Transcript
25G Accessories
25AG Top Section
25AG1 Top Section
25AG2 Top Section
25AG3 Top Section
25AG4 Top Section
25AG5 Top Section
TS 2.25 O.D. 14 Ga. Wall
TS 2.25" O.D. 14GA. WALL
Set screw lugs. Screws shipped inside leg.
TS 2.75” O.D. 16 Ga. Wall
Bearing Plate BPL25G Long legs provide extra clearance for installation of equipment. Bolts to top of standard section. Drilled to accept TB3 or TB4 thrust bearing.
1’ 5-1/4”
Set screw lugs. Screws shipped inside leg.
8’ 3-1/2 Overall height
1’4-3/4”
8’ 3/16” Overall height
9’3-1/2” Overall height
9'9" OVERALL HEIGHT
9'3" OVERALL HEIGHT
9'0" OVERALL HEIGHT
40"
1’ 1/4”
1'3"
1'3"
1’4-3/4”
1'6"
1'0"
SET SCREW LUG. SCREW SHIPPED INSIDE LEG.
1'4"
8-1/4"
1’0”
1-1/4" STD. PIPE (1.66" O.D.) 1-1/4" N.P.T.
25AG IS SUPPLIED WITH BUSHING INSTALLED. CAN BE REMOVED. TS 2.00" O.D. 16GA. WALL
Erection Fixture EF2545 2-1/2” sheave with 3/8”ID groove. For lifting tower sections during installation. Note: Erection fixtures should only be used to raise one section, or any part of a section, at one time. They are not intended for the lifting of people.
Assembly Plate/Top Beacon Plate APL25G For Mounting red beacon. Bolts to top of standard section. Thrust Bearing TB3 Supports up to a 2” O.D. mast. TB4 (not shown) Supports up to a 3” O.D. mast. Rotor Post (Left) RP25G (Right) RP25G CM Special Rotor Post Accessory Shelf AS25G For mounting many popular rotors. Fiels drilling may be necessary for some rotors. Bearing/Accessory Shelf BA25G Drilling to accept thrust bearing on top plate. Accessory shelf drilled for mounting many popular rotors.
WARNING WARNING WARNING THIS ITEM IS NOT INTENDED FOR THE LIFTING OF PERSONNEL See safety precaution literature
Tower Bushing TB50 For use in 25AG and ST25AG Top sections 1-1/4” I.D. x 2” O.D. TB75 Tower Bushing 1-1/2” I.D. x 2” O.D.
Copyright 1995 ROHN Specifications subject to change without notice. See ROHN safety publication 93-2754C for important information prior to using, installing or dismantling any towers, parts bases or accessories.
25G-16
