Transcript
airCUE-7 CS0374
Physical Description Microphone Motion sensor
IR transmitter IR capture receiver
IR receiver Light sensor
Speakers Power supply connector
Multifunctional button System default button
Integrated kickstand
Reset button
Charging It is recommended that you leave the unit connected to external power adapter until the battery is fully charged. It may take up to 2.5 hours. Direct Charging
Using Tabletop Docking Station
1. Plug the adapter cable into the power connector located on the left side of the airCUE-7.
1. Plug the adapter cable into the power connector located on the bottom side of tabletop docking station.
2. Plug the adapter into an AC outlet.
2. Plug the adapter into an AC outlet. 3. Place airCUE-7 into tabletop docking station.
Power supply
Power supply
Multifunctional Button
System Default Button
Default functionality
When pressed the factory default function is performed. The factory default setup is as follows
• Short press displays OSD (On Screen Display) default page. • Long press (approx. 3 seconds) displays OSD Exit page, where you can Power Off or Standby the unit. Note: If programmed, current running application takes control over button functionality.
•
IP address: 192.168.1.128
•
IP Mask: 255.255.255.0
•
Password: Empty (no input required)
Reset Button When pressed the reset of the unit is performed followed by operating system boot taking approx. 15 seconds.
User Manual Complete user manual can be downloaded here: http://www.cuesystem.com/wireless_touch_panels_cuenium2.aspx
www.cuesystem.com |
[email protected] © CUE, a.s. | All rights reserved. | Specifications are subject to change without prior notice.
Data Sheet DS077 Revised 17.10.2012
