696-960 Mhz - Amphenol Antenna Solutions

Transcript

696-960 MHz BCD-7001-EDIN-X Single Band | Omni Antenna | V-Pol | 360° | 1.1 dBd | Fixed Tilt • Single band, omni antenna with fixed electrical tilt • Mounting bracket included D E U N I T N O C S I D Ordering Options Antenna with 0° of electrical downtilt EDIN Female Connector NE Female Connector BCD-7001-EDIN-0 BCD-7001-NE-0 Electrical Characteristics Frequency Bands 696-960 MHz 696-806 MHz Polarization 806-960 MHz Vertical Horizontal Beamwidth 360° 360° Vertical Beamwidth 70° 70° 0.5 dBd (2.6 dBi) 1.1 dBd (3.2 dBi) Gain Electrical Downtilt 0° Impedance 50Ω VSWR 1.6:1 IM3 (2x20W carrier) < -145 dBc Input Power 250 W Total Number of Connectors Connectors Per Band 696-960 MHz Antenna has 1 connector located on the bottom of the antenna 1 Connector, Elongated 7/16-DIN Female (EDIN) or Elongated N Female (NE) (see ordering options section above for available connector types) Lightning Protection Direct Ground Mechanical Characteristics Dimensions (Length x Diameter) Weight without Mounting Brackets Survival Wind Speed Wind Area Wind Load (161 km/hr or 100 mph) 250 x Ø100 0.9 > 201 0.03 72 mm 9.8 x Ø3.9 kg km/hr m2 2 > 125 in lbs mph 0.34 ft2 16 lbf N Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice. REV061115R www.amphenol-antennas.com 1 of 2 696-960 MHz BCD-7001-EDIN-X Single Band | Omni Antenna | V-Pol | 360° | 1.1 dBd | Fixed Tilt D E U N I T N O C S I D Mounting Options Part Number Image Fits Pipe Diameter Weight This antenna cannot be mechanically downtilted. All mounting bracket kits are ordered separately unless otherwise indicated. Select from the options listed below. --- Standard Mounting Bracket Kit (Included) N/A Downtilt Bracket Kit Antenna cannot be mechanically downtilted Inverted Mounting The BCD-7001-EDIN-X cannot be mounted in an inverted position Inverted Models Inverted models not available BCD-7001-EDIN-0 BCD-7001-EDIN-X -90 -90 -60 -120 -150 -30 35 30 25 20 150 15 10 5 30 120 60 -60 -120 -150 180 --- 0 -30 35 180 30 25 20 150 15 10 5 0 30 120 60 90 90 Horizontal 0° | Vertical Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice. REV061115R www.amphenol-antennas.com 2 of 2