Transcript
1. Product Name Laser Sphere Projector
2. Product Code 20378
3. Colour As shown
4. Brief Description Mesmerising moving and colour changing light effects.
5. Contents Your Laser Sphere Projector is supplied in one box containing: 1 x Projector 1 x Power supply (in bottom section of box) 1 x Diffuser Semi-Sphere Cap (on the top of the projector)
6. Snoezelen® Stimulations Visual
7. Best Use Use in a darkened environment and experiment with two different lighting effects – with and without the frosted top.
8. Compatible ROMPA® Products ROMPA offer a range of projection and equipment for visual input. Please see www.rompa.com for the full product range.
9. Starting Up Put the Laser Sphere Projector on a stable surface and use under supervision.
10. Detailed Description Mesmerising moving and colour changing light effects. Remove the frosted top and beautiful effects are projected onto your wall. Tiltable, so the angle of the lighting effect can be adjusted. Includes low voltage adapter.
11. Safety Always supervise the use of this product
This product is for indoor use only. Please store in a cool, dry place. Do not place in direct sunlight. Keep out of the reach of children. Always ensure the light is disconnected from the mains supply when not in use. This product is not a toy. Electrical lamps should not be left unattended and should always be used with adult supervision. Please ensure that the product is kept away from water at all times. Do not try to use any power source other than the AC adapter that is packed with the unit (12V AC, 250 mA) If you are not using the product for an extended period of time, please ensure the AC adapter is unplugged. The unit contains no serviceable parts. Please do not use liquid cleaning products on this light. Soft cloths and feather dusters are suitable. Do not operate this appliance if the cable or plug becomes damaged. A qualified electrician must always carry out any repairs that are necessary. Keep the original box for storage and future reference.
WARNING: This Projector is classified as a laser product. Do not look directly into the beam. To avoid damage to the eyes, please avoid prolonged direct eye contact with the product.
12. Technical Specification Size: Electrical Rating: Transformer:
13L x 10.5W x 14cmH 12V AC 250mA I/P 230V~50Hz O/P 12V AC 250mA
Laser product class II Meets the requirements of EN61558-2-6
13. Installation
Read all these instructions carefully BEFORE use, and familiarise yourself with these as necessary. Connect the adapter to the round one pin socket at the back of the base. Place the Projector upright on a flat, stable surface. For indoor use in dry environments only. The Projector can be used, with or without the Diffuser Semi-Sphere Cap. Without the cap, the visual effect can be projected onto a wall, as shown on the next page. For best results, place the Projector 1 – 3 metres from the surface you’re projecting onto. Tilt the base as required to adjust the angle of the projection. This has a range of 45°. Plug in the adapter. Switch on at the wall. Switch ON using the circular ON/OFF button on the front of the base.
Do not leave the product unattended whilst in use. Always unplug the product from the electrical outlet when not in use.
OPERATION 1. The colours and pattern of the projection change by themselves – the colour and pattern cannot be controlled. 2. Switch off again after use – press the ON/OFF button a second time to switch OFF. 3. Unplug after use.
14. Care and Maintenance
Keep dry Do not immerse in water. Wipe clean with a very slightly damp clean cloth – if using an adapter, make sure this is disconnected before cleaning
15. Troubleshooting Not applicable.
Further copies of these instructions can be downloaded at www.rompa.com We hope you find our instructions invaluable. If you have any suggestions for improving them further your comments will be greatly received – please contact us at
[email protected]
LASER SPHERE PROJECTOR 20378, October 2015 Copyright ROMPA® Ltd
