Transcript
Part # 1085-135 Omni Antenna, 4 Section Collinear, 1.35 - 1.39 GHz, 6 dBi, Internal Bandpass Filter
Overview Southwest Antennas Part # 1085-135 is a 4 section collinear omni antenna with a frequency range of 1.35 to 1.39 GHz and 6 dBi of peak gain. This product features an integrated RF bandpass filter to help eliminate interference from other co-located radios operating outside of the antenna's 1.35 - 1.39 GHz operational frequency range, providing increased performance for attached radios. A matte black radome and black-chrome RP-TNC(m) RF connector offer a low visibility finish that will not attract attention when deployed. The waterproof sealed spring base allows the antenna to bend or flex with impact and return to its vertical operating position, reducing risk of damage to the antenna or mated radio RF connector.
Features: Broad Band Coverage 4 Section Collinear 1.35 - 1.39 GHz 50W Power Handling 6 dBi Omni Radiation Pattern Rugged Construction Low Glare Black Radome End Cap Lettering "L" Heavy Duty Sealed Spring Base Black Chrome RP-TNC(m) RF Connector
Doc: 217-0001-637 Created: 10/03/2016
8145 Ronson Rd. Ste B • San Diego, CA 92111 PH: (858) 277-3300 • Fax: (858) 571-6911 • Email:
[email protected] southwestantennas.com
Page 1
Part # 1085-135 Omni Antenna, 4 Section Collinear, 1.35 - 1.39 GHz, 6 dBi, Internal Bandpass Filter
Antenna Specifications Parameter
Value
Antenna Pattern
Omni
Frequency Band
L
Impedance
50
Ohms
Minimum Frequency
1.35 / 1,350
GHz / MHz
Maximum Frequency
1.39 / 1,390
GHz / MHz
Frequency Bandwidth
0.04 / 40
GHz / MHz
Maximum VSWR
2:1
Ratio
Gain
6
dBi
Polarization
Vertical
Maximum RF Input Power
50
Watts
Horizontal (AZ) Beamwidth
360
Degrees
Vertical (EL) Beamwidth
25
Degrees
Color
Black
Spring or Gooseneck
Spring
Spring Length
0.750 / 19.050
inches / mm
Spring Diameter
0.750 / 19.050
inches / mm
Maximum Wind Velocity
100 / 161
mph / kph
RF Connector Type
RP-TNC(m)
RF Connector Finish
Black Chrome
Product Height
21.750 / 552.450
inches / mm
±0.13"
Product Diameter
0.812 / 20.625
inches / mm
+0.02" / -.000"
Doc: 217-0001-637 Created: 10/03/2016
Units
Tolerance
8145 Ronson Rd. Ste B • San Diego, CA 92111 PH: (858) 277-3300 • Fax: (858) 571-6911 • Email:
[email protected] southwestantennas.com
Page 2
Part # 1085-135 Omni Antenna, 4 Section Collinear, 1.35 - 1.39 GHz, 6 dBi, Internal Bandpass Filter
Parameter
Value
Units
Tolerance
Product Weight
5.06 / 143.45
oz / grams
Parameter
Value
Units
Filter Type
3mm, 3-Pole Bandpass Filter
Filter Frequency Band
L Band
Filter Impedance
50
Ohms
Filter Min Frequency
1.35 / 1,350
GHz / MHz
Filter Max Frequency
1.39 / 1,390
GHz / MHz
Insertion Loss
<0.80
dBa
Return Loss
15
dB
Over 100% of BW
Rejection 1
-50
dBc
Min @ 960 MHz
Rejection 2
-40
dBc
Min @ 1,850 MHz
Filter Power CW
8
Watts
Filter Power Peak
10
Watts
Operating Temp
-40 to +85
C
Filter Specifications
Doc: 217-0001-637 Created: 10/03/2016
Tolerance
8145 Ronson Rd. Ste B • San Diego, CA 92111 PH: (858) 277-3300 • Fax: (858) 571-6911 • Email:
[email protected] southwestantennas.com
Page 3
Part # 1085-135 Omni Antenna, 4 Section Collinear, 1.35 - 1.39 GHz, 6 dBi, Internal Bandpass Filter
Elevation Pattern Referenced to +10 dBi
Doc: 217-0001-637 Created: 10/03/2016
8145 Ronson Rd. Ste B • San Diego, CA 92111 PH: (858) 277-3300 • Fax: (858) 571-6911 • Email:
[email protected] southwestantennas.com
Page 4
Part # 1085-135 Omni Antenna, 4 Section Collinear, 1.35 - 1.39 GHz, 6 dBi, Internal Bandpass Filter
Band Pass Filter Response Blue = S11
Doc: 217-0001-637 Created: 10/03/2016
8145 Ronson Rd. Ste B • San Diego, CA 92111 PH: (858) 277-3300 • Fax: (858) 571-6911 • Email:
[email protected] southwestantennas.com
Page 5
Part # 1085-135 Omni Antenna, 4 Section Collinear, 1.35 - 1.39 GHz, 6 dBi, Internal Bandpass Filter
Engineering Drawing Dimensions are in inches
Doc: 217-0001-637 Created: 10/03/2016
8145 Ronson Rd. Ste B • San Diego, CA 92111 PH: (858) 277-3300 • Fax: (858) 571-6911 • Email:
[email protected] southwestantennas.com
Page 6
