Transcript
AMERICAN SPECIALTIES, INC. 441 Saw Mill River Road, NY 10701 (914) 476.9000 • (914) 476.0688 www.americanspecialties.com
MODEL №:
3923
ISSUED:
1-87
REVISED:
31 Jan 2013
ANCHOR FOR 3/4" - 1" (19-25) THICK PARTITION EXPOSED MOUNTED GRAB BARS
3
4"-1"
[19-25] THICKNESS OF PARTITION (BY OTHERS)
STAINLESS STEEL NO. 3400 & 3500 GRAB BAR SERIES (NOT SUPPLIED)
3" DIA [Ø76] X 18" [3] THICK STAINLESS STEEL ROUND PLATE WITH THREE (3) 1/4-20 INTERNALLY THREADED POSTS X 5 8" [16] LONG WELDED-ON. ROUND PLATE TO HAVE A SATIN FINISH
3-18" DIA [Ø79] REF
2-14" DIA [Ø57] BOLT CIRCLE FOR THREE (3) WELDED POSTS TO MATCH COUNTERSUNK MOUNTING HOLES THROUGH GB FLANGE
3" DIA [Ø76] REF
NOTE: ALL DIMS INCH [MM] THREE (3) 1 4-20 x 3 4" [19] LONG PAN HEAD MACHINE SCREWS PER FLANGE
5
8"
[16]
SPECIFICATION Anchor for 3/4" - 1" (19-25) Thick Partition Exposed Mounted Grab Bars shall be type 304 stainless steel alloy 188. and shall have three (3) 1/4-20 internally threaded posts welded-on. Exposed side of plate shall have a satin finish. Anchor kit shall contain (1) Plate and (3) 1/4-20 x 3/4" (19) long Phillips or slotted pan head machine screws. Specify one (1) kit per flange. Anchor shall be Model № 3923 as manufactured by American Specialties, Inc., 441 Saw Mill River Road, Yonkers, NY 10701-4913 INSTALLATION Place grab bar on partition at desired location and mark mounting hole locations. Drill 3/8" diameter (Ø10) holes through the partition at marked locations. Place anchor at far side of partition and secure grab bar to it on near side with 1/4-20 machine screws (provided). Refer to grab bar specification for correct procedure and strength data. For compliance with 2010 ADA Accessibility Standards mount unit so that top of horizontal grab bar is 33" (838) minimum above finished floor (AFF) to 36" (914) maximum above finished floor, unless lower code applies.
THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE
