Transcript
200 PONTIAC GRAND PRIX
Year: 2000
Make: Pontiac
Model: Grand Prix
IN-DASH APPLICATION: Dash Type: GM Oversize
Kit: GM1517
Harness: GM02
Antenna Adapter: MDA-1
CD Changer Interface: None
FRONT SPEAKERS: Door: Tweeter Door: 5 ¼’ 4-hole speaker mounted in factory speaker adapter WHEN INSTALLING AN AFTERMARKET 5 ¼” SPEAKER, AN ADAPTER IS NOT REQUIRED.
REAR SPEAKERS: Rear Deck Speakers: 6 x 9 in factory speaker adapter WIRE COLOR CODES: +12V Constant +12V Accessory Switched -12V Chassis Ground Illumination/Dimmer LF+ LFRF+ RFLR+ LRRR+ RR-
= = = = = = = = = = = =
Orange Yellow Black Gray Tan Gray Light Green Dark Green Brown Yellow Dark Blue Light Blue
NOTE: THIS MANUAL IS BASED ON CAREFULLY DOCUMENTED RESEARCH. ABSOLUTE ACCURACY IS ATTEMPTED BUT NOT GUARANTEED. USE THIS MANUAL AS A REFERENCE GUIDE. SCOSCHE, INC. CANNOT BE RESPONSIBLE FOR INCONSISTENCIES THAT MAY OCCUR..
© 2000 SCOSCHE INDUSTRIES, INC. 155
ALL RIGHTS RESERVED FOR MORE INFORMATION VISIT www.scosche.com OR CALL SCOSCHE INDUSTRIES, INC. AT 800-363-4490
2000 Pontiac Grand Prix
4-Door sedan PRELIMINARY: Disconnect the negative battery cable. ANTENNA: The factory antenna is located in the rear glass. RADIO REMOVAL AND IN-DASH INSTALLATION: Note: : The factory radio provision is a DIN and a Half opening. 1. Extract (2) Philips head screws from underneath steering column panel. 2. Adjust steering column and use Panel removal tool to pry off radio/dash trim bezel. 3. Extract (4) Philips head screws securing radio, pull away, disconnect, and remove. FRONT DOOR SPEAKER INSTALLATION: Note: The factory speaker provision is for a 5 ¼” driver with a 1 ¼” tweeter. When installing an aftermarket 5 ¼”, a speaker adapter is not required. 1. Using small pick, pry out screw covers from underneath door grabber, and extract (2) T27 Torx screws 2. Using Panel removal tool, pry along door panel perimeter, pull door panel away, disconnect, and remove door panel. 3. Extract (4) 9/32" screws securing speaker, pull away, and disconnect speaker. REAR DECK SPEAKER INSTALLATION: Note: The factory speaker provision is for a standard 6x9" speaker. When installing an aftermarket 5 ¼ or 6 ½, a speaker adapter is required. We recommend the Scosche SA69. 1. Release and remove bottom seat section. 2. Extract (2) 10mm. Bolts, and (2) 12mm. Bolts to release top seat back section, pull up and out to remove. 3. Use Panel removal tool to remove (2) plastic fasteners from rear deck panel, pull up and out to remove. 4. Extract (4) ¼ “ screws securing speaker, pull away, disconnect, and remove speaker.
NOTE: THIS MANUAL IS BASED ON CAREFULLY DOCUMENTED RESEARCH. ABSOLUTE ACCURACY IS ATTEMPTED BUT NOT GUARANTEED. USE THIS MANUAL AS A REFERENCE GUIDE. SCOSCHE, INC. CANNOT BE RESPONSIBLE FOR INCONSISTENCIES THAT MAY OCCUR..
156
© 2000 SCOSCHE INDUSTRIES, INC.
ALL RIGHTS RESERVED FOR MORE INFORMATION VISIT www.scosche.com OR CALL SCOSCHE INDUSTRIES, INC. AT 800-363-4490
