Transcript
IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, especially when children are present, basic safety instructions should always be followed, including the following: Polythene bags over product or package may be dangerous. To avoid danger of suffocation, keep this wrapper away from babies and children. This bag is not a toy. DANGER: When the unit is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the unit is switched off. WARNING: Do not use this appliance in or near bathtubs, showers, basins or other vessels containing water. •Do not immerse in water or other liquids. • Do not reach for an appliance that has fallen into water. Unplug immediately. • Take care to avoid contact between the hot surfaces of the unit and the skin, paying particular attention to the face, neck and hands. • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or instruction concerning use of the appliance by a person responsible for their safety. • Children should be supervised to ensure they do not play with the appliance. IMPORTANT: Always unplug the appliance when not in use or before cleaning. Do not leave unattended when plugged in or switched on. Do not place on any heat sensitive surface and always allow to cool before storing away. • Do not use any attachments other than those supplied by Conair Australia Pty Ltd. • Use this appliance only for its intended use and as described in this instruction booklet. • This appliance is not intended for commercial use. • Never drop or insert any object into an opening. • Never block the air openings of the appliance or place on a soft surface such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint and other debris. • Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. • Keep the cord away from heated surfaces. • Do not use an extension cord with this appliance. • If the supply cord is damagedit must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • After use do not wrap the cord around the appliance as in time this may cause the cord to fracture. Coil cord loosely by the side of the appliance in storage. • Always ensure that the voltage to be used corresponds to the voltage marked on the unit. • For additional protection, the installation of a residual current device (RCD) with a rated operating current not exceeding 30mA is advisable in the electrical current circuit supplying the bathroom. Ask your installer for advice.
5. At this point the unit will instantly start heating up. This styler has 3 ultra-high heat temperature settings. There is a temperature range that’s gentle and safe for every type of hair, from the finest to the most resistant, and helps you create the look you want.
Goddess Waves Transform yourself with silky, shiny waves. Style faster with better heat & conditioning ionic steam. Enjoy a longer lasting, more defined wave with increased shine.
11
6. Let the unit heat up for at least 2 - 3 minutes before using the steam function. Avoid any contact between the hot surfaces and your face or neck. Make sure you do not direct the steam at your face or neck.
1
2
3
9 8
10
7
13
6
4
7. On first use with the steam, or if the unit has not been used for a while, start up the steam function by closing and opening the unit 7 - 8 times ( a pumping action). Switch the steam function on (5) and select the desired steam output no steam, low or high.
12
5
Features: 1. Up to 230˚C professional salon heat 2. 30 second instant heat 3. Total conditioning system adds moisture and shine 4. Water reservoir for optional gentle conditioning steam 5. Steam function switch: 3 positions - no steam/low/high 6. Ceramic tourmaline coated plates 7. Internal ionic generator 8. T emperature control with 3 variable settings: high/medium/low (from 180˚C to 230˚C) 9. LED on light 10. On/off switch 11. Cool tips 12. Professional swivel power cord 13. Automatic cut-off system How to use your Goddess™ Waves Prepare 1. Remove all packaging and point of sale labels before use. A plastic cover has been placed over the plug to protect it from damage during transportation. Remove the plastic cover from the plug before use. 2. E nsure hair is clean and completely dry before using the appliance. Comb through hair to prevent knots and tangles and then divide hair into equal sections. 3. R emove the water reservoir (4) located at the unit and lift the black rubber button. Fill it with distilled water, preferably filtered water, and replace black button. Then put the reservoir back on the unit. Check that the reservoir is properly positioned and closed. Check that the outside of the reservoir and your hands are dried well. If the reservoir is full, you can use the steam function. If you have to fill the reservoir a second time, unplug the unit and replace the reservoir immediately after filling it, making sure you don’t touch the hot plates. 4. P lug the appliance into a 240v power outlet. Press the on/off button (10) to switch the appliance on. The LED will light up and blinking, then solid after default temperature ready. When putting on the table, the unit should be in correct position, the two barrels should be facing upward.
