Ar-b1551 Manual Version 1.31

Transcript

1.1. PACKING LIST AR-B1551 Manual Version 1.31 1. SETTING UP THE SYSTEM The AR-B1551 is new generation 3.5” CPU board. This section provides hardware’s jumpers setting, the connectors’ locations, and the pin assignment. LVDS1 FDD LPT TS1TS2 IDE1 IDE1 LCD1 CF1 USB1 AUDIO 1 1.4. FDD PORT CONNECTOR (FDD) LED1 H4 P3 P1 COM1 1.3. HARD DISK CONNECTOR U5 PC1 H3 PWR4 - AR-B1551V1.0 U3 PWR8 JP3 JP2 JP1 J1 JP4 IR COM2 The quick setup manual 1 AR-B1551 all-in-one single CPU board 1 Hard disk drive interface cable 1 floppy interface cable 1 Audio adapter cable 1 LPT cable Acrosser’s AR-B9425 audio card Software Utility CD - 1.2. SDRAM SOCKET 144 PIN, 128MB MAXIMUM (DIMM1) H2 H1 JP6 1.5. PARALLEL PORT CONNECTOR (LPT) KM CRT LAN1 RST 33 2 DIMM1 U22 PIN Signal Pin Signal 1-33(odd) GROUND 18 -DIRECTION 2 20 -STEP OUTPUT PULSE 4 -REDUCED WRITE CURRENT NOT USED 22 -WRITE DATA 6 NOT USED 24 -WRITE ENABLE 8 -INDEX 26 -TRACK 0 10 -MOTOR ENABLE A -DRIVE SELECT B -DRIVE SELECT A -MOTOR ENABLE B 28 -WRITE PROTECT 30 -READ DATA 32 -SIDE 1 SELECT 34 DISK CHANGE 12 14 16 26 24 22 20 18 16 14 12 10 8 6 4 2 CN8 1 DB-25 1 -Strobe Signal 3 2 Data 0 4 15 -Error 5 3 Data 1 6 16 -Initialize 7 4 Data 2 8 17 -Printer Select In 9 5 Data 3 10 18 Ground 11 6 Data 4 12 19 Ground 13 7 Data 5 14 20 Ground 15 8 Data 6 16 21 Ground 17 9 Data 7 18 22 Ground 19 10 -Acknowledge 20 23 Ground 21 11 Busy 22 24 Ground 23 12 Paper 24 25 Ground 25 13 Printer Select 26 -- No Used CN8 DB-25 2 14 Signal -Auto Form Feed 1.6. KEYBOARD & MOUSE CONNECTOR (KM) 1 34 CF1 25 23 21 19 17 15 13 11 9 7 5 3 1 KM 1 2 3 4 5 6 KDT MDT GND VCC KCLK MCLK 1 2 3 4 5 6 Front View ___________________________________________________________________________________________________________________________ Page 1 of 3 AR-B1551 Manual Part No: 220010098 1.7. USB CONNECTOR (USB1) 1.13 IRDA HEADER (IR) 1.16. RESET BUTTON (RST) 1 VCC 1. USBVCC1 2. USBVCC2 3. USBD1F4. USBD2F5. USEB1F+ 6. USBD2F+ 7.8. GND 9.10. GND. 2 4 6 8 10 1 3 5 7 9 1 1 2 2 OFF ON Factory Preset 1 2 1 2 USED RS232 & RS485 1 2 COM1 3 6 3 7 4 5 3.RX 4.RTS 5.TX 6.CTS 7.DTR 8.RI 1.11. CRT CONNECTOR (CRT) RS485 Terminator Select (JP6) 4 5 8 CRT (CRT Connector) 6 1 Red Green 11 2 3 Blue 13 Horizontial 14 Vertical Sync 4, 9, & 11 Not used 5 & 10 Ground 6, 7 & 8 AGND 12 DDC DATA 15 15 DDC CLOCK 10 9 1.12. NETWORK SETTING -RJ-45 Connector (LAN1) 8 1 P1 1 P3 2 3 1 2 3 A B C RS-232 Factory Preset A B C RS-485 4 3 2 1 SW2 1 4 GND 2 SW PUSHBUTTON 5 IRTX 9.GND P/WLED CFLED HDLED 1.9. COM1 1 2 5 1.DCD 2.DSR ONLY RS232 3 - 3 IRRX 1.10. COM2 9 1 1. 