4-in-1 Cordless Rechargeable Shaver

Transcript

™ Gen us TECHNICAL SPECIFICATION Measurements: 55x55x165mm Cable Length: 1.5m Battery: NI-MH 600mAh Input: 3V 150mAh Est. 1992 e v e ry d ay s o l u t i o n s 4-in-1 Cordless Rechargeable Shaver INSTRUCTION MANUAL MEDICAL WARNING • Consult your dental professional before you use the toothbrush attachment of this product if you have had oral or gum surgery in the previous 2 months. • Contact your dental professional if excessive bleeding occurs after using the toothbrush attachment of this product or bleeding continues to occur after 1 week of use. • If you have a pacemaker or other implanted device contact your physician or the device manufacturer prior to use. • This device has been tested and is compliant with safety standards for electromagnetic devices. • Consult your physician prior to using this device if you have medical concerns. Model No. EL2776 Please read carefully before use and keep for future reference Imported and distributed by Easylife Group Ltd, London NW1 0JP Support Line: 0844 441 8448 For more innovative products from Easylife please visit: www.easylifegroup.com ™ Support Line: 0844 441 8448 IN2773 © 2016 Easylife Group Ltd Est. 1992 e v e ry d ay s o l u t i o n s For more innovative products from Easylife please visit: www.easylifegroup.com Important: Pack Contents: 1. 2. 3. 4. 5. 6. Shaving Unit Main Unit On/Off Button Charge/Battery Indicator Charging Pedestal /Cradle Hair Clippers Read this user manual carefully before you use the shaver and keep this manual for future reference. 7. Toothbrush Connector 8. Toothbrush Heads 9. Blade Oil 10. Nose Trimmer With Protection Cap 11. Cleaning Brush 12. Mains Adaptor Danger Keep the mains adapter (12) away from water. Warning Do not cut off the adapter to replace it with another plug. 1 These appliances are not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of these appliances by a person responsible for their safety. 2 Children should be supervised to ensure that they do not play with this product and included accessories. 3 5 12 4 6 9 Be careful with hot water when you clean the shaving heads. Always check if the water is not too hot, to prevent your hands from getting burnt. Caution Never immerse charger in water or rinse entire device under the tap. The appliances and accessories are not dishwasher-proof. Always place and use the appliances on a surface that is fluid-resistant. Use, charge and store the shaver at a temperature between 5oC and 35oC. Only use the accessories supplied with this shaver or that have been specifically developed for this shaver. • Do not use the appliances and accessories if they are damaged. • If the adapter or any of the other accessories are damaged, only replace them with an approved accessory. • Only use the Beard trimmer to trim facial hair (beard, moustache and sideburns). Do not use it to trim hair below the neckline. • Do not use included attachments with other devices. • • • • • 7 10 8 11 ™ Support Line: 0844 441 8448 For more innovative products from Easylife please visit: Est. 1992 e v e ry d ay s o l u t i o n s www.easylifegroup.com The Display Using Different Attachments: • Battery symbol: A blue light indicates the unit is working correctly when the device is switched on. • Lock symbol: When charging, a red light behind the lock symbol will illuminate. With interchangeable heads, simply pull off the shaver head and replace with either the nose trimmer, beard trimmer or toothbrush by simply aligning and slotting into place. Charging Note: Do not twist the shaving unit when removing it from the main unit. • Insert the small plug into the socket on the bottom of the shaver, then plug the adapter in the mains socket. When the shaver is charging, the ‘lock symbol’ should light up red. 2. Insert the lug of the trimmer or toothbrush connector or nose trimmer into the slot in the top of the shaver Then press down to attach it to the shaver body (‘click’). 1. Pull the shaving unit straight off the main unit. 3. Press the on/off button to switch on. • Fully charging takes approximatly 5 hours for approximatly 35 minutes of use. • To prevent over charging, please make sure you unplug the shaver after 5 hours. • Alternativley, you can charge via the charging pedestal. Insert the small plug into the socket at the back of the charging pedestal. Plug the adapter into a mains socket. Gentley put the shaver into the slot on the pedestal with the shaver display facing outwards. The display shows that the shaver is charging when the ‘lock symbol’ glows red. ™ Support Line: 0844 441 8448 For more innovative products from Easylife please visit: Est. 1992 e v e ry d ay s o l u t i o n s www.easylifegroup.com Shaving 6. Dry your face and thoroughly clean the shaver after use (see ‘Cleaning and Maintenance’ section, pg. 11). Note: Make sure you rinse all foam or shaving gel off the shaver. Skin adaptation period Your first shaves may not bring you the result you expect and your skin may even become slightly irritated. This is normal. Your skin and beard need time to adapt to any new shaving system. Hair Trimming Trimming the corner and the temple We advise you to shave regularly (at least 3 times a week) for a period of 3 weeks to allow your skin to adapt to the new shaver. During this period, use your new electric shaver exclusively and do not use other shaving methods. If you use different shaving methods, it is more difficult for your skin to adapt to the new shaving system. 