Transcript
OPEP-33-A4G1RH
1.25Gbps Upstream/1.25Gbps Downstream GE-PON ONU Transceiver FEATURES z RoHS compliant z IEEE802.3ah Gigabit Ethernet compliant z 2x5 pin SFF package with SC Receptacle z 1310nm Burst Mode 1.25Gbps transmitter, and 1490nm Continuous Mode 1.25Gbps receiver z Integrated with WDM filter to cut 1550nm and 1650nm optical signal off z Single +3.3V power supply z LVPECL electrical signal interface z LVTTL Bias Control input and Rx Signal Detect output z Laser Class 1 Product which comply with the requirements of IEC 60825-1 and IEC 60825-2
Description
Application
DELTA’s GE-PON ONU transceiver OPEP-33-A4G1RH is designed for Gigabit Ethernet Passive Optical Network transmission.
z IEEE 802.3ah 1000BASE-PX10/20-U z GE-PON ONU z Burst Mode Application
The module is contained in a 2x5 SFF
z FTTx WDM Broadband Access
package with standard SC receptacle connector. The module consists 1310nm FP laser, InGaAs PIN, Preamplifier and WDM filter in a high-integrated optical sub-assembly, and it receives up to 1.25Gbps of continuous data at 1490nm, and transmits 1.25Gbps of burst-mode data at 1310nm.
z OPEP-33-A4G1RH data link up to 20km in 9/125um single mode fiber.
1 DELTA ELECTRONICS, INC.
Revision: S1 01/16/2009
www.deltaww.com
OPEP-33-A4G1RH 1. Absolute Maximum Ratings Parameter Storage Temperature Storage Ambient Humidity Power Supply Voltage Signal Input Voltage Receiver Damage Threshold Lead Soldering Temperature/Time Lead Soldering Temperature/Time
Symbol Ts HA VCC
Min. -40 5 -0.3 -0.3 +7
Typ.
TSOLD TSOLD
Max. 85 95 4 Vcc+0.3 260/10 380/10
Unit ºC % V V dBm ºC/sec ºC/sec
Note
Note (1) Note (2)
Note (1). Suitable for wave soldering Note (2). Only for soldering by iron
2. Recommended Operating Conditions Parameter Operating Case Temperature Ambient Humidity Power Supply Voltage Power Supply Current Power Supply Noise Rejection
Symbol TC HA VCC ICC
Min. 0 5 3.13 1.25
Data Rate
-100ppm
Typ. 3.3
1.25
Transmission Distance
Max. 70 85 3.47 300 100 1.25 +100ppm
Unit ºC % V mA mVp-p
Note Note (1) Non-condensing
100Hz to 1MHz
Gbps
20
km
Max. +4 +4 +7
Unit dBm dBm dBm dB nm nm dBm
Note (1). Measured on topside of case front center
3. Specification of Transmitter Parameter Average Launched Power (B.O.L) Average Launched Power (E.O.L) Launched power (Peak.) Extinction Ratio Center Wavelength Spectrum Width (RMS) Transmitter OFF Output Power Laser Burst On Time Laser Burst Off Time Optical Rise/Fall Time Total Jitter Optical Return Loss Tolerance Relative Intensity Noise Optical Transmitter Reflectance Output Eye Mask {X1,X2,Y1,Y2,Y3}
Symbol PO PO PP ER λC σ POff Ton Toff tr/tf tJ ORLT RIN15OMA
Min. 0 -1 9 1276
Typ.
1356 2.8 -45 32 32 260 128 15 -115 -10 Compliant with IEEE 802.3ah {0.22,0.375,0.20,0.20,0.30}
ps ps dB dB/Hz dB
Note Note (1)
FP Laser
Note (2) Note (3)
Note (4)
Note (1). Launched power (avg.) is power coupled into a single mode fiber with master connector. B.O.L=Before of Life; E.O.L= End of Life Note (2). These are unfiltered 20-80% values. 2 DELTA ELECTRONICS, INC.
