Transcript
3 zone induction cooktop 600mm I3B60 3 Zone Induction cooktop Slide touch control Power booster to all zones Large pot 280mm zone with 5000W capacity Pan sensors Timer function Pause function Schott ceramic glass - easy clean 9 power levels Auto off safety switch Huge 5000W booster zone
Child lock Residual heat indicator Durable stainless steel frame
Zone Power Output (W) Front Left: 2200W/3600W
Total Power: 7200W 30amps 1200 W
Back Left: 1400W/2000W
Power:
Middle right: 3000W/5000W
Dimensions & Installation*
Product Dimensions: 590mm (W) x 520mm (D) x 55mm (H) Cut out Dimensions: 560mm (W) x 490mm (D)
or 2180 W
220 - 240 volt/50Hz
1100 W or 2395 W
1300 W
*Induction cooktops heat rapidly and unlike other
cooktops require air intake and air exhaust outlets. Please refer overleaf and to website and manual for correct installation requirements.
590 520 60 Warranty
490
2 year Parts and Labour Customer Service Our Nationwide Service Team can be contacted on 1800 444 357 email
[email protected]
560 Dimensions are a guide only refer to the instruction manual and website for full instructions
T: 02 9958 3111 F: 02 9958 3555 E:
[email protected]
www.euromaid.com.au
3 zone induction cooktop 600mm I3B60 INDUCTION COOKTOP INSTALLATION REQUIREMENTS Induction cook tops heat rapidly and unlike other cook tops require separated air intake and air exhaust outlets.
HEAT BARRIER Heat barrier should be the width of the internal cabinet. The barrier is fitted about midway (front to back) of the cook top to separate rear inlet and front outlet. It is affixed between coo ktop base and the heat shield or oven.
HEAT SHIELD A heat shield must be fitted when cook top installed above drawers or cupboard. Minimum distance between base of cook top and heat shield is 25mm. A heat shield is not required above an oven although minimum gap between oven and base of cook top should be 50mm.
Induction ctop bulletin 05-03-2010 MG
VERTICAL SUPPORT The vertical support should be fitted 16mm below bottom of bench top to allow exhaust of warm air from cook top vents. Support blocks maybe required above the vertical support for installation of stone or solid surface bench tops. A gap of 3-5mm is required between the benchtop and the top of the panel/door/drawer depending on what's situated below the cooktop .
TOP OF CABINET To ensure un-restricted airflow to cook top, back of cabinet needs to remain open or checked out.
VENILATION SPACE To allow adequate airflow a minimum gap of 20mm should be available between rear of cabinet and wall.
KICK BOARD Kick board should have a 3 to 5mm gap at top to allow airflow under cabinet and rear of the cabinet.
Warranty 2 year Parts and Labour Customer Service Our Nationwide Service Team can be contacted on 1800 444 357 email
[email protected]
T: 02 9958 3111 F: 02 9958 3555 E:
[email protected]
www.euromaid.com.au