1. 2. 3. 4. After shaving if you would like to trim the corners or temples, you can use the little trimmer at the back side of the shaver. • Make sure the shaver is off • To open, simply slide the button on the back of the main unit down and the trimmer will pop out. • To close, press the cover of the trimmer back into the slot until you hear a click. Press the on/off button once to switch on the shaver. Move the shaving heads over your skin in circular movements. Do not make straight movements. Press the on/off button once to switch off the shaver. Wet shaving You can also use this shaver on a wet face with shaving foam or shaving gel. Hair Clippers To shave with shaving foam or shaving gel, follow the steps below: 1. Apply some water to your skin. 2. Apply shaving foam or shaving gel to your skin. 3. Rinse the shaving head under the tap to ensure that the shaving unit glides smoothly over your skin. DO NOT PUT THE BODY OF THE SHAVER UNDER THE TAP. 4. Press the on/off button once to switch on the shaver. 5. Move the shaving unit over your skin in circular movements. Note: Rinse the shaver head under the tap regularly to ensure that it continues to glide smoothly over your skin. DO NOT PUT THE BODY OF THE SHAVER UNDER THE TAP ™ You can use the trimmer to groom your sideburns and moustache. Do not use it to trim hair below the neckline. The trimmer comes with a comb guide when you receive it. You can use the hair clippers either with the guide or without. Support Line: 0844 441 8448 For more innovative products from Easylife please visit: Est. 1992 e v e ry d ay s o l u t i o n s www.easylifegroup.com Hair Clipper Before trimming, comb your hair as per hair growth direction. Nose and Ear Hair Trimming 1. Make sure the nose or ear is clean. Comb guide has two length guides, 3mm and 6mm. Please note the number indicated is the length of hair that will remain. 2. Insert the tip of the outer blade into your nostril or aural cavity. Insert it slowly so as not to injure your nostril or aural cavity. 3mm 6mm 3. Cut the nose hair and ear hair by moving the appliance. Gently push a corner of the comb to remove and the marking is on the back side of the comb guide. 4. Move the trimmer slowly so as not to injure your nostril or aural cavity. 1. Chose the desired length and put the comb back to the trimmer until it clips securely. 5. Cut only the nostril hair around the entrance using the tip (approx. 5mm) of the outer blade (metallic part). 2. Press the on/off button to start trimming. 6. Some trimmings may remain inside your nostril or aural cavity. After cutting, remove them using a tissue or cloth. The outer blade surface may get a little warm during use, but performance will not be affected. 3. Place the flat base of the Trimmer /comb guide against the skin. 4. Slowly slide the Trimmer Guide and Blades through hair. Repeat from different directions as necessary. 5. Repeat the same when using the trimmer without the comb guide. ™ Support Line: 0844 441 8448 For more innovative products from Easylife please visit: Est. 1992 e v e ry d ay s o l u t i o n s www.easylifegroup.com Using the Toothbrush Cleaning and Maintenance 1. Make sure the shaver is off before attaching the toothbrush and adapter. • Always ensure the shaver is unplugged and switched off before cleaning. Clean the shaver: 2. Insert the toothbrush into the toothbrush adapter. • Pull open the shaving heads one by one (Fig. 1). 3. Then firmly press the brush and adapter into the main unit until it clicks into place. • Rotate and pull open the centre head last (Fig. 2). • Tip any collected hair into a waste receptacle. Brushing • Use the provided cleaning brush to remove any hair or residue inside the accessory. Fig. 1 Fig. 2 1. Wet the bristles and apply a small amount of toothpaste. • Wash only the shaver head, not the whole body, with water (Fig. 3). 2. Place the toothbrush bristles against the teeth at a slight angle towards the gum line. 3. Press the power on/off button to turn on. • Leave the shaving heads open to dry completely. Nose/Ear Hair Trimmer and Hair Clippers: 4. Gently move the brush head slowly across the teeth in a small back and forth motion so the longer bristles reach between your teeth. Continue this motion throughout your brushing cycle. • Clean the blades with the cleaning brush and tap water. Fig. 3 Main Unit 5. After you have completed the brushing cycle, you can spend additional time brushing the chewing surfaces of your teeth and areas where staining occurs. You may also brush your tongue, with the toothbrush turned on or off, as you prefer. • Only use a soft damp cloth to clean the main unit of the shaver and never immerse the whole unit in liquids. Lubricating • Using the supplied blade oil, lubricate the trimmer blades and shaver heads with a small drop of oil once every 6 months or when blades do not move freely. ™ Support Line: 0844 441 8448 For more innovative products from Easylife please visit: Est. 1992 e v e ry d ay s o l u t i o n s www.easylifegroup.com