Transcript
Series 1-DC • D1D to D5D series SSRs; MOSFET output • Ratings from 7A to 40A @ 200 VDC, and from 7A to 10A @ 500 VDC • DC Control • Relays are easily paralleled for higher-current applications
PRODUCT SELECTION Load Voltage 100 VDC 200 VDC 400 VDC 500 VDC
7A
10A
D1D07 D2D07 D4D07 D5D07
12A
20A
40A
D1D12 D2D12 D4D12
D1D20
D1D40 D2D40
D5D10
OUTPUT SPECIFICATIONS (1) Description Operating Voltage Range Maximum Off-State Leakage Current @ Rated Voltage [mArms] Maximum Load Current (3) [Adc] Minimum Load Current [mA] Maximum Surge Current (16.6ms) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Thermal Resistance Junction to Case (Rjc) [°C/W] Maximum On-State Resistance [RDS-ON][Ohms]
7A
12A
20A
40A
7A
12A
40A
7A
12A
7A
10A
0-100 0.1 7 0 15 2.0 2.2 0.29
0-100 0.2 12 0 28 1.6 1.34 0.13
0-100 0.3 20 0 42 2.1 1.06 0.10
0-100 0.3 40 0 106 2.1 0.83 0.05
0-200 0.1 7 0 22 2.0 1.5 0.29
0-200 0.3 12 0 27 2.8 1.06 0.23
0-200 0.3 40 0 106 2.1 0.83 0.05
0-400 0.3 7 0 17 4.2 1.06 0.6
0-400 0.3 12 0 36 4.2 0.8 0.35
0-500 0.2 7 0 19 5.7 1.0 0.8
0-500 0.3 10 0 29 5.5 0.8 0.55
INPUT SPECIFICATIONS (1) Description
DC Control
Control Voltage Range Maximum Turn-On Voltage Minimum Turn-Off Voltage Maximum Input Current (1-DC only) Nominal Input Impedance Maximum Turn-On Time [µsec] Maximum Turn-Off Time [msec]
3.5-32 VDC 3.5 VDC 1.0 VDC 1.6 mA (5 VDC), 28 mA (32 VDC) See Note 4 100 1.0
GENERAL SPECIFICATIONS Description Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 V DC) Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation Terminals Recommended Terminal Screw Torque Range:
Parameters 2500 VRMS 109 Ohm 50 pF -20 to 80°C -20 to 125 °C 3.0 oz (86.5g) Thermally conductive Epoxy Screws and Saddle Clamps Furnished, Unmounted 6-32 Screws - 10 in lbs. 8-32 and 10-32 Screws -20 in. lbs. (Screws dry without grase)
GENERAL NOTES 1) 2) 3) 4)
All parameters at 25°C and per section unless otherwise specified. Dielectric strength and insulation resistance are measured between input and output Heat sinking required, for derating curves see page 3. Input circuitry version incorporates active current limiter.
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com
MECHANICAL SPECIFICATIONS
THERMAL DERATE INFORMATION
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com
WIRING DIAGRAM
MAXIMUM SURGE VS DURATION
AGENCY APPROVALS UL E116950 (100 Volt Models 1-DC Only ) Rev. 121608
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com
ANNEX - ENVIROMENTAL INFORMATION
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com
