2014 Airport Lighting Products.indd

Transcript

Power & Control Equipment RC Radio Controller Compliances: FAA AC 150/5345-49: L-854 NASAO Guidelines Applications Ordering Information The Radio Controller permits the remote activation of the airport lighting system by the pilot. This is accomplished by keying the aircraft’s microphone in a particular sequence at a designated frequency. For the 1 step radio controller the system is activated upon receiving a series of pulses of radio frequency energy within a 5 second period. After receipt of five pulses the relay closes. The solid state timer will continue to operate for 15 minutes after which it will cause the system to revert to the original “off” condition. The timer is reset by the receipt of five pulses at anytime, reinitiating the 15 minute “run” cycle. The operating time may beselected in 15 minute increments from 15 minutes to 1 hour by setting switches on the Timer Board Each controller includes an antenna. If desired, specify by description a remote antenna with 50 feet (15 m) of coaxial cable. Specify the radio frequency. For the 3 step radio controller the systems is activated upon receiving a series of pulses of radio frequency energy within a five second period. At the third pulse the first relay closes, at the fifth pulse the second relay closes, at the seventh pulse the third relay closes. At any time the pilot has the option of sending three, five, or seven pulses to command the intensity level to his desires. The system will remain at the intensity of the last command received. The solid state timer will continue to operate for 15 minutes after which it will cause the system to revert to the “off” condition. The Timer is reset by the receipt of any command at any time, re-initiating the 15 minute “run” cycle. RC products are manufactured by Control Industries Description Part Number Radio Controller for 1 Step Radio Controller for 3 Step Regulator Interface Unit RC-1T2A RC-1T5A RIU-1200* * A regulator interface unit is not required for the operation of any Crouse-Hinds late model regulator. Outline Drawings 10.00 (254) 8.00 (203) 5/16˝ DIA. MTG. HOLE 4 PLACES ANTENNA R3 Receiver, Decoder, Tuner, and Power Supply 12.75 (324) R2 LED INDICATORS R1 12.00 (305) CAP. CONTROL 1 CONTROL 2 CONTROL 3 120 VAC NEUTRAL POWER TRANSF. FUSE Features Depth = 5.00 (127) ƒ ETL Certified ƒ Frequency: 118 to 136 MHz The UNICOM frequency of 122.8 MHz is commonly selected Dimensions: Inches (mm) Shipping Weight: 18.0 lbs. 8.2 kg. Shipping Volume: 0.62 cu. ft. 0.018 cu.m. ƒ Outdoor Enclosure ƒ Whip or Remote Antenna ƒ Input Voltage: 120V ƒ Solid-State Circuitry ƒ Ambient Temperature: ±55°C 4.22 www.crouse-hinds.com/airportlighting