Transcript
Installation Repeater—Operation and Maintenance This guide covers the following Pathway product numbers: #4807 - 4-way Installation Repeater #4808 - 8-way Installation Repeater #4809 - 12-way Installation Repeater #4810 - 16-way Installation Repeater #4813 - 4-way Installation Repeater w/RDM #4814 - 8-way Installation Repeater w/RDM #4815 - 12-way Installation Repeater w/RDM
Model 4808
OPERATING ENVIRONMENT Pathway eDIN Installation Repeaters are intended for installation in dry, indoor, non-hazardous environments suitable for NEMA 1 enclosures. Operating temperature range is from –10°C to +50°C, up to 95% humidity, non-condensing.
WARNING All DMX input/output ports must be connected to low-voltage data lines only. Do not connect high voltage sources to these connectors or serious damage and possible injury will occur.
OPERATION
WARRANTY
Once a Pathway eDIN Installation Repeater is completely and properly installed, its operation is fully transparent to the end user. No on-going or periodic user action is required.
All Pathway eDIN Installation Repeaters shall carry a three-year Limited Warranty against defects in materials and workmanship under normal use and service. Pathway Connectivity’s sole responsibility under this warranty shall be to repair, replace or refund at Pathway’s discretion, any units which are determined to be defective upon Pathway’s inspection. Pathway may elect to refund the cost of the device upon return, solely at Pathway Connectivity’s discretion. This warranty applies to the original purchaser or retail customer only
In the event of power loss, an eDIN Installation Repeater will resume full normal operations once power is restored, without any user action or intervention necessary. MAINTENANCE Pathway eDIN Installation Repeaters require very little maintenance. Enclosures exteriors should be inspected annually for physical damage from impacts or liquids. Steps should be taken, if necessary, to prevent liquids from contacting the enclosure in future. Enclosure interiors should be inspected annually for loose wires and connections, and for debris. Connections should only be tightened if necessary. Debris should be gently removed from the interior and its source determined.
Pathway Connectivity Solutions #103 - 1439 17 Avenue SE Calgary AB Canada T2G 1J9 (403) 243-8110 fax (403) 287-1281
[email protected] www.pathwayconnect.com
