Transcript
Manson
MISCELLANEOUS PRODUCTS & ACCESSORIES SSB - 4112 / 4212 Battery Protector (Low Voltage Disconnect)
Manson
PRODUCT GUIDE & INDEX Lead Acid Battery Chargers AC-DC 3-Stage IUoU Charger with High Efficiency Zero Voltage Switching Mode Design
Description
Intended applications
Over-discharging batteries can damage batteries and or load, and require a longer recharge time. A Low Voltage Disconnect prevents this happening so it is in effect a battery protector. Manson's SSB4XXX battery protector is all solid state (FET) with micro-processor control (MCU). There is no metal contacts like most voltage sensitive relay in the market . The MCU continuously monitors the battery voltage and load current, disconnects the load when battery voltage is below the preset voltage level (LVD) or when load current is above the rated value of the unit. When the battery is recharged, the voltage is raised to another preset voltage level (LVR) the load is then automatically reconnected again. The FET design limits the voltage drop to less than 0.25V even at 100A load current .It has an extremely low standby (6 mA) and operation (9 mA) current consumption. It also protects the load from over voltage (from charging source to the battery) by disconnecting the load.
To protect starting, house or site batteries and equipments for caravan, SUV, boat, with DC loads such as DC motors, inverter, communication equipment, fridge, and etc against damage, and over discharging. When battery is connected to a charging source such as solar, wind, battery charger, it can conserve the battery power by allowing the load to draw power from the charging dc source when the battery is full according to your presets of LVR and LVD.
Model
Page Power Rating
Key Features
SBC-2130
25-26 Input : 100-240Vac ; Output : 12Vdc 30A
SBC-2140
Input : 100-240Vac ; Output : 12Vdc 40A
• • • • • • •
SBC-2150
Input : 100-240Vac ; Output : 12Vdc 50A
SBC-2215
27-28 Input : 100-240Vac ; Output : 24Vdc 15A
SBC-2220
Input : 100-240Vac ; Output : 24Vdc 20A
SBC-2225
Input : 100-240Vac ; Output : 24Vdc 25A
SBC-2408
29-30 Input : 100-240Vac ; Output : 48Vdc 8A
SBC-2410
Input : 100-240Vac ; Output : 48Vdc 10A
SBC-2413
Input : 100-240Vac ; Output : 48Vdc 13A
AC-DC 3-Stage IUoU High Frequency Charger Model
Page Power Rating
Key Features
SBC-2105
31
• Selection for sealed & Wet type battery • LED indicator for charging & full • Electronic protections with auto recovery for short circuit, reverse polarity, OVP, OTP and battery under voltage (<7.5V) • Plastic clip on mounting bracket and crocodile clip
• • • • •
10 selections of Low Voltage Disconnect and Low Voltage Reconnect All Solid State with Micro-processor Control Extensive Protections: Over Temperature, Over Voltage / Over Current. Manual over-ride connection Extruded Aluminum housing with PC plastic end caps Minus 40°C to +60°C operation temperature.
DC-DC 3 Stage IUoU Charger / 13.8V / Half Input Converter Model
Page Power Rating
BBC-3140 32
Specifications MODELS BATTERY VOLTAGE SYSTEM PROTECTOR SETTING LVD = Cut Out LVR = Cut In Mode 0 Mode 1 Mode 2 Mode 3 Mode 4 Mode 5 Mode 6 Mode 7 Mode 8 Mode 9 ON/OFF Delay Time for Protector Mode PROTECTION Low Voltage Protection (No Delay) Over Voltage Protection Over Temperature Protection Protection Current (Start Point) CONTINUOUS OUTPUT CURRENT MAXIMUM OUTPUT CURRENT (delay 10-60 seconds) OPERATION CURRENT CONSUMPTION (LED ON) IDLE CURRENT CONSUMPTION (LED OFF) VOLTAGE DROP WITH 100A (MAIN BATT. to AUX. BATT.) OPERATION TEMPERATURE RANGE OVER-RIDE FEATURE INDICATION BY LED (TWO COLOR RED AND GREEN) APPROVAL DIMENSION (L x W x H) WEIGHT
Input : 180-260Vac ; Output : 12Vdc 5A
Features •
SSB-4112 12VDC Tolerance: ±0.1Vdc for 12Vdc sys. LVD LVR 10.5V 12.9V 10.9V 13.0V 11.2V 13.1V 11.5V 13.2V 11.9V 13.3V 12.1V 13.4V 12.4V 13.5V 12.6V 13.6V 12.8V 13.7V 13.0V 13.8V 15 seconds 8.5VDC ±0.5VDC 18.5VDC ±0.5VDC Yes 140A 100A 120A 9mA 6mA 250mV -40°C to +60°C YES YES CE EN 61000 162x75x50 mm 6.3x3.0x2.0 inch 486g 17oz.
