Transcript
Accessory
INSTALLATION INSTRUCTIONS PARTS LIST Attachment Kit (Sold Separately) P/N 08A28-1H1-800
Application
Publications No.
BII 32726 ACURA MUSIC LINK (FOR iPod®)
2007 MDX
Issue Date
OCT 2006
Acura Music Link Kit (Sold Separately) P/N 08A28-1H2-101 Acura Music Link unit
4 Cushion tapes
Holder cushion
Bus cable
Grommet Music Link harness
8 Wire ties CD-ROM (for home computer use only)
2 Long wire ties Quick reference guide
BUS Cable 2 Port (Sold Separately) P/N 08A31-0F1-000 Bus cable 2 port
© 2006 American Honda Motor Co., Inc. - All Rights Reserved. iPod ® is a registered trademark of Apple Computer, Inc.
BII 32726 (0610)
08B28-STX-2000-91
1 of 7
3.
TOOL AND SUPPLIES REQUIRED #2 Phillips screwdriver Flat-tip screwdriver Ratchet
Remove the passenger's side under cover (five clips, and release the two pins and two vehicle connectors).
VEHICLE CONNECTORS (2)
10 mm Socket 10 mm Combination wrenches Tape measure Felt-tip pen Isopropyl alcohol Shop towel CLIPS (5)
Masking tape Illustration of the Acura Music Link Installed on the Vehicle
BUS CABLE
ACURA MUSIC LINK UNIT MUSIC LINK HARNESS PASSENGER'S SIDE UNDER COVER
4.
PINS (2)
5N14011S
Open the glove box. Remove the damper rod cover and release the damper rod. Lower the glove box while pushing in on the left and right sides. DAMPER ROD
AUDIO UNIT
BUS CABLE 2 PORT 5N15111S
COVER
INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.” 1.
2.
2 of 7
Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons.
6411050S
GLOVE BOX
Disconnect the negative cable from the battery.
BII 32726 (0610)
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
5.
Remove the right side dashboard cover (four retaining tabs).
7.
Using a flat-tip screwdriver and a shop towel, remove the driver's side center trim (five clips and three retaining tabs).
RETAINING TABS (2) FLAT-TIP SCREWDRIVER
SHOP TOWEL
CLIPS (5)
DRIVER'S SIDE CENTER TRIM
RETAINING TABS (2)
RIGHT SIDE DASHBOARD COVER
6.
5N14051S
5N14030S
Remove the right dashboard trim (one self-tapping screw, ten clips, and three retaining tabs).
RETAINING TABS (3)
8.
Remove the center panel lower trim (two clips). CLIPS (2)
RIGHT DASHBOARD SELF-TAPPING TRIM SCREW CENTER PANEL LOWER TRIM
5N14061S
CLIPS (10)
5N14040S
RETAINING TABS (3)
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
BII 32726 (0610)
3 of 7
9.
Attach four pieces of masking tape to protect the center console in the area shown.
12. Insert the Acura Music Link unit into the holder cushion.
VEHICLE CONNECTORS (9)
ACURA MUSIC LINK UNIT
BOLTS (4)
HOLDER CUSHION
AUDIO UNIT
6905090B
Align ends. 5N14071S
CENTER CONSOLE
MASKING TAPE
10. Remove the audio unit (four bolts). Pull the audio unit out and unplug the nine vehicle connectors.
13. Plug the bus cable DIN connector (black) and the Music Link harness DIN connector (white) into the Music Link unit. NOTE: To avoid connector damage, orient the connectors properly with the flat side up, and insert them straight in (not crooked). To remove, pull back on the slide collar to release a locking mechanism. Do not pull on the cable, or you can damage it.
11. Get the Music Link harness. Measure and mark the Music Link harness at the location shown using a felt-tip pen.
FELT-TIP PEN
MUSIC LINK HARNESS ACURA MUSIC LINK UNIT
MARK
MUSIC LINK HARNESS DIN CONNECTOR (WHITE) Upside
700 mm
5N15011S
BUS CABLE DIN CONNECTOR (BLACK) Upside
6903010H
4 of 7
BII 32726 (0610)
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
14. Secure the Acura Music Link unit to the steering hanger beam with two long wire ties as shown.
AUDIO UNIT OPENING
WIRE TIE
LONG WIRE TIE
17. Using isopropyl alcohol on a shop towel, clean the area where the cushion tape will attach.
ACURA MUSIC LINK UNIT
MUSIC LINK HARNESS
VEHICLE HARNESS
WIRE TIE
BUS CABLE FRONT
Align the mark made in step 11 with the wire tie.
CUSHION TAPE LONG WIRE TIE
STEERING HANGER BEAM ACURA MUSIC LINK UNIT
VEHICLE BRACKET (Clean with isopropyl alcohol.)
5N15051S
6411010S
15. Route the bus cable to the audio unit opening and secure the bus cable to the vehicle harness with one wire tie.
18. Attach the cushion tape to the edge of the vehicle bracket in the area shown.
16. Connect two wire ties together, and secure the Music Link harness to the steering hanger beam with wire ties.
19. Secure the Music Link harness to the vehicle harness with one wire tie at the mark you made in step 11.
MUSIC LINK HARNESS
STEERING HANGER BEAM
WIRE TIE
5N15061S
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
BII 32726 (0610)
5 of 7
20. Bundle up the excess Music Link harness, and secure it to the vehicle harness with one wire tie. VEHICLE HARNESS
WIRE TIE
22. Make the length of the bus cable 2 port 14-pin connector the same length as the vehicle connectors. Bundle up the excess length of bus cable, and secure it to the vehicle harness with three wire ties. VEHICLE HARNESS WIRE TIE
MUSIC LINK HARNESS (Bundle up.)
BUS CABLE (Bundle up.)
WIRE TIE
6411020S
BUS CABLE 2 PORT 14-PIN CONNECTOR
21. Get the bus harness 2-port connector. Plug the bus cable 14-pin connector and vehicle 14-pin connector into the bus cable 2 port 14-pin connector.
(Align.) VEHICLE CONNECTOR
5N15080S
23. Plug the vehicle connectors and the bus cable 2 port 14-pin connector to the audio unit, and reinstall the audio unit.
BUS CABLE 14-PIN CONNECTOR
VEHICLE CONNECTORS BOLTS (4)
AUDIO UNIT AUDIO UNIT
VEHICLE 14-PIN CONNECTOR
BUS CABLE 2 PORT
BUS CABLE 2 PORT 14-PIN CONNECTOR
5N15070S
VIEW FROM THE BACK SIDE
6 of 7
BII 32726 (0610)
5N15091S
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
24. Reinstall the damper rod and cover. Be careful not pinch the Music Link harness when closing the glove box.
DAMPER ROD
COVER
6411060S
MUSIC LINK HARNESS
GLOVE BOX
25. Check that all wire harnesses are routed properly and all connectors are plugged in. 26. Reinstall all removed parts. Check that all clips and other fasteners are installed securely. 27. Reconnect the negative cable to the battery. 28. Enter the customer's audio and navigation system (if equipped) anti-theft code, and reset the XM radio presets, and the clock. 29. Give the CD-ROM disc to your customer. This disc is software for use on home computers, and it also contains an owner's manual. 30. Turn the radio unit ON. Set mode to Acura Music Link by pressing CD until display CDC or CD4 is shown on the radio display. If CD-C EJECT is on the display, the unit should work properly. 31. Check the operation of the security system according to the security system user's information provided.
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
BII 32726 (0610)
7 of 7
