Transcript
Align 300
Installation Instructions INSTALLATION WARNINGS: Read the entire instruction sheet before you begin installation or assembly. Installer must verify that the wall will safely support the combined weight of all the attached equipment and hardware. Improper installation of this product can cause extensive property damage or serious personal injury, either during or after the installation. It is the responsibility of the installer to ensure that all applications including wood, concrete, block, brick, steel, etc. are secured properly to code. California Installations could require specific anchorage, and additional mounting screws. Check with local authorities for codes in your area. Other seismic states have similar regulations. DISCLAIMER: The Manufacturer and/or Distributor will bear no responsibility for any damages of any kind arising from any improper installation of this product. Because wall construction varies widely and the ultimate method of mounting is out of the Manufacturers or Distributors control, it is imperative that the installer consult with local engineering, architectural, or construction personal to ensure the wall mount is constructed properly and to code to handle the applied load.
Parts in Box
Provided
Tools Needed
5x #12 x 2-1/2
5x 1/4-20 x 3
4x
4x
M4 x 8mm M4 x 12mm
6x Velcro 1x Mouse House 1x Quick Connect Bracket
5x Toggler Bolts
1x Track Cover 1/8" 3/16" 154420180 Rev. A
Align 300
Slide keyboard assembly on to track and tighten in position with hand knob.
Installation Instructions
Locate the wall stud and mark the top hole. 1/8˝
Drill a pilot hole and insert screw part way. Place a level on the side of mount and mark other holes. Drill pilot holes. Tighten all screws to the wall.
NOTE: Refer to instruction sheet included with track for deatils on different wall mounting conditions.
Slide LCD assembly on to track and tighten in position with hand knob. Remove the end cap at one top of the track slider.
1/8˝
Replace end cap and tighten.
Affix the mouse holder to the underside of the keyboard tray.
Using the screws provided and a Phillips head screwdriver, attach the LCD to the Quick Connect Bracket. Slide the Quick Connect Bracket on to the mounting plate.
Affix the 6 Velcro hook and loops to the underside of the keyboard. Position and press the keyboard firmly onto the keyboard tray.
*Release Points Using the Height Adjustable Cable Manager:
Adjusting the Height Adjustable Segment: 1. With the monitor mounted to the arm, move the monitor through the height range; Ensure the arm will hold the monitor in the position you placed it. 2. If the monitor drops or rebounds upward, adjust the tension screw at the back of the arm segment as shown using the 3/16” Allen key. Repeat steps until the monitor is counterbalanced. 3. Repeat for keyboard tray counterbalance.
1. Remove cable manager by pinching at release points. 3/16˝
2. Lay cables in cable manager. 3. Snap cable manager back into place. Note text indication “FRONT” inside cable manager. 4. Repeat for keyboard tray cable manager.
