Transcript
®
1200 Autopointing Flyaway by C-COM Satellite Systems Inc.
The 1.2 m Flyaway Autopointing Antenna System with the iNetVu 7000 controller has the following Key Features: - One Button Auto-Pointing Controller - 3 Axis Motorization - Supports Manual Control - Airline Checkable - Captive Hardware/Fasteners - No Tools Required for Assembly/Disassembly - Setup Time Less than 15 Minutes, One Person - Leveling capability for Uneven Surfaces - 2 Pieces Dual Skin Metal Reflector - Supports Ku Band
Feed Arm Twist-Flex Waveguide WR75 Cover Flange Interface RG6U from Feedhorn to Base Connector
Maximum Mount Rotation
40 km/hr 72 km/hr 145 km/hr 360 BTU/h/sq. ft -40º F to 149º F (-40º C to 65º C) -22º F to 131º F (-30º C to 55º C) 1.3 cm/h
Azimuth Elevation Polarization Elevation Deploy Speed
± 80º
Azimuth Deploy Speed
Variable 15º /sec Max. Variable 10º /sec typ 0.2º /sec
Peaking Speed
5º- 80º ± 95º Variable 2º /sec typ
Motors Electrical Interface
1.2 m Offset Feed Elevation over Azimuth 0.635 22.0º Single Offset
Electrical Rx & Tx Cables Control cables Standard Optional
2 RG6 cables (10m each) 10m Ext. Cable upto 75m available
Case1: 2 piece reflector, 28.6 x 71.8 x 128.9 cm; 32 kg Case2: Feed arm with elevation actuator, 49.5 x 22.2 x 123.8 cm; 21 kg Case 3: Tripod , 45.2 x 40 x 118.75 cm; 35 kg Case 4: 6U rack mount with iNetVu 7000 controller + cables; 32 kg
Ku-Band (Linear)
Environmental Wind Load Operational No Ballast or Anchors With Ballast or Anchors Survival (with Ballast/Anchors) Solar radiation Temperature (Survival) Temperature (Operational) Rain
Reflector Mount Geometry F/D Ratio Offset Angle Antenna Optics
Packaging Cases:
RF Interface Radio Mounting Axis Transition Waveguide Coaxial
Mechanical
12 VDC 15A Max.
Transmit Power Transmit (Tx) Frequency Receive (Rx) Frequency Feed Interface Efficiency Midband Gain Antenna Noise Temperature 10º Elevation 30º Elevation Sidelobe better than
Cross-Polarization on Axis Within 1 dB Beamwidth Return Loss Insertion Loss Tx/Rx Isolation Feed - 2 Port XPol
1 to 200 Watt 13.75 - 14.50 GHz 10.70 - 12.75 GHz Receive WR75 70% 41.8 dBi
Transmit WR75 70% 43.5 dBi
58 K 53 K 100λ/D< Ø < 20º 20º < Ø < 26.3º 26.3º < Ø < 48º 48º < Ø 30 dB 22 dB 17.7 dB typ 0.3 dB typ 40 dB
29 - 25 Log Ø dBi -3.5 dBi 32-35 Log Ø dBi -10 dBi 35 dB 26 dB 20 dB typ 0.1 dB typ 80 dB
Standard warranty: 2 years
www.c-comsat.com (613) 745-4110
(877) 463-8886
Specifications are subject to change.
May 2010
SatLink 1910 High-Performance VSAT Indoor Unit
The SatLink 1910 is the leading high-performance DVB-RCS certified VSAT Indoor Unit, with support for DVB-S2 and DVB-S forward links. Hardware optimized for IP networking it offers outstanding throughput and upgrades to new hardware-based features. Advanced QoS, traffic acceleration, VPNs and many other value-added software features make the SatLink 1910 ideal for carrier-class interactive data, voice, and video conferencing, plus multicast IP applications. Users connect via Ethernet. The SatLink 1910 supports various antenna options plus BUCs/LNBs in C, Ku, Ka and EHF bands, including STM’s own Ku Band transceivers. The SatLink 1910 VSAT is a member of a family of SatLink products and systems from STM enabling scalable, high-availability DVB-RCS networks optimized for Internet Protocol (IP) communications, including: VSATs, turnkey hub and gateway systems, hub components, and value-added options for advanced data, voice and video networking via satellite. STM is the technology and market leader in DVB-RCS satellite networks delivering superior performance for telecom service providers, ISPs, governments and enterprises around the world. STM also offers teleport services, installation and integration services, plus total managed network services.
Features & Benefits ● Outstanding IP Performance SatLink 1910 delivers 12 Mbps of IP throughput with advanced IP networking features.
● Bandwidth Efficiency at Many Levels Advanced DVB-S2 modulation and FEC, header compression, section packing & intelligent bandwidth-ondemand algorithms enable efficient broadband applications; the unit consumes only 64 bps when idle, 0 bps in “auto-sleep” mode.
● Comprehensive IP Networking Features SatLink delivers TCP and HTTP acceleration, NAT, VPN, VLAN options, and MPLS extensions, plus a built-in DHCP server and both unicast and multicast IP routing.
● Advanced QoS for Data, Voice, Video QoS Groups for bandwidth-on-demand enable delay sensitive traffic for interactive media concurrently with bulk data, without dedicating bandwidth per VSAT.
