Transcript
Issued November 1996
10572
Anti Static Products RS stock no. 229-2116 Footwear test station/calibration unit 1. 2. 3. 4. 5. 6.
Insert the two wires into the mating banana sockets on top of the calibration monitor. Remove the top section control panel from the tester. Remove left hand cable from the footwear tester control panel. Insert one of the cables from the calibrator into this part on the control panel. Set the calibrator low fail. Hold the remaining wire from the calibration unit and hold it on the left hand metal footplate of the test station. 7. Repeat the above for the other test positions on the calibration unit. 8. Replace the left hand banana contact of the test station, remove the right hand wire and insert the calibration units cable. Repeat the above tests but on the right hand metal footplate. Results Calibration monitor setting Low fail Low pass High pass High fail
Footwear test station Low fail light flashes Pass light Pass light High fail
*Repeat test at regular intervals
Technical Specification Two straight cables with moulded strain relief 4mm banana plug connectors to each end. High impact box: ________________________________________95mm x 58mm 21mm Fitted with two banana sockets to the top. 4 position range testing selector switch to the front. Low fail:______________________________________________________855k/Ohms ± 1% Low pass: __________________________________________________945 K/Ohms ± 1% High pass: ________________________________________________33.25 M/Ohms ± 1% High fail: __________________________________________________36.75 M/Ohm ± 1%
The information provided in RS instruction leaflet is believed to be accurate and reliable;however, RS Components assumes no responsibility for inaccuracies or omissions, or for the use of this information, and all use of such information shall be entirely at the user’s own risk. No responsibility is assumed by RS Components for any infringements of patents or other rights of third parties which may result from its use. Specifications shown in RS Components instruction leaflets are subject to change without notice.
RS Components, PO Box 99, Corby, Northants, NN17 9RS An Electrocomponents Company
Telephone: 01536 201234 © RS Components 1996
