16` Awg Booster Cable - Harbor Freight Tools

Transcript

16’ AWG BOOSTER CABLE 1000A CAPACITY ITEM 66834 OPERATING INSTRUCTIONS Distributed exclusively by Harbor Freight Tools®. 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our Web site at: http://www.harborfreight.com © Copyright 2009 by Harbor Freight Tools®. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions, please call 1-800-444-3353. SAVE THESE INSTRUCTIONS WARNING To prevent serious injury and property damage: 1. Do not exceed max. 1000 Amp capacity. 2. Do not allow red and black Cable clamps to touch each other or same metal object. 3. Wear ANSI-approved safety goggles and heavy-duty work gloves during use. 4. Read and understand all instructions and safety precautions as outlined in vehicle’s service manual before use. 5. WARNING! Lead acid batteries generate hydrogen gas during normal operation, and even more gas is generated when battery is charging. Hydrogen gas is explosive. 6. WARNING! If battery fluid comes in contact with skin, wash with soap and water and rinse with lemon juice and vinegar. If fluid comes into contact with eyes, flush with water for several minutes and contact a physician immediately. 7. Do not burn a battery as it can explode in a fire. Do not attempt to charge a leaking battery. 8. Do not smoke in vicinity of lead battery. 9. People with pacemakers should consult their physician(s) before use. Electromagnetic fields in close proximity to heart pacemaker could cause pacemaker interference or pacemaker failure. Caution is necessary when near coil, spark plug cables, or distributor of running engine. Engine should be off during distributor adjustment. 10.Inspect before every use; do not use if parts are loose or damaged. 11. Use as intended only. 12. Keep away from children. OPERATING INSTRUCTIONS BLACK/NEGATIVE (–) Battery Clamp to an unpainted, solid piece of metal on the 1. Make sure the transmissions of both vevehicle with the “dead” battery. hicles are in “PARK” (for automatic transmissions) or “NEUTRAL” (for manual) and 4. Start the “donor” vehicle’s engine and their emergency brakes have been set. allow to idle. Turn both car engines off prior to connect- 5. Turn the ignition switch of the vehicle ing the Booster Cable to the batteries of with the “dead” battery to “START” for no both vehicles. more than 5 to 6 seconds. NOTE: If the 2. Attach the RED/POSITIVE (+) Battery vehicle’s engine does not start, turn the Clamps to the POSITIVE battery termiignition switch to “OFF” and wait at least nals of both vehicles. 3 minutes before repeating this Step. When finished, turn off both vehicles and 3. Attach one BLACK/NEGATIVE (–) Battery remove the Booster Cable (NEGATIVE Clamp to the NEGATIVE battery terminal terminal first.) of the “donor” vehicle. Attach the other To jump start a vehicle: NOTE: NO REPLACEMENT PARTS ARE AVAILABLE FOR THIS PRODUCT.