Transcript
RADIO EQ STACK
TUNERS / CASSETTE / DISC PLAYERS MINI
STAN
DIN
SINGLE DBL DIN
ISO DIN
CHASSIS H
13/ 4-2
2
2
2
37/ 8
3
CHASSIS W
71 / 8
71/ 8
71/ 8
7
71/ 8
71/8
CHASSIS D
43/ 4-51/2
57/ 8-611/ 16
57/ 8-611/ 16
57/ 8-611/ 16
57/ 8-611/ 16
57/ 8-611/ 16
NOSE H
15/ 8-13/4
15/ 8-13/4
23/ 8
113/ 16
33/ 4-4
NOSE W
41/ 8-43/ 16
41/ 8-43/ 16
71/ 2
611/ 16
611/ 16-71/4
SHAFT SP.
51/ 8-53/4
51/ 8-6
UPDATED THROUGH '96 '97 '98 '99
TOYOTA 1995-UP TERCEL 2 Door/4 Door
IN DASH APPLICATION NOTES KS
KS
KS
K4
K4
KS
APPLICATION KIT MODEL: TA02
HARNESS ADAPTOR:
ANTENNA ADAPTOR:
NONE
IN-DASH INSTALLATION AREA DIMENSIONS MAX DEPTH
DEPTH 3
7 /4"
CAVITY DASH OPENING
TYPE:
DASH MATERIAL:
WIDTH
3
7 /4"
DOUBLE DIN ISO
PLASTIC
HEIGHT
3
7 /4"
43/8"
7"
313/16"
THICKNESS:
3
/32 ”
REMOVE REAR SUPPORT
FOR MAX DEPTH
MODIFY CAVITY
AMPLIFIER/EQ MOUNTING LOCATIONS (WxHxD) UNDER/IN DASH
UNDER SEAT
GLOVE BOX
TRUNK/ CARGO Various
NOTE: THIS MANUAL IS BASED ON CAREFULLY DOCUMENTED RESEARCH. ABSOLUTE ACCURACY IS ATTEMPTED BUT NOT GUARANTEED. USE THIS MANUAL AS A REFERENCE GUIDE. SCOSCHE, INC. CANNOT BE RESPONSIBLE FOR INCONSISTENCIES THAT MAY OCCUR.
Dimensions shown are inches. For inch/mm conversions refer to chart section.
Vehicle illustration courtesy of NADA Used Car Guide.
*Aftermarket requires drilling new mounting holes.
B C1 C2 D D1 D2 D3 F1 F2 K K1 K2 K3 K4
= = = = = = = = = = = = = =
K 5 = WHEN EQUIPPED WITH STANDARD TWO SHAFT RADIO/TAPE PLAYER. FABRICATE KIT WHEN EQUIPPED WITH FLAT FACE ELECTRONIC RADIO/TAPE PLAYER. K S = SCOSCHE KIT RECOMMENDED. N = NOT RECOMMENDED. EXTENSIVE MODIFICATION REQUIRED. P = PERFECT WITHOUT MODIFICATION. P 1 = MODIFY OR REMOVE POCKETS. P 2 = COIN POCKET LOCATION IN DASH (MAY REQUIRE TRIM KIT). P 3 = PERFECT WHEN EQUIPPED WITH STANDARD TWO SHAFT RADIO, K WITHOUT. R = REAR LOAD ISOMOUNT. U = UNDERDASH. W 1 = WITH POWER WINDOWS ONLY. W 2 = WITHOUT POWER WINDOWS ONLY.
BACK UP PLATES REQUIRED. CUT TRIM/PLASTIC (STRUCTURE). CUT STEEL. BELOW DECK ONLY. LIFT PORTION OF DECK. (MAY REQUIRE STRUCTURAL REINFORCEMENT). CUT STEEL WHEN TOP MOUNTED. DO NOT IF BELOW DECK. NARROW SURFACE, BELOW DECK ONLY. MINIMUM MODIFICATION FILE SHAFT HOLES OR DASH OPENING. MODIFY DASH CAVITY AND/OR PANEL. INSTALLATION KIT, SPACER OR ADAPTOR REQUIRED. KIT MODIFICATIONS REQUIRED. EXTENSION KIT RECOMMENDED. WHEN EQUIPPED WITH FACTORY "ELECTRONIC" RADIO. FABRICATE PANEL/BRACKETS.
211
©
1995-UP TOYOTA TERCEL 2 DOOR/4 DOOR
DASH.
FRONT DOOR PANEL.
PRELIMINARY: DISCONNECT THE NEGATIVE BATTERY CABLE ANTENNA: THE FACTORY ANTENNA IS LOCATED IN THE LEFT FRONT WINDSHIELD PILLAR.
RADIO REMOVAL AND IN-DASH INSTALLATION: NOTE: THE FACTORY RADIO PROVISION IS FOR A DOUBLE DIN ISO RADIO THAT FITS BEHIND THE DASH BEZEL. AN INSTALLATION KIT IS NECESSARY FOR ALL AFTERMARKET INSTALLATIONS. 1. CAREFULLY PRY OUT ON THE BOTTOM SIDE OF THE RADIO TRIM BEZEL TO RELEASE CLIPS. 2. LIFT UP OUT SO THE HOOKS ON THE TOP EDGE OF THE BEZEL WILL RELEASE. 3. EXTRACT THE (4) SCREWS SECURING THE RADIO TO THE DASH, UNPLUG CONNECTORS AND ANTENNA AND REMOVE RADIO.
FRONT DOOR SPEAKER INSTALLATION: NOTE: THE FACTORY SPEAKER PROVISION IS FOR A 4" SPEAKER 3-HOLE TRIANGULAR MOUNTING PATTERN SPEAKER. DIRECT SPEAKER ACCESS: 1. POP OUT SMALL CUT OUT AT BOTTOM OF FACTORY GRILLE, WHICH IS A HOOK, THEN SPEAKER GRILLE WILL SLIDE DOWNWARD AND REMOVE. 2. EXTRACT (4) SCREWS ALONG THE BOTTOM EDGE OF THE DOOR PANEL. 3. EXTRACT (3) 10 MM BOLTS HOLDING SPEAKER IN, UNPLUG AND REMOVE SPEAKER. DOOR PANEL REMOVAL: 1. REMOVE (1) SCREW FROM BACK OF DOOR RELEASE HANDLE TRIM CUP. 2. POP OFF PLASTIC INSIDE MIRROR COVER TRIANGLE. 3. POP UP ARMREST PAD WITH A PANEL REMOVAL TOOL AND REMOVE THE (2) SCREWS FROM THIS LOCATION. 4. REMOVE WINDOW CRANK WITH CRANK PULLER TOOL. 5. CAREFULLY PRY OUT ON THE EDGES OF THE DOOR PANEL TO RELEASE THE PANEL CLIPS, LIFT UP AND AWAY TO REMOVE THE PANEL.
REAR DECK SPEAKER PROVISION.
REAR DECK SPEAKER INSTALLATION: NOTE: THE FACTORY SPEAKER PROVISION IS FOR A 6 1/2" 2-HOLE FOOTBALL STYLE SPEAKER. 1. POP OUT SIDE SEAT BELT MECHANISM COVERS. 2. POP 3RD BRAKE LIGHT HOUSING TO RELEASE, UNPLUG LIGHT AND REMOVE. 3. USING A PANEL REMOVAL TOOL POP REAR DECK UPWARD TO RELEASE FASTENERS, REMOVE REAR DECK. 4. EXTRACT (2) SCREWS HOLDING SPEAKER, UNPLUG AND REMOVE
FRONT DOOR SPEAKER.
212
©