● Low-Power, 1U Rack-Mount Design The SatLink 1910’s compact size with low power consumption makes it viable for all types of locations, including remote, solar-powered sites.
● Accessory Card Slot for Upgrade Options Rear plug-in card slot allows advanced new features, such as mesh networking, providing a future-proof VSAT investment.
● ACM and Rain Fade Mitigation Adaptive Coding and Modulation (ACM) on forward links and adaptive FEC and symbol rate on return links increase bandwidth efficiency and improves link margins to mitigate rain fades.
● Traffic Engineering for Large Networks Carriers, ISPs and others gain control over bandwidth resources using SatLink VSAT Groups for traffic engineering. Networks with 10,000’s of VSATs are supported.
● Mobile and Transportable Options The SatLink 1910 and SatLink Hub Systems support options for marine and land mobile VSAT requirements.
● BUCs up to 5 Watts with Power Control Internal power for BUCs up to 5 Watts; automatic power control from the hub simplifies installation and optimizes operation and bandwidth use.
SatLink 1910 High-Performance VSAT Indoor Unit
Specifications Capacity Throughput: Up to 12 Mbps of IP packets at 1500 bytes (varies with IP software features enabled)
IP QoS and Bandwidth-on-Demand Traffic Classification: May use combination of 802.1p, DSCP, Protocol Type, IP Source Address, IP Destination Address, TCP/UDP Source Port or Destination Port QoS Treatment: Four Service Classes (VoIP, ViC, CD, BE) split into seven QoS sub-classes with separate priority queues, congestion avoidance, and discard sub-class Capacity Requests: RBDC, VBDC, AVBDC in combination for bandwidth-on-demand, plus CRA & FCA
IP Packet Encapsulation & Compression Format: (Tx & Rx) DVB-RCS standard MPEG2 MPE with section packing, without regard to packet boundaries per EN 301 192 & ISO 13818-1 Header Compression: Removes up to 23 bytes (on Tx), 21 bytes on (Rx), on each encapsulated IP packet
IP Routing and IP Stack Support Routing: Unicast and Multicast IP Protocols: IP, UDP, TCP, ARP, ICMP, IGMP, DHCP Server, DNS Cache, Telnet, SNMPV2c Advanced Options: TCP Acceleration; HTTP Acceleration; NAT; GRE Tunnels; VLANs
Management Interfaces Local: RS-232 CLI Remote: Telnet, SNMP v2c, Web GUI Software Upgrade: Local, TFTP or multicast via satellite
Compliance CE: Fully compliant with R&TTE Directive DVB-RCS: ETSI EN 301 790; SatLabs DVB-S / S2: ETSI EN 300 421 / EN 302 307 International: Country specific certifications
TDM Receive (DVB-S2) Modulation: 1 to 45 Msps with choice of MODCODs: ♦QPSK: 1/4, 1/3, 2/5, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 ♦8PSK: 3/5, 2/3, 3/4, 5/6, 8/9, 9/10 ♦16APSK: 2/3, 3/4, 5/6, 8/9, 9/10 FEC Frames: Normal (64 Kbit) and Short (16 Kbit) Roll-off Factor: 20%, 25%, or 35% Modes: CCM, VCM, ACM (DVB-S mode also supported for legacy networks)
TDMA Transmit (DVB-RCS) Modulation: QPSK Symbol Rates: 125 Ksps to 3 Msps FEC Rates: 1/2, 2/3, 3/4, 4/5, 6/7 (Turbo Codes) Frequency Hopping: Fast (within 500 MHz band)
Physical Interfaces Serial Port: RS-232, DB-9 (local management) Ethernet: 10/100Tx Mbps, RJ-45 (user IP traffic) Tx (BUC) Interface: F-type 75 Ohm; 24 VDC at up to 3 A, plus 10 MHz reference under software control. ♦Tx Output: 950 to 1450 MHz ; - 35 dBm to 0 dBm ♦BUC control: Extended DiSEqCTM Rx (LNB) Interface: F-type 75 Ohm; LNB Power 13 or 18 VDC, 300 mA maximum ♦Rx Input: 950-2150 MHz; -65dBm to –20 dBm ♦LNB Control: 22 KHz or 13/18 VDC signaling Expansion Slot: For SatLink plug-in card options Front LEDs: Power, Error, Tx, Rx, Ethernet Link/Activity
Electrical, Environmental & Physical Power Supply: 110-240VAC, 50-60 Hz, internal Power Consumption: 10 W (IDU only); 31 W @ P1dB with SatLink 4033 2W transceiver Operating Temperature: 0 to 45 °C Storage Temperature: -20 to 85 °C Humidity: 20% to 90% non-condensing Size: 44 x 24.5 x 4.5 cm Weight: 4 kg
www.stmi.com STM Group, Inc. | 2 Faraday | Irvine, CA 92618, USA | T +1 949 273 6800 | FAX +1 949 273 6020 STM Norway AS | Vollsveien 21 | 1366 Lysaker, Norway | T +47 6753 5337 | FAX +47 6753 5335 All specifications and features subject to change without notice. SatLink and the STM logo are a registered trademarks of STM Group, Inc. The DVB logo is a registered trademark of the DVB Project (www.DVB.org). SatLabs logo is a registered trademark of SatLabs (www.satlabs.org). DiSEqC is a trademark of Eutelsat. Document # 105037; Revision N - 100730