◘ All values are based on the Standard ambient Temperature 25°C and Pressure 0.1Mpa. ◘ SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE
SSB-4212 24VDC Tolerance: ±0.2Vdc for 24Vdc sys. LVD LVR 21.0V 25.8V 21.8V 26.0V 22.4V 26.2V 23.0V 26.4V 23.8V 26.6V 24.2V 26.8V 24.8V 27.0V 25.2V 27.2V 25.6V 27.4V 26.0V 27.6V
Wide AC input range Zero voltage switching design for high reliability and efficiency 4 battery type selection: Wet / Calcium-Calcium / AGM / GEL Power supply mode / Charger mode selection Auto-soft start bulk charge Remote temperature sensor is included Dual LED indicators for bulk, absorption, Float charge; Fault, Power supply or Charger mode and Power ON • Thermal control variable speed fan cooling • Auto-recivery short circuit, Overload, Over temperature, Over voltage protection, Thermal fuse reversed polarity protection
Input : 22-30Vdc ; Output : see operation modes As 3-Stage 12V charger varies with battery type Voltage Converter : regulated 13.8Vdc Voltage Reducer : half input voltage
Key Features Software based power conversion technology • 3 operation mode: 3 stage 12V charger, voltage reducer with 13.8V output or half input voltage • 3 stage charger for Wet, Gel, AGM & Calcium-Calcium type battery • 2 user defined charging profiles; Auto on & off with ignition control; MCU control • Optional remote control panel & temperature sensor
Low Power Smart Charger Model
Page Power Rating
Key Features
SBC-8168
33
Input : 100-240Vac ; Output : 12Vdc 5A
SBC-8268
34
Input : 100-240Vac ; Output : 25Vdc 2.2A
• MCU control 4 stage charging: Repair, Bulk, Absorption, Float • Pulse width modulation PWM charging for Repair, Absorption and Float Charging • Charger self-checks and scans battery for Repair / Reversed polarity / Fault • Selection of Car / Motorcycle / Cold weather charging mode • Thermal control regulates charging current in hot or enclosed conditions • Suitable for all types of Wet, Gel, AGM lead acid battery from 5 to 120AH • Supplied with two swappable leads with clamps and eyelet terminal • Universal AC input 100 to 240V • Can be connected permanently to battery • Auto returns to last selected charge mode when mains returns after power outage
High Power Smart Charger 17VDC ±1.0VDC 34.5VDC ±1.0VDC
Model
Page Power Rating
Key Features
SBC-8138
35
Software based MCU control 7-Stage Lead Acid and selection to Power Supply mode • 4 Battery type selection: Wet / AGM / Gel / Calcium-Calcium • Adjustable output current from 10% to 100% for wide battery capacity AH • Extensive protections with Alarm & LED including auto thermal decrease of output current to shut down • LED indications of 8 Charging stage and 8 Protection status • Supplied with charging cable and battery clamp mounted with temperature sensor
SBC-8238
SBC-9138 SBC-9238
Input : 180-260Vac ; Output : 12Vdc 25A
Input : 180-260Vac ; Output : 24Vdc 12A
36
Input : 180-260Vac ; Output : 12Vdc 25A Input : 180-260Vac ; Output : 24Vdc 12A
A deluxe version of SBC-9138 / 9238 with LCD showing : All the charging stages in a graphic format Amp, Voltage, AH values Types of fault, battery selection type, setting of charging current limit
