Transcript
DTK-4LVLP-CR LOW VOLTAGE CARD READER CIRCUIT PROTECTION
INSTALLATION INSTRUCTIONS NOTE: THIS DEVICE IS INTENDED FOR INDOOR USE ON ISOLATED LOOP CIRCUITS, DATA, OR LOW VOLTAGE TELECOMMUNICATION CIRCUITS. 1. BEFORE BEGINNING INSTALLATION, MAKE SURE THE POWER IS OFF. 2. THIS DEVICE MUST BE CONNECTED IN SERIES BETWEEN THE FIELD WIRING AND THE EQUIPMENT TO BE PROTECTED. 3. SECURELY MOUNT THE BASE CLOSE TO THE CIRCUIT BEING PROTECTED USING THE DOUBLE SIDED TAPE (SUPPLIED), OR TWO #8 SCREWS (NOT SUPPLIED). 4. MAKE SURE THE WIRE DISTANCE FROM THE SURGE PROTECTOR TO PROTECTED EQUIPMENT IS GREATER THAN THE WIRE DISTANCE FROM THE SURGE PROTECTOR TO GROUND. 5. USE ONE COMMON GROUND PER SYSTEM TO ELIMINATE THE POSSIBILITY OF A DIFFERENCE IN GROUND POTENTIALS. 6. FOLLOW THE DIAGRAMS ON THE UNIT AND CONNECT THE WIRES ACCORDINGLY. 7. AFTER ALL CONNECTIONS HAVE BEEN MADE AND NO HAZARDS EXIST, RESTORE POWER. 8. IF YOU HAVE ANY QUESTIONS CALL TECHNICAL SUPPORT AT: 1-888-472-6100. SLOT 0.180" x 0.240" TYP. 2 places
5-12VPWR
}
}
} 24VPWR
(1v)
DATA (5V)
AUD. LED
1.60"
OUTPUT PROTECTED
SURGE PROTECTION
DTK-4LVLP-CR SURGE PROTECTION 1.165"
1.555"
5-12VPWR
}
DATA (5V)
}
5-12VPWR
LED AUD.
}
DATA (5V)
}
}
LED AUD.
}
(1v)
(1v)
24VPWR
INPUT UNPROTECTED
24VPWR
0.10"
DTK-4LVLP-CR
INPUT UNPROTECTED
SURGE PROTECTION
DTK-4LVLP-CR SURGE PROTECTION 0.20" 2.60"
3.00"
TITLE:
Diversified Technology Group, Inc.
INSTALLATION INSTRUCTIONS DTK-4LVLP-CR APPROVED BY:
MATERIAL: FINISH:
1720 Starkey Road
Largo, Florida 33771
Tel. 727-812-5000
Fax 727-812-5026
DRAWN BY:
RWM
DATE:
8-23-01
REVISED:
6-5-02
DWG NO.
INT-100025-001
PART NO.
191405
REV.
2
