Preview only show first 10 pages with watermark. For full document please download

Adjustable Sling Cpu Holder Installation Instructions

   EMBED

Share

Transcript

Adjustable Sling CPU Holder Installation Instructions 12/15/2014 ke_ii_adj_sling_cpu_holder_d_front_c.eps at 180% 5AD9050 Tools Needed Tools Included • Drill • #3 Phillips screwdriver • Allen wrench Step 1: Attach Track to Worksurface 1. Position track (A) in desired location. Make sure track (A) is perpendicular to front edge of worksurface. 2. Use track (A) as a template, and drill 1/16” pilot holes 1/2” DP. 3. Secure track using screws (B). A B Step 2: Place CPU into Sling Step 3: Install CPU Sling to Track 1. Use stored Allen wrench (D) from the back of sling CPU holder to press release tab (H). Pull out sling (C). 2. Slide CPU into sling (C) with CPU centered front to back and side to side. ke_ii_adj_sling_cpu_holder_d_1.eps 1. Slide glide plate (E) into track (A). : 1” = 4mm 2. Secure track face platescale (F) with screws (G). Adjust CPU in sling (C) to make it hang level. 3. Firmly tighten sling (C) around CPU using provided Allen wrench (D). Return Allen wrench (D) to its storage location. Back view Front view D H A F G D E C C CPU Removal ke_ii_adj_sling_cpu_holder_d_2_c.eps scale : 1” = 4mm 1. Remove track face plate (F) by loosening screws (G). 2. Slide CPU from track (A). 3. Use stored Allen wrench (D) to press release tab (H). Pull on sling (C) to create slack. ke_ii_adj_sling_cpu_holder_d_3.eps scale : 1” = 4mm