Revision: S1 01/16/2009
www.deltaww.com
OPEP-33-A4G1RH Note (3). Measure at 27-1 NRZ PRBS pattern Note (4). Maximum sensitivity penalty due to transmitter and dispersion effect through 10km single mode optical fiber. Note (4). Transmitter eye mask definition 1+ Y 3
Normalized Amplitude
1 1- Y1 0.5 Y1 0 - Y2
0
X1
X2
1- X2 1- X1
1
Normalized Time
4. Specification of Receiver Parameter Input Optical Wavelength Receiver Sensitivity (B.O.L) Receiver Sensitivity (E.O.L) Input Saturation Power (Overload) Signal Detect -Assert Power Signal Detect -Deassert Power Signal Detect Hysteresis Data Output Rise/Fall time Receiver 1480 to 1500nm Reflectance Optical Isolation 1260 to 1360nm from External 1550 to 1560nm Source 1640 to 1665nm
Symbol λIN PIN PIN PSAT PA PD PA-PD tr/tf
Min. 1480
-3 -39 0.5
Typ. 1490
Max. 1500 -26.5 -24
6 260
Unit nm dBm dBm dBm dBm dBm dB ps
-12
dB
-43 -33 -33
dB dB dB
-27 2
Note PIN-PD Note (1)
Note (2) Note (3) Note (4)
Note (1). Measured with Light source +1dBm, 1490nm, ER=9dB; BER =<10-12@PRBS=27-1 NRZ This assurance should be met with asynchronous data flowing out of the optical transmitter of the system under test. The output data pattern from the transmitter of the system under test is a repetition of alternate 0/1 pattern as defined for this measurement. Note (2). When SD deasserted, the data output is Low-level (fixed) Note (3). These are 20%~80% values. Note (4). Measured at wavelength of 1490nm.
3 DELTA ELECTRONICS, INC.
Revision: S1 01/16/2009
www.deltaww.com
OPEP-33-A4G1RH 5. Electrical Interface Characteristics Parameter Transmitter Total Supply Current Differential line input Impedance Differential Data Input Swing Data Input Voltage- High Data Input Voltage- Low BiasCNT(n) Input Voltage- High BiasCNT(n) Input Voltage- Low Receiver Total Supply Current Differential Data Output Swing Signal Detect Output Voltage-High Signal Detect Output Voltage-Low
Symbol
Min.
Typ.
ICC RIN VDT VIH-VCC VIL-VCC VBCH VBCL
80 200 -1.165 -1.810 2 0
100
ICC VDR VLOSH VLOSL
400 2 0
800
Max.
Unit
Note
A 120 1600 -0.880 -1.475 Vcc 0.8
mA Ohm mVp-p V V V V
Note (1)
B 1200 Vcc+0.3 0.8
mA mVp-p V V
LVPECL LVTTL Note (1) Note (2) LVTTL
Note (1). A (TX)+ B (RX) = 300mA (Not include termination circuit) Note (2). Internally AC coupled, but requires a 100Ohm differential termination at or internal to Serializer/ Deserializer.
6. Transmitter Burst Mode Timing Characteristics Parameter BiasCNT(n) Enable Duration Interval of BiasCNT(n) Signal
Symbol
Min. 1 0.112
Typ.
Max. 1000000
Unit us us
Note
BiasCNT(n) Enable Duration
BiasCNT(n)
VccT VccT < 3.1V VccT > 3.1V
Interval of BiasCNT(n) Signal
BiasCNT(n) X High Low
Data Input X X No Yes
Optical Output OFF OFF Other Laser bias and modulation signal output
X = Don’t care Other = Less than +7 dBm (peak) High = Logic high level, Low = logic low level No = No Data Input, Yes = Data Input, OFF = Optical Power is less than –45dBm 4 DELTA ELECTRONICS, INC.
