Transcript
Instruction Sheet
408-4293
Fiber Optic Sapphire Scribe Tool 504064-1
27 Jul 07
Rev A
2. Gently draw the beveled edge of the sapphire blade across the fiber as shown in Figure 2. 3. After lightly scoring the fiber, pull the fiber straight away from the connector to finish the scribe process. The fiber should shear cleanly at the scribe point.
Metal
After Lightly Scoring, Pull Fiber Straight Away
Body Fiber Sapphire Cutting Tip
Epoxy
Clear Plastic Cap
Ferrule Tip
Scribe Tool
of Connector
Figure 1
1. INTRODUCTION
Figure 2
This instruction sheet covers the use of Fiber Optic Sapphire Scribe Tool 504064–1. The tool is used to remove fiber from the connector end face before polishing. Read these instructions thoroughly before using the tool. Reasons for reissue of this instruction sheet are provided in Section 4, REVISION SUMMARY.
2. DESCRIPTION
4. INSPECTION It is recommended that the tool be inspected immediately upon arrival at your facility. AMP also recommends inspection at regularly scheduled intervals, to ensure that it has not been damaged during handling and use.
The scribe tool has a cutting tool design. The body is metal, the cap is plastic, and the cutting tip is sapphire.
Visually inspect the tool, especially the tip. The tip should be clean, dry, and free from cracks, nicks, or any deformities. If the tip is damaged, it should be replaced or discarded. The tip cannot be repaired.
3. SCRIBING PROCEDURE
5. TOOL REPLACEMENT
Before scribing the fiber, make sure the epoxy in the connector has been properly cured.
Order replacement tools through your representative, or call 1–800–526–5142, or send a facsimile of your purchase order to 717–986–7605, or write to:
DANGER
ALWAYS wear safety glasses when working with optical fibers. BE VERY CAREFUL to dispose of fiber ends properly. The fibers create slivers that easily puncture the skin and cause irritation.
1. Place the sapphire cutting tip on the fiber just above the epoxy as shown in Figure 2. CAUTION
6. REVISION SUMMARY
DO NOT allow the sapphire cutting tip to touch the epoxy. The epoxy may damage, chip, or crack
!
CUSTOMER SERVICE (038–035) TYCO ELECTRONICS CORPORATION PO BOX 3608 HARRISBURG PA 17105–3608
the sapphire cutting tip.
E
2007 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
Revisions to this instruction sheet include:
S Updated document to corporate requirements
TOOLING ASSISTANCE CENTER 1-800-722-1111
This controlled document is subject to change.
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
TE logo and Tyco Electronics are trademarks. *Trademark. Other products, logos, and company names used are the property of their respective owners.
visit our website at
www.tycoelectronics.com
1 of 1 LOC B
