mode.
Antenna
INPUT
– –
CH-2
+
BRIDGED –
+ +
CH-1
CH-1 (L)
BATTERY
REMOTE
GND
60A
60A
CH-2 (R)
(R)
(L)
SPEAKER OUTPUT
FUSE
POWER SUPPLY
2 Channel Amplifier (Optional) INPUT
– –
CH-2
+
BRIDGED –
+ +
CH-1
CH-1 (L)
CH-2 (R)
BATTERY
REMOTE
GND
60A
60A (R)
SPEAKER OUTPUT
(L)
FUSE
POWER SUPPLY
2 Channel Amplifier (Optional)
NOTE: A 4913 adapter is also required when using an older CD Shuttle equipped with separate RCA’s and DIN Cable connectors
4910-02 Extension (Sold Separately)
B M-Bus CD Shuttle
1
Data Bus
Din Connector 2 4 5
2
Signal Ground
3 4
Data Ground Right Signal
3
5
Left Signal
6
Battery
7 8
Ignition Power Supply Ground
1 8 6
7
¤
A
9
Front Left (+) Output (White) Front Right (-) Output (Gry/Blk)
2 3
16 15 14 13 12 11 10 9
Ground (Black) Front Left (-) Output (White/Blk)
CDM-9803 Radio Rear Connector View
B CD Shuttle DIN Connector
9 10 11 12 13 14 15 16 1 2 3 4 5 6 7 8
A
1. 2. 3. 4. 5. 6. 7. 8.
Ground Front Left Front Left + Front Right Front Right + Open Open Ignition Acc
9. 10. 11. 12. 13. 14. 15. 16.
Battery Rear Left Rear Left + Rear Right Rear Right + Open Remote-On Power Antenna
Revision-B-06242002
