Preview only show first 10 pages with watermark. For full document please download

Ademco - 443 Line Security Modularm

   EMBED

Share

Transcript

AT THE PREMISES: I) Install No. 442 Transmitting Unit (See Instructions Supplied with No. 442) No. 442 AT HEADQUARTERS: 1 } ’ I I I I I I I I). Connect Terminals Console 2) Wire 6 volts from No. 644 Energy Pack to center termi na I strip of cabinet. Attach (+I to terminal (-1 to terminal 3. 3) of Contro Plug in Module phone I i nes to rear plug 5 (-1 and 6 (+I of NO. 132 Cabinet. OBSERVE POLAR I Ty . No. 443 Line I, Security 24 V. I I I NO. 644 . The No. 443 Line Security Modularm is designed for those special jobs that require A special supervisory signal is sent over the telehigh telephone line security. This special signal provides the line security since phone lines to the No. 443. Tamper i ng it becomes extremely difficult to compromise the telephone lines. with the telephone lines wi II result in the signal at the No. 443 in the pol i ce station. I NSTALLAT I ON The installation of the No. 443 is identical to that of Modularm 130; on exis ting the telephone lines into the No. installations just plug the No. 443 and connect For new installations refer to Modularm 130 instructions. 132 Console Cabinet. Note: The and within Transmitting No. 443 Line Security Modularm can the same system as other Modularms. Unit must be used at the premises OPERATING INSTRUCTIONS - When a burglar alarm lights to indicate the location of the alarm. also sound until the reset button is pushed. the red lamp will remain lit until the control a be intermixed in the same However, a No. 442 Line to send the Line Security cabinet Security signals. occurs, the red lamp on the No. ‘The horn in the console cabinet Even though the horn is silenced, at the premises is reset. 443 wi I I The white trouble lamp will light in the event that power is interrupted on the phone lines such as would happen when the phone lines are cut or shorted. A similar signal would be received if someone tried to impose a voltage over the When the officer on duty silences the horn by pressing the reset telephone lines. button the white lamp will stay on until the trouble condition is corrected. 101 www.PDF-Zoo.com RECHARGE-A-DACK ( LT97 1