Preview only show first 10 pages with watermark. For full document please download

1 Htp-3600 Quick Start Guide 3

   EMBED


Share

Transcript

HTP-3600 Quick Start Guide Check that you have all the accessories. 1 STANDBY/ON MUTE SLEEP Speaker cord (x6) STATUS TUNER EDIT FM/AM TAPE/VCR CLASS – TV STATION + SYSTEM SETUP 1 Open the battery compartment on the rear of the remote control. 2 Insert the supplied batteries following the markings inside the battery compartment to align them correctly. 3 Replace the battery compartment cover. 4 Stick the self-adhesive non-skid pads to the underside of each speaker. Use four pads per speaker. Make sure to use a stable surface when doing this, and lay the speakers flat on their side. DIMMER INPUT SELECTOR STB DVD/DVR DIGITAL TUNING FM wire antenna Put the batteries in the remote control and stick the non-skid pads to the base of the speakers. 2 + – VOLUME CH LEVEL + 3 Connect each speaker to the receiver using the supplied speaker wires. Surround left Surround right To connect, insert the colored wire into the matching colored (+) tab and the other wire into the black (–) tab as shown below. Note that the color-coded tabs are as follows: • Red : Front right speaker • White : Front left speaker • Green : Center speaker • Purple : Subwoofer • Grey : Surround right speaker • Blue : Surround left speaker ENTER ROOM SETUP TEST TONE – AUTO STEREO SURROUND Batteries (x2) OFF – AM loop antenna 1 2 BASS + TONE – Non-skid pads (1x12) Receiver MPX TREBLE + RECEIVER You should also have: • Speakers* • Subwoofer • Operating instructions • Warranty card 4 SOUND Remote control * Before placing the speakers, please refer to the speaker manual for detailed assembly instructions. Also check the speaker manual for a complete list of supplied accessories. Surround speakers Connect antennas 5 Connect the FM wire antenna and fully extend along a window frame or another suitable place that gives good reception. 1 To connect the AM loop antenna, twist the exposed wire strands together and insert into the terminal, then snap the connector shut as shown below. 2 AM loop antenna Listening position R FRONT L SPEAKERS SUB WOOFER CENTER SURROUND R L + + – – Subwoofer For the best surround sound, set up your speakers like this. The front left and right speakers should be about 6–9 feet apart. Center speaker 6 Connect the receiver to your DVD player/ recorder. Use a coaxial digital cord (not supplied) to connect the digital output of your DVD player/ recorder to the DIGITAL INPUT (COAXIAL) DVD/DVR jack. 1 Plug the receiver, DVD player/ recorder and TV into a convenient AC outlet. Press  STANDBY/ON to switch on the receiver. Front right 7 Front left Center After switching on, make any necessary settings required by the DVD player/ recorder, then you're ready to start enjoying your home theater system. Refer to the receiver's operating instructions for a detailed explanation of this system's surround sound features. Use a red/white stereo audio cord (not supplied) to connect the AUDIO TV IN jack on the receiver to the audio output on your TV.* This will allow you to listen to your TV through this speaker system.  STANDBY/ON * Note that you must also connect the DVD player/ recorder's video output to your TV's video input to watch a DVD video (video cable is not supplied). VOLUME  STANDBY/ON AUTO SURROUND STEREO INPUT SELECTOR DIGITAL STB DVD/DVR + FM/AM TAPE/VCR TV – Receiver DIGITAL INPUT (COAXIAL) DVD/DVR FM wire antenna Receiver 2 AUDIO TV IN IN + + – – Switch on your DVD player/ recorder and TV, and set the TV to the correct video input. ANTENNA OUT R L VIDEO 1 FM UNBAL 75Ω  AM LOOP Receiver  STANDBY/ON VIDEO SELECT TV L R VIDEO IN AUDIO OUT TV  STANDBY/ON 3/8 in. (10mm) DIGITAL OUT VIDEO OUT DVD player/ recorder DVD player/ recorder For detailed instructions, see the Operating Instructions supplied and / or contact one of our knowledgeable Pioneer Customer Service Representatives at 1 - (800) 421-1404. HTP3600.p65 1 05.1.17, 5:12 PM Setting Up Your HTP-3600 Home Theater System At-a-Glance Refer to the following diagram when making system connections for a full surround sound setup. Note that the TV, DVD player/ recorder and some accessories are not included. Refer to the reverse side of this sheet to check what’s supplied with the HTP-3600. DVD player/ recorder COAXIAL OUT VIDEO OUT Not supplied AUDIO OUT VIDEO IN Front R. Front L. Not supplied Not supplied DIGITAL INPUT (COAXIAL) DVD/DVR – Subwoofer + Center AUDIO TV IN R FRONT L SPEAKERS SUB WOOFER CENTER SURROUND R L + + – – Receiver Surround L. Surround R. For detailed instructions, see the Operating Instructions supplied and / or contact one of our knowledgeable Pioneer Customer Service Representatives at 1 - (800) 421-1404. HTP3600.p65 2 05.1.17, 5:12 PM