Preview only show first 10 pages with watermark. For full document please download

2.8" Lcd Display Quick Start Guide

   EMBED

Share

Transcript

1 Unpack and verify contents Verify that your kit contains one each of these components: Quick Start Guide 2.8” LCD Application Kit 2.8” LCD Application Kit This Quick Start Guide 2.8” LCD Display board 1 - Flat ribbon 50-pin cable 1 - Flat ribbon 6-pin cable 2 Connect hardware to development board a Connect the 2.8” LCD Display board to the ConnectCore™ 9P/Wi-9P 9215 JumpStart board using the flat ribbon cables according to the following table and figures: Cable Flat ribbon 50-pin cable Flat ribbon 6-pin cable Development board connector Peripheral Application Header [X33] SPI Header [X8] 2.8” LCD display board connector Peripheral Application Header [P1] SPI Header [P2] Description Main display connection Touchscreen connection [X8] 2.8” LCD Display board [P1] [X33 ] ConnectCore™ 9P/Wi-9P 9215 JumpStart board 3 Download documentation NOTE: When connecting the cable be careful to align pin 1 on the JumpStart board with pin 1 on the LCD board as indicated by red ribbon stripe. [P2] 4 What’s next? Click on the “Documentation” link to access available product documentation a To obtain a complete bill of material and installation instructions specific to your platform, go to http://www.digi.com/support b Select "Application Kits," as shown, and click "Submit" c Click on “2.8” LCD Application Kit” link © Digi International, Inc., 2009 Digi, Digi International, ConnectCore and the Digi logo are trademarks or registered trademarks of Digi International, Inc., in the United States and other countries worldwide. All other trademarks are property of their respective owners.