Transcript
3G-SDI to CVBS Converter User Manual
Connection Power Adaptor
3G-SDI Camera Power Input
SDI Input
SDI to CVBS Convertor
coaxial cable CVBS Output Coaxial cable
TV/ TV/ LCD LCD
Caution • • • •
Specification
This equipment is only for indoor use Do not use the power supply which is beyond the specified range. Unauthorized repair, alteration, misuse, will affect the warranty period. For any damage, please contact authorized service person for more information.
Packing • •
3G-SDI to CVBS Converter User Manual
x1 x1
Port 3G-SDI signal source SDI Signal status indicator CVBS Signal output
SDI IN STATUS CVBS OUT
DC 12V IN
DC 12V Power input
POWER
Power indicator
PAL/NTSC
PAL/NTSC switch
Input Signal
3G-SDI (BNC)
Output Signal
CVBS (BNC)
Supported Resolution
720P:25/30/50/60 FPS 1080P:25/30/50/60 FPS
3G-SDI Input distance
720P:25/30/50/60FPS 1080P:25/30 FPS 1080P:50/60 FPS
180M 100M
CVBS Output distance
720P:25/30/50/60FPS 1080P 25/30 FPS 1080P:50/60 FPS
350M 160M
Current Consumption
DC 12V/300mA(Max)
Dimension
88(L)x89(W)x23(H)mm
Weight
120g
Temperature
Operating Temperature: -10 to 40℃ Storage Temperature: -20 to 70℃
FAQ Fault phenomenon
POWER LED
Power status indicator light: When power up the converter, the color of LED light is red, after 2 seconds, it turns green. And when power off the converter; the LED light will be switched off
SDI STATUS
Signal status indicator light, When SDI signal input is normal, the light is green. When SDI signal input is error, the light is red. When not receiving effective signal, the light will be switched off.
PAL/NTSC
PAL/NTSC system switch. Turn the switch to PAL system or NTSC system, the setting will be effective after repowering up the converter.
*In theory, 3G-SDI signal can be transmitted over 100 meters, but the actual transmission distance depends on the quality of the coaxial cable and the BNC connector. The specification of the cable must meet 75-5 standard.
Possible reason
Solution
No CVBS signal output
1.Check whether the power line is connected well 2.Check whether the power adapter is faulty. 3.Check whether the signal line is faulty
The video output system is incorrect
After setting PAL/NTSC system, the converter was not repowered up.
The SDI status indicator light is not ON
1.Disconnected the 3G-SDI input signal 2.Faulty input signal line
1.Reconnection 2.Change the signal line
The SDI status indicator light is normally on
Incorrect input signal, it is not 3G-SDI signal
Change the input signal line
The power status indicator light is not ON
1. The power cable is poor connection 2.The power adapter is faulty.
1.Reconnection 2.Change the power supply
1.Reconnection 2.Change the power supply 3.Change the power supply Repower up the converter after setting.