2. 3. 2 NOT USED 1.14 TOUCH SCREEN 1.8. LED HEADER (LED1) LED1 IR PIN (LAN1 1 2 3 4 5 6 7 8 FUNCTION TPTX+ TPTX TPRX+ Not Used Not Used TPRX Not Used Not Used -TS1 1.RXD1F 2.TXD1F 3.CGND1 T.S.1 3 2 1 1.17. 26-PIN AUDIO CONNECTOR (AUDIO1) -TS2 1.RXD2F 2.TXD2F 3.CGND2 T.S.2 3 2 1 13 1 26 14 FUNCTION TXOUT0TXOUT0+ TXOUT1TXOUT1+ TXOUT2TXOUT2+ TXCLKTXCLK+ TXOUT3TXOUT3+ VTKBP VTX5 VTX5 GND GND VTX5 VTX5 NC GND GND VTX12 VTX12 GND NC NC NC 1 26 2 Audio Connector 1.15 LVDS HEADER (LVDS1) PIN (LVDS1) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 25 CN9 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 SIGNAL CDINL LININL CDINR LININR VCC NC LINOUTL MICIN LINOUTR PCBEEP GND NC NC GNDAUD GND NC NC NC NC NC NC NC NC NC GNDAUD GND _________________________________________________________________________________________________________________________ Page 2 of 3 AR-B1551 Manual PART NO: 220010098 1.18. LCD PANEL DISPLAY CONNECTOR (LCD1) 43 44 (1) 64 Pin PC/104 Connector Bus A & B (PC2) 2 1 2 Pin 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43 Signal GND GND VSYNCR Not Used FPDR0 FPDR2 GND FPDR5 Not Used FPDR7 FPDR8 FPDR10 Not Used GND FPDR13 FPDR15 FPDR17 VCC +12V GND DISPENR GND Pin 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44 Signal CLK HSYNCR GND Not Used FPDR1 FPDR3 FPDR4 Not Used FPDR6 GND FPDR9 FPDR11 Not Used FPDR12 FPDR14 FPDR16 GND VCC +12V GND GKLENR VDDEN 1.19. POWER CONNECTOR (PWR4 & PWR8) 1 +12V PWR4 2 GND 4 3 2 1 1 2 3 4 5 6 7 8 JP2 64 1 64-Pin PC/104 Connector 1 2 1 3 5 63 39 40 2 4 6 40 Pin PC/104 Connector 1.21. BATTERY SELECT (J1 & JP1) „ „ Internal BAT: JP1 2-3 ON External BAT: JP1 1-2 ON JP1 JUMPER VOLTAGE 1-3 ON 2-4 ON 3-5 ON 4-6 ON VCC3 NOTE Factory Preset VCC 1.23. DOC ADDRESS SELECT (JP4) 1 1.EXBAT 2 JP4 2.VCC 1 3 3.INTVBAT Factory Preset 2 J1 1 1.EXBAT 2 2.GND 1.22. VOLTAGE SELECT (JP2 & JP3) „ Lvds 1 JUMPER ADDRESS NOTE OFF C8000 Factory Preset ON D0000 1.24. DOC SOCKET (U22) JP3 4 +5V GND +5 VDC +5 VDC GND GND +12 VDC -12 VDC -5 VDC LCD 1 (2) 40 Pin PC/104 Connector Bus A & B (PC1) 3 GND 1 2 3 4 5 6 7 8 „ 1.20. PC104 CONNECTOR 1 3 5 JUMPER VOLTAGE 1-3 ON 2-4 ON 3-5 ON 4-6 ON VCC VCC3 2 4 6 NOTE NOTE: OFF = Without Jumper. On = With Jumper Factory Preset Note: If the content in Setting is inconsistent with CD-ROM. Please refer to the Setting as priority. _________________________________________________________________________________________________________________________ Page 3 of 3 AR-B1551 Manual PART NO: 220010098