Transcript
Installation Instructions KB-DT5K-PM45 45° Panel Mount Keyboard 1. Install 1/4-20 machine screws with sealing washers from underside of keyboard in the four places shown in Figure 2. There should also be sealing washers or RTV between the Mounting Bracket and Panel.
FIGURE 1 – Side View PANEL
NOTE: Screws, sealing washers, and RTV are not provided.
MOUNTING BRACKET
TYPING SURFACE OF KEYBOARD
2. Route the necessary cables through the cable gland. 3. Install the cable gland into the panel. optional.
Location is
NOTE: 1.26" - 1.30" Cable Gland Hole diameter 0.394" Maximum Panel thickness
CABLE GLAND
FIGURE 2 – Rear View of Wall Mounting Bracket 1/4-20 MACHINE SCREWS IN PANEL (4 PLACES AS SHOWN, NOT PROVIDED)
36.68 mm (1.444")
57.8 mm (2.27")
355.6 mm (14.00") 413.3 mm (16.27") 99040A • December 31, 2015 • www.HopeIndustrial.com • International: +1 (678) 762-9790 • UK: +44 (0) 20 7193 2618 • Copyright © 2016 Hope Industrial Systems, Inc.
