Transcript
FIBER OPTIC TECHNOLOGY CALIBRATION LABORATORY
Optical Terminators Plug type Description: The plug-type optical terminations are used to terminate dark fiber ports on fiber optic components. The zirconia ferrule is polished with an angled end face to reduce un-wanted reflections from open ports. These terminations also provide improved personnel safety over other termination methods.
Features: • • • •
Reduced backreflection Termination possible without use of matching gels Easy to install Optical terminations are matched to system design
Application: • • • •
Termination of dark fiber ports on products such as DWDMs (Dense Wavelength Division Multiplexors), switches and other multiport components Bidirectional transmission systems Analog and CATV transmission systems High bit rate telecommunication systems such as STM-16 (OC-48) and above
TER_01-01_EN is registered trademark of OPTOKON, a.s. Other names and trademarks mentioned herein may be the trademarks of their respective owners. 19/05/2014 OPTOKON, a.s. reserves the right to make changes, without notice, to the products described in this document, in the interest of improving design, operational function and/or reliability. OPTOKON, a.s. Cerveny Kriz 250, 586 01 Jihlava, Czech Republic tel. +420 564 040 111, fax +420 564 040 134, WWW.OPTOKON.COM,
[email protected]
1
FIBER OPTIC TECHNOLOGY CALIBRATION LABORATORY
Specifications:
Specifications (Angled 8°)2
Parameters Wavelength range
1310 to 1650 nm
Return loss (FC, SC, LC)
>60 dB
Operating temperature
-25 to +70 °C
Storage temperature
-40 to +85 °C
Power durability
1 W - standard
Ordering code: TER - XXX-HD
Connector Type: NPC1 NSC NLC
Note:
1) NPC NPC215 2) APC
FC/APC SC/APC LC/APC
2.05 mm standard 2.15 mm standard on demand angled polishing 8°, other angle on demand
TER_01-01_EN is registered trademark of OPTOKON, a.s. Other names and trademarks mentioned herein may be the trademarks of their respective owners. 19/05/2014 OPTOKON, a.s. reserves the right to make changes, without notice, to the products described in this document, in the interest of improving design, operational function and/or reliability. OPTOKON, a.s. Cerveny Kriz 250, 586 01 Jihlava, Czech Republic tel. +420 564 040 111, fax +420 564 040 134, WWW.OPTOKON.COM,
[email protected]
2
