Transcript
AB-311 iBus Wall-Dock for A-BUSTM TM
By
The AB-311 is an A-BUSTM local input module that was specially designed for the Apple R iPod R and iPod mini R. The attractive wall mount remains unobtrusive while not in use, yet its support ledge with integrated dock connector slides out easily, ready to dock your iPod at all times. (See Made For section on page 3 for a complete list of compatible iPods.) Features: ! Compatible with all standard A-BUSTM systems ! Charges the iPod ! Senses audio to automatically override the main A-BUSTM source Support Clip Hold the top of the iPod securely. 3 support clips are supplied: 1 for iPod mini, 1 for iPod nano, and 1 for other iPod models
Slide-out Cradle Provides support for the iPod and holds the dock connector. The support ledge slides into the AB-311 when not in use.
Dock Connector Delivers power to the iPod for charging and provides audio to the A-BUSTM whole-house audio system. 2
Compatibility Made For iPods with dock connector: ! iPod photo ! iPod mini ! 4th Generation iPod with omni (dock) connector ! 3rd Generation iPod with omni (dock) connector TM
This product is compatible with all Channel Vision A-BUSTM products as well as all 3rd party products that carry the A-BUSTM Logo.
Other Required Components The AB-311 is not a standalone device. It must be installed as part of an A-BUSTM system which requires the following components: Hub with Power Supply: IN
OUT
1
2
3
4 BRN WHT/BRM BLU WHT/BLU GRN WHT/GRN ORG WHT/ORG
by
C HANNEL V ISION
AB-404
P-1014 (power supply included)
TM
OR AB-T2454
PRO EL
Model P-1014 System Input
CHANN V I S ION
TM
Zone 1
ribution BUS Dist 1 x 4 AIR
System
L
Zone 3
Zone 2
Zone 4
Module
Power
Status +12VDC
+24VDC
Emitters
Signal
Priority
Expansion Output
Local Local Input
R
Amplified Keypad: AB-114
Single Source Input Module: STATUS 12VDC
AUDIO L
R
By
C HANNEL V ISION
AB-202 A-BUS OUTPUT
AB-202
TM
STATUS IR IR EMITTERS
Speakers: In-ceiling, In-wall and free standing 8 ohm speakers are acceptable.
3
System Wiring Diagram Using the AB-311 local source input module
PRO EL
Tape Monitor or Room 2 output
Model P-1014 System Input
CHANN V ISION
TM
Zone 3
Zone 2
Zone 1
Zone 4
le n Modu stributio
Sat radio System
DVD player
Signal
Priority
L
BUS Di 1 x 4 A-
IR
ion Expans Output
Status +12VDC
Power +24VDC
Emitters
Local Local Input
R
CD player
Receiver
(Optional) IR emitters
AB-311 (Rear) OUT
OUT
IN
IN
AB-114
AB-311 (Front)
Speakers
4
Installation 1. Mount the AB-311 in a low voltage ring or junction box.
2. Install the trim ring.
3. Select the appropriate support clip for your iPod Note: there are 2 support clips provided to accommodate both standard iPods and the iPod mini
Support Clips
5
4. Open the slide-out cradle and dock your iPod.
Slide-out Cradle
5. Enjoy your music! AB-311 (shown with iPod mini installed next to AB-114 keypad)
Connection Tips and Troubleshooting Trouble? 1) Be sure you have connected the CAT-5 cable correctly. Note that the stripe/solid pattern should match the labels on the product. Miss-wiring can cause distorted sound or prevent the system from working at all! 2) Be sure you have connected the speakers in phase. Follow the label on the product. Out of phase speakers can rob the system of its bass. Especially when driving dual-voice-coil speakers. Connections: IN
6
OUT
Input/Output ... To simplify installation, the AB-311 has both 110 and RJ-45 inputs and outputs. Only one of the inputs and one of the outputs should be used at a time.
Stripping and Connecting CAT-5 Wire CAT-5 cable should be stripped with a proper stripping tool, such as Channel Vision’s J-110 tool. 1. Place the CAT-5 between the blade and the first notch of the J-110 tool. Cat5
Blade
2. Rotate the tool only once around the CAT-5. Multiple turns will cause you to cut into the inner wires. Rotate 1 turn only 3. Inspect the inner wires for damage. If any wires are cut start over at step 1.
Check for damage
Slight pressure
4. Use any standard 110 punch-down tool to properly seat all wires. Note: Do NOT use a screwdriver or any other tool that is not specifically designed for terminating UTP cable. Using improper tools will damage the connector!
Specifications: (typical @25º C) Operating Voltage : 24±.5VDC Cable requirements: CAT-5 or better Operating Temperature: -10ºC to +50ºC Specifications subject to change without notice.
iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries. A-BUS is a registered trademark of LeisureTech Electronics Pty Ltd
7
Channel Vision Technology will repair or replace any defect in material or workmanship which occurs during normal use of this product with new or rebuilt parts, free of charge in the USA, for two years from the date of original purchase. This is a no hassle warranty with no mail in warranty card needed. This warranty does not cover damages in shipment, failures caused by other products not supplied by Channel Vision Technology, or failures due to accident, misuse, abuse, or alteration of the equipment. This warranty is extended only to the original purchaser, and a purchase receipt, invoice, or other proof of original purchase date will be required before warranty repairs are provided. Mail in service can be obtained during the warranty period by calling (800) 840-0288 toll free. A Return Authorization number must be obtained in advance and can be marked on the outside of the shipping carton. This warranty gives you specific legal rights and you may have other rights (which vary from state to state). If a problem with this product develops during or after the warranty period, please contact Channel Vision Technology, your dealer or any factory-authorized service center.
500-111 revE
