Transcript
ANT
POWER
SYNC
C
RELAY 1 RELAY 2 RELAY 3 RELAY 4
ERASE TIMER SELECT
SIGNAL TEST
RELAY 3
FUSE
RELAY 2
FUSE
FUSE
FUSE
RELAY 1
RELAY 4
FUSE
Fig 1.1
B
A
LOAD 230V INPUT SUPPLY
QS-ELITE-1
Sync/Pair Button – Press once to auto pair. See Advanced operation for other pairing options.
Status LEDs– Flash when signals are sent/received
Erase Button – Press and hold to erase all pairings, see advanced operation for individual erase Timer Select Button – Used to select timer mode
Mag sync – Touch a magnet to the plastic case in the cross hatched area to replicate the sync button on board without opening the case
Signal Test mode – Press to enter signal test mode Momentary/Latching Jumper Links – It is possible to set the relay switches on the ELITE receiver to either momentary or latching operation. Latching (link fitted) - One press for on, one press for off. Momentary (link removed) - On while button is held only. To set a relay switch to either momentary/latching choose the associated link cap. NOTE: If link is changed, power cycle the receiver (turn off/on) otherwise it will stay in the same mode it was previously set in.
POWER
RELAY 1 RELAY 2 RELAY 3 RELAY 4
SYNC
8
ERASE
7
TIMER
6
TEST
5 4
RELAY 3
FUSE
RELAY 2
FUSE
FUSE
FUSE
RELAY 1
3
RELAY 4
2
FUSE
L
N
1
E
L N E
L N E
L N E
L N E
Relay switch terminals: Output Fuses must be 4A (Slow blow fuses recommended) 230Vac power input
Earth
Neutral
Live
Power input fuse – must be 500mA (Fast blow fuse recommended)
