Preview only show first 10 pages with watermark. For full document please download

99-7313 Installation Instructions

   EMBED

Share

Transcript

KIT FEATURES DIN head unit provisions Pocket 99-7313 INSTALLATION INSTRUCTIONS KIT COMPONENTS Radio Housing APPLICATIONS CAR PAGE HYUNDAI Elantra 2001-02.......................................................1-2 Tiburon 2003...........................................................1-2 TOOLS REQUIRED Phillips screwdriver 1-800-221-0932 rev. 140202 www.metraonline.com © COPYRIGHT 2001 METRA ELECTRONICS CORPORATION HYUNDAI Elantra 2001-02 2 1 ALL VEHICLES 3 4 A B C D A) Strip wire ends back ½" B) Twist ends together C) Solder D) Tape Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2) Phillips screws under the instrument cluster. Remove the ashtray and (2) Phillips screws exposed in the ashtray cavity. Unclip the radio/instrument cluster trim bezel and remove. Remove (4) Phillips screws securing the factory head unit and disconnect the wiring. Locate the Radio Housing. Skip to the Installation Instructions for ALL VEHICLES on Page #2. HYUNDAI Tiburon 2003 1 Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip the radio/climate control trim bezel (starting with the bottom edge) and remove the bezel. Remove (2) Phillips screws securing the factory head unit and disconnect the wiring. 1 Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit). 5 2 Cut and remove the LOWER mounting tabs on the Radio Housing. Skip to the Installation Instructions for ALL VEHICLES on Page #2. Re-connect the battery terminal and test the unit for proper operation. Mount the head uni t/kit assembly to the sub-dash with the Phillips screws previously removed in step #1. 2