Transcript
3D Projection Ready on the Go Ideal Choice for Education and Home Entertainment Use! The BenQ 3D goggles are exceptionally designed to provide an immersive 3D viewing experience with BenQ’s DLP® LinkTM-enabled projectors*. *BenQ Projector with 3D Ready Function * Please visit the http://www.benq.us/product/projector/3dglasses website for a full list of supported products
3D Goggles Specification Part Number
5J.J0T14.011
Response Time
1.7ms
Contrast ratio (On/Off)
1000:1(typical)
View Angle (Left/ Right)
50 degree (typical)
Viewing Distance
~8M
Detect Type
DLP Link (Photo Sensor)
Storage Temperature
-10~60˚C
Operation Temperature
0~50˚C
Operation Humidity
20~85%
Power Consumption
4 mW (operation) / ~55hrs
Batteries
CR2032 x 2 (pcs)
Dimension (H x W x L)
45.9 x 168.8 x 165.2(mm)
Accessories
Quick start guide (paper) / Nose pad x 2 (Big/small)
BenQ America Corp. 15375 Barranca Parkway. Suite A-205. Irvine, CA 92618 Education Deal Registration – http://promotions.benq.us/education/ B2B Deal Registration - http://promotions.benq.us/dealregistration/
Tel: (949) 255-9500
www.BenQ.us
Do not block
English English
Light Sensor
Do not block Light Sensor
Battery cover
Remove battery cover, then install two CR2032 type batteries.
Do not block
! ON button
Press to start 3D function > Switch inverse images between your eyes
Battery cover
English
Remove battery cover, then install
Battery cover two CR2032 type batteries.
4 Remove battery cover, then install two CR2032 type batteries. This glasses support DLP-LINK 3D Ready projectors. When DLP-LINK signal has not been detected for 180 seconds, the 3D glasses will automatically turn off. The 3D glasses will blink when the batteries are reaching the end of life. WARNING: The 3D glasses are not prescription eyewear, sunglasses, nor a protective goggle. Do not use the glasses for any general eyewear purposes (e.g., driving, reading, protection from sunlight or ultraviolet light, etc.) ON as such use may result in injury. button
Press to start 3D function > Switch inverse images between your eyes Press to start 3D function > Switch inverse images between your eyes ON button
4
4 Nose piece
Replace with one of two sizes for a comfortable fit
Cleaning the lenses Clean the lenses whenever you notice dirt or dust on the surfaces. • Clean the lenses with a commercially available blower and/or lens cleaner. ! • If there is dirt or smears, use lens-cleaning paper or moisten a soft cloth with lens cleaner and gently wipe the lens surfaces. Never rub the lenses with abrasive materials.
English WARNING: To avoid the damage of battery cover, be sure to follow the steps as illustrations for battery installation.
5
