Transcript
6-465.1 5H084765
October, 2015
INSTALLATION INSTRUCTIONS Trim Kits
Figure 1 – Deflect Blade and Front Plate removal Installation Instructions Huntin' Dawg Kit: Step one - Remove all louver blades off of heater. Step two - Remove all louvers blade springs (do not discard). Step three - Remove screws from the front face plate. Step Four - Add new "Camo" face plate to unit and replace with the screws previously removed. Step five - add existing louver springs and new "Camo" deflector blades onto unit.
Carbon Fiber Kit: Step one - Remove all louver blades off of heater. Step two - Remove all louvers blade springs (do not discard). Step three - Remove screws from the front face plate. Step Four - Add new "Carbon Fiber" face plate to unit and replace with the screws previously removed. Step five - add existing louver springs and new "Carbon Fiber" deflector blades onto unit.
Diamond Plate Kit: Step one - Remove screws from the front face plate. Step two - Add new "Diamond” face plate to unit and replace with the screws previously removed.
Modine Manufacturing Company has a continuous product improvement program, and therefore reserves the right to change design and specifications without notice. Modine Manufacturing Company 1500 DeKoven Avenue Racine, WI USA 53403-2552 Phone: 1.800.828.4328 (HEAT) www.modine.com © Modine Manufacturing Company 2015
Litho in USA