Revision: S1 01/16/2009
www.deltaww.com
OPEP-33-A4G1RH H BiasCNT(n) L Data Input
Optical Output
Within 15% of steady state
Ton
Toff
7. Pin Description Tx/Rx
Pin No. 1 2
I/O
Rx
3
O
4 5 6 7 8 9 10
O O
Tx
I I I
Pin Name VeeR VccR SD
Description Receiver Ground +3.3V Receiver Power Supply Normal Optical Input indicated by logic “High”, and No Optical Input indicated by logic “Low”. (LVTTL) RD(n) Inverted Receiver Data Output (AC-Coupled CML output) RD(p) Non-Inverted Receiver Data Output (AC-Coupled CML output) VccT +3.3V Transmitter Power Supply VeeT Transmitter Ground BiasCNT(n) Negative pulse which control the ONU burst mode operation TD(p) Non-Inverted Transmitter Data Input TD(n) Inverted Transmitter Data Input MS Mounting studs/ connect this pin to Chassis ground HL EMI Shielding Leads/ connect this pin to Chassis/ Signal ground
5 DELTA ELECTRONICS, INC.
Revision: S1 01/16/2009
www.deltaww.com
OPEP-33-A4G1RH 8. Recommended Interface Circuit DELTA GEPON ONU Module 1uH
6. VccT
3.3V 10uF
100nF
100nF 1uH 8. BiasCNT(n)
BiasCNT(n)
Transmitter
9. TD(p)
Coupled interface
10. TD(n) 7. VeeT
Protocol IC
2. VccR
SerDes IC 10uF
100nF
5. RD(p)
Z0=50ohm
100nF
100ohm 4. RD(n)
Z0=50ohm
100nF VccR RES
3. SD
SD
Receiver
1. VeeR * RES is the internal 4.7K to 10K Ohms pull-up resistor.
DC - Coupled interface
Coupled interface
AC - Coupled interface
3.3V 130ohm
Z0=50ohm Host Board
82ohm
100nF 100ohm
DELTA ONU
Z0=50ohm Host Board
Z0=50ohm
150ohm
DELTA ONU
Z0=50ohm 130ohm
150ohm
100nF
82ohm
3.3V
6 DELTA ELECTRONICS, INC.
Revision: S1 01/16/2009
www.deltaww.com
OPEP-33-A4G1RH 9. Outline Dimensions Parameter Mechanical Dimensions Connector Type
Unit mm -
Description 48.3x13.5x9.6 SC/UPC connector
Note IEC-61754-4
. J r e t p a h c b u S R F n oC i t 1 a 2 i
t d, ca s u d dr r Aa o d r Dn P Fa t rh s e t s e a ic w n Ls a em 1l i r s po sm f a r l oe C Cp
W eek (52W eeks/Y ear) : 1月 2日 =01
7 DELTA ELECTRONICS, INC.
Revision: S1 01/16/2009
www.deltaww.com
OPEP-33-A4G1RH 10. Regulatory Compliance Feature
Test Method
Electrostatic Discharge (ESD) to the Electrical Pins
Human Body Model MIL-STD-883E Method 3015.7 (HBM) EIA-JESD22-A114
Electrostatic Discharge (ESD) to the Simplex Receptacle
Contact Discharge
Machine Model (MM) EIA-JESD22-A115
Air Discharge
Radio Frequency Electromagnetic Field Immunity
IEC/EN 61000-4-2 IEC/EN 61000-4-2 IEC/EN 61000-4-3
Performance
(1) Satisfied with electrical characteristics of product spec. (2) No physical damage
FCC Part 15 Class B EN 55022 Class B (CISPR 22A)
Electromagnetic Interference (EMI)
Laser Eye Safety
Reference
FDA/CDRH
FDA 21CFR 1040.10, 1040.11
CDRH File # 0420993
TUV
IEC/EN 60825-1 IEC/EN 60825-2
TUV Certificate R50032471
TUV
IEC/EN 60950
UL/CSA
UL 60950
#
Component Recognition UL File # E239394
Appendix A. Document Revision Version No. S0
Date 2008-04-22
S1
2009-01-16
Description Preliminary datasheet Add the specification of Receiver Sensitivity (E.O.L) and update the PD to -39dBm.
8 DELTA ELECTRONICS, INC.
Revision: S1 01/16/2009
www.deltaww.com