Style Separate your hair into three parts: upper, middle and lower segments. Clip the upper two segments of hair out of the way. Spray the bottom segment of hair with styling product if desired. 1. Begin with lowest segment of hair. Place sections of hair between the wave plates; press and hold for 5–10 seconds. 2. Repeat styling process moving down, so waves are continuous. 3. Release middle segment of hair and repeat. 4. Release upper segment of hair, starting two inches from roots and repeat. 5. Let hair cool and break up waves with your fingers to create a softer look. 6. Tease roots with a comb for added volume. Styling tips: • For professional results, comb a small amount of mousse or styling gel through the hair before drying and styling. • For a softer, more natural look, run fingers through the hair to break up the waves. • For more styling tips, great ‘how to’ video’s and inpsiring step by step guides visit vssassoon.com.au NB: This appliance has a safety automatic shut-off system, which will automatically turn the appliance off if left switched on for 72 minutes. If this occurs, please wait for appliance to cool. Switch the appliance off and unplug the cord. How to use the variable temperature settings The 3 variable temperature settings provide variable heat for different hair types. These settings allow you to choose the required temperature setting according to your particular need. NB: The heat up time will vary depending on which temperature setting you select. It is suggested to use the lower heat settings when using the appliance for the first time. WARNING: This is a high heat appliance. Care must be taken to avoid the hot surfaces of the appliance coming into direct contact with the skin, in particular the eyes, ears, face and neck. IMPORTANT: Hair that has been heavily bleached or chemically treated should only use the low heat setting on this product. Please consult your hairdresser on using heated appliances if you have any concerns about the condition of your hair. WARNING: The 230˚C maximum high heat setting is not suitable for hair that has been chemically treated, beached or damaged. DO NOT USE THIS PRODUCT ON HEAT DAMAGED OR CHEMICALLY DAMAGED HAIR ON THE HIGHER HEAT SETTING Temperature Setting Guide Variable Temperature Control Settings setting 1 setting 11 setting 111
Hair Type Fine, bleached or delicate hair Normal or coloured hair Hard to style, thick hair
How does the ionic feature work? Many aspects of modern living, including air conditioning, contact with man-made fibres and air pollution add to the build-up of static electricity in the hair. Even brushing and towel-drying the hair can increase these levels. This static charge causes the scales, or cuticles of the hair, to push hair strands apart, resulting in a rough hair surface. Consequently, hair may have a dull appearance. High levels of static charge cause hair to become ‘flyaway’ and difficult to style. The advanced internal ionic generator conditions hair by emitting negative ions to reduce static, by leaving hair silky and shiny with reduced frizz. Buzzing noise This product will make a faint buzzing noise, due to the Ionic steaming function. It will also make a slight rattling noise, due to the feeder in the water reservoir. These noises are completely normal, and part of standard operation of this product. What is Ceramic Tourmaline? Ceramic Technology helps to tame flyaways and frizzies by preventing heat damage and spreading heat evenly and consistently. Hair damage is minimised as heat is distributed evenly from the styling appliance avoiding harmful hot spots. User Maintenance Your styler is designed for household use and is virtually maintenance-free. No lubrication is needed. Keep all vents and openings clear of lint and other debris. If cleaning becomes necessary, disconnect the appliance from the power outlet. Allow the steam waver to cool and wipe exterior with a cloth. If any abnormal condition occurs, allow to cool and return to your place of purchase. Limited Three Year Warranty This product is subject to the express warranty given on the warranty card included with the product, as may be amended by reference to and in accordance with the terms of the warranty cards displayed on VS Sassoon website www.vssassoon.com.au To make a warranty claim you must retain your proof of purchase. Further details can be found at www.vssassoon.com.au and click on ‘customer service’.
Get more from your styling tools, visit
instruction booklet
www.vssassoon.com.au
for news, styling tips and much more. Vidal Sassoon and related logos are trademarks of The Procter & Gamble Company used under licence by Conair ©2013 Conair Australia Pty Ltd Suites 20 and 21, 7 Narabang Way, Belrose NSW 2085 Customer Service Hotline (Australia): 1800 650 263 Customer Service e-mail:
[email protected] Conair New Zealand Ltd., PO Box 251159, Pakuranga, Auckland, 1706, New Zealand Customer Service Hotline (New Zealand): 0800 266 247
Waves Conditioning Ionic Steam VSP98A
