Preview only show first 10 pages with watermark. For full document please download

4.25” Installation Cautions

   EMBED

Share

Transcript

4.25” INSTALLATION CAUTIONS When installing an EM110 with a PM110, please note the following: 1. The EM110 must always be installed on the left side of the PM110, as illustrated in Fig. 3, so that it will agree with the orientation required by Dragon Drop-IR™ (if used). Refer to the DD4 Dragon Drop-IR instructions. Always mount the EM110 to the left of the PM110 in the J-box. PGM CNCL FULL CLR MEM RESTORE NETWORK SEQ DELAY WRITE 89A TRNS PROTECT 67 STEP 5.0” 45 BCD 01 23 EF EDIT NETWORK ADDRESS DEL XFER ERR IR C O M EM110 PM110 Fig. 3 EM110/PM110 Mounting Precautions 2. In addition, mounting on the left side allows the case screws to nest together, preventing mechanical interference between the two units when mounted in a J-Box. See Fig. 3. 08901130 rev. A 10-28-99 4.25” THE EM110 BASE MODULE For the Smart Pad3 system The EM110, one of three base modules in the Smart Pad3 system, is used as an Expansion Module when 3-gang configurations are required. It has no memory and serves only to expand the number of key functions for the PM110. Refer to the Smart Pad3 INSTALLATION INSTRUCTIONS for further information. PM110 EM110 (Rear) (Rear) EM110 (Front View) Red Stripe Red Stripe PM110 SMART PAD3TM PROGRAMMABLE MODULE TO PM1 10 SPEAKER OUTPUT R+ L+ L– R– R+ GND R– STATUS L– +12V AMPLIFIER INPUT L+ IR OUT TO EM110 5.0” ® ® SYLMAR, CA Fig. 1 MADE IN U.S.A. 20-Conductor Ribbon Cable & Plug Ass'y (supplied with EM110) Fig. 2 3-Gang EM110 to PM110 Connections This package contains one EM110, a 20-Conductor Ribbon Cable & Plug Assembly and screws for J-box mounting. Connect the EM110 to a PM110 using the 20-Conductor Cable as shown in Fig. 2. Be sure to orient the cable so that the red stripe side is positioned as shown. See also "INSTALLATION CAUTIONS", over.  12950 BRADLEY AVENUE, SYLMAR CA 91342 Tel: (818) 362-0353 • Fax: (818) 362-9506 • www.xantech.com