Preview only show first 10 pages with watermark. For full document please download

10/100mbps Network Interface Card

   EMBED

Share

Transcript

10/100Mbps Network Interface Card 10/100Mbps Network Interface Card The ALLOY-1439XD is a realtek based 10/100Mbps Network Interface card for use in standard PCI servers and workstations. All standard PC Operating Systems supported. It features Nway Auto-Negotiation for speed selection of 10Mbps or 100Mbps, in half-or full-duplex mode. The EtherZIP 100XD fully complies with all IEEE 802.3u, 10/100Base-TX standards. Designed with Realtek single-chip Fast Ethernet LAN controller, the EtherZIP 100XD uses high speed Bus-Mastering DMA to optimize throughput while maintaining low CPU utilization. Additional support for ‘Wake on LAN’ and remote BootROM applications is also provided, while external LED's provide for easy diagnostic's of the cards operation. Extensive Networking Operating System (NOS) drivers are available including, Win XP/2000/NT/98/ME, NetWare, IntraNetware, Linux etc. The ALLOY-1439XD is also available with a Low Profile Bracket. Features: - Dual Voltage PCI operation 3.3V and 5V Complies with PCI 2.1 and 2.2 specification Optiona PXE Boot Rom for WIN2000 RIS Wake UP LAN Support Auto configuration of IRQ and I/O address 1/2 10/100Mbps Network Interface Card Specifications: Standards: Compliant to IEEE 802.3u 100Base-TX Fast Ethernet and IEEE 802.3 10Base-T Ethernet standards Connector: Shielded RJ-45 Jack Cable: Cat.5 or higher UTP or STP (unshielded twisted pair/shielded twisted pair) cable Maximum cable length 100 metres Bus type: PCI (V2.1 or V2.2) Data Transfer Speed: 10Mbps Ethernet or 100Mbps Fast Ethernet Duplex Operation: PCI bus Full or half-duplex (default) LED Indicators: Link/Activity and FDX LEDs mounted on the Adapter bracket Wake on LAN: Supported on compliant motherboards, via: 3 Pin WoL header connector on Adapter, connected through supplied cable to motherboard connector or Direct from PCI slot on later motherboards Boot ROM: Remote Boot ROM Socket on board (ROM chip optional extra) Power Requirement: +3.3V at 2.0A/+5V at 2.0A (auto-detect) Ambient Temperature: 0 to 50 C Humidity: 5% to 90% PCB Dimensions: 121mm(L)×38(H)m 2/2