Transcript
6308 card English
20/3/01
1:27 pm
Page 1
Quick Installation
Step 3 Connect the VCR Video and camera switch pulse (VEXT)
Step 1 Connect cameras
Step 4 Connect the PSU The cameras must be connected before switching on
Step 2 Connect monitors Main monitor
Spot monitor (optional)
Step 5 Switch on power
Is now ready to record without any further programming!
6308 card English
20/3/01
1:27 pm
Page 2
Viewing multiple cameras
Operating
Picture in Picture Press the PIP key to swap the main and PIP image. Press and hold the PIP key to edit the display, use required camera key to fill that segment.
Recording cameras to tape
to select the segment, press the
Press mode to exit.
Quad
• Select the required time-lapse mode on the VCR.
Press the QUAD key to switch to a quad display. Press and hold the QUAD key to edit the display, use to select the segment, press the required camera to fill that segment (not available on 4-way Sprite Lite).
• Press record on the VCR. • Simplex (SX) units - Press mode until the ‘Record’ LED on the front panel is lit.
Press mode to exit.
• Cameras will now multiplex record to tape.
Multiscreen (not available on 4-way Sprite Lite)
Playing back a tape • Double press the mode key to enter playback mode – the ‘Play’ LED is lit on the front panel.
Press the multiscreen key to toggle between 9-way, 8+2, 12+1 and 16-way. Press and hold the Multiscreen key to edit the display, use to select the segment, press the required camera key to fill that segment.
• Select 3-hour mode on the VCR and press play.
Press mode to exit.
• To stop playing back, press mode on the Sprite Lite and stop on the VCR.
Viewing cameras on the spot monitor Press the mode key to toggle 'spot' mode, this is indicated by the word 'SPOT' on the main monitor and the front panel spot LED illuminating. Press a camera key to display that camera on the Spot monitor.
Sequencing cameras Main monitor sequence
Viewing single cameras Full V
Pressing the camera key will display a full screen image of that camera.
1
Press the sequence key to toggle the main monitor sequence on or off. Press and hold the sequence key to edit the sequence, use the camera keys to insert or remove cameras from the sequence.
Zooming an image
Press mode to exit.
Press the camera key to toggle zoom on and off. When zoom is enabled, use to scroll around the image.
Spot monitor sequence
Freezing an image V
Double press the camera key to toggle freeze frame on or off.
Press the mode key to toggle 'spot' mode, this is indicated by the word 'SPOT' on the main monitor and the ‘Spot’ LED on the front panel illuminating. Press the sequence key to toggle the main monitor sequence on or off. Press and hold the sequence key to edit the sequence, use the camera keys to insert or remove cameras from the sequence. Press mode to exit. Note: The sequence dwell time is preset to 5 seconds.
www.dedicatedmicros.com MI-U-SPL/E2-0
