Atp Velocity Si Pro 2.5” Sata Ssd Specification

Transcript

Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification ATP Velocity SI Pro 2.5” SATA SSD Specification Version 1.1 Your Ultimate Memory Solution! 1 ATP Confidential & Proprietary Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification Disclaimer ATP Electronics Inc. shall not be liable for any errors or omissions that may appear in this document, and disclaims responsibility for any consequences resulting from the use of the information set forth herein. The information in this manual is subject to change without notice. ATP general policy does not recommend the use of its products in life support applications where in a failure or malfunction of the product may directly threaten life or injury. All parts of the ATP documentation are protected by copyright law and all rights are reserved. This documentation may not, in whole or in part, be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable form without prior consent, in writing, from ATP Corporation. The information set forth in this document is considered to be “Proprietary” and “Confidential” property owned by ATP. Revision History Date Version Dec. 19th, 2011 Jan. 5th, 2012 1.0 1.1 Changes compared to previous issue - First release - Revise P/N and image to PowerProtector only Your Ultimate Memory Solution! 2 ATP Confidential & Proprietary Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification Table of Contents INTRODUCTION ..................................................................................................................4 MAIN FEATURE ...................................................................................................................4 BLOCK DIAGRAM...............................................................................................................5 SATA SSD PIN ASSIGNMENT ...........................................................................................7 SYSTEM POWER REQUIREMENT ..................................................................................7 ENVIRONMENT SPECIFICATIONS ................................................................................8 RELIABILITY .......................................................................................................................8 TBW (TOTAL BYTES WRITTEN).....................................................................................8 PERFORMANCE...................................................................................................................8 ATA FEATURE SET .............................................................................................................9 ATA COMMAND SET ..........................................................................................................9 POWER MANAGEMENT SUPPORT ..............................................................................11 SMART COMMAND SET ..................................................................................................12 SMART ATTRIBUTE .........................................................................................................12 PHYSICAL DIMENSION SPECIFICATIONS ................................................................13 MECHANICAL FORM FACTOR (UNITS IN MM) .......................................................13 Your Ultimate Memory Solution! 3 ATP Confidential & Proprietary Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification Introduction ATP Velocity SI Pro 2.5” SSD is a best-in-class wide-temp industrial grade SLC SSD solution with enterprise-class features. SI Pro SSD offers outstanding performance and proven reliability, ideal for extreme performance, high data security (AES 128/256 encryption), and consistent data integrity requirement (ATP PowerProtector technology), suited for POS, industrial computers, data center and industrial applications exposed to mission critical, high shock and vibration environments. Main Feature SSD Processor with enterprise-class features for cost-sensitive client environment Capacities: 240GB/120GB/60GB/30GB SLC (Single Level Cell) NAND flash memory Maximum performance: Sequential read up to 500MB/s, sequential write up to 500MB/s (Without external SDRAM buffer memory ) Random Read IOPS up to 60K, sustain write IOPS up to 20K ATP PowerProtector technology ATP secure erase ATP SSD life monitor RAISE provides RAID-like protection for single SSD client systems Operating temperature: -40oC to +85oC 6Gb/s SATA V3.0 compliant and backward compatible with SATA 3.0/1.5 Gb/s with NCQ/TRIM RoHS compliant CE , FCC & VCCI certification Your Ultimate Memory Solution! 4 ATP Confidential & Proprietary Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification Block Diagram ATP SI Pro 2.5” SATA SSD consists of below functional blocks. The advanced architecture is optimized to provide highest data reliability and transfer performance. Voltage Regulator (5V to 3.3V/ Flash Controller (Channel 0) Flash Controller (Channel 1) Flash Controller (Channel 2) SATA Host Device Flash Controller (Channel 3) SSD controller Flash Controller (Channel 4) 55b/512B ECC Interface RAISE Flash Controller (Channel 5) Intelligent wearLeveling Flash Controller (Channel 6) Automatic Encryption (AES-128/256) Flash Controller (Channel 7) Your Ultimate Memory Solution! 5 ATP Confidential & Proprietary 8/16 pieces of SLC NAND Flash Memory Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification Product Images AF240GSSCJ-MAAXP Capacities ATP P/N AF30GSSCJ-MAAXP AF60GSSCJ-MAAXP AF120GSSCJ-MAAXP AF240GSSCJ-MAAXP ATP EXTERNAL P/N AF30GSSCJ-MAAXP AF60GSSCJ-MAAXP AF120GSSCJ-MAAXP AF240GSSCJ-MAAXP Notes: 1. 1 GB = 1,000,000,000 Byte Your Ultimate Memory Solution! 6 ATP Confidential & Proprietary CAPACITY 30GB 60GB 120GB 240GB PowerProtector Yes Yes Yes Yes Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification SATA SSD Pin Assignment Group Pin No.1 Function Description GND A+ AGND BB+ GND Ground Signal Segment S1 S2 S3 S4 S5 S6 S7 Differential signal pair A Ground Differential signal pair B Ground Key & Spacing Power Segment P1 P2 P3 P4 P5 P6 P7 P8 P9 P10 P11 P12 P13 P14 P15 NC/V33 NC/V33 NC/V33 GND GND GND V5 V5 V5 GND NC/DAS GND NC/V12 NC/V12 NC/V12 3.3V power (Not used) 3.3V power (Not used) 3.3V power (Not used) Ground Ground Ground 5V power, pre-charge 5V power 5V power Ground Not used Ground 12V power (Not used) 12V power (Not used) 12V power (Not used) Notes: 1. All pins are in a single row, with a 1.27 mm (0.050”) pitch. System Power Requirement Parameter Symbol Min Type Max Unit Supply voltage Active power Idle power VCC PW PS 4.5 5.0 2.5 0.5 5.5 7 V W W - Your Ultimate Memory Solution! 7 ATP Confidential & Proprietary - Remark RMS value RMS value Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification Environment Specifications Type Operating Non-Operating Operating Non-Operating Value -40oC to 85oC -45oC to 85oC 25oC，8% to 95%, noncondensing 40oC，8% to 93%, noncondensing Vibration Operating sine 16.4G, 10~2000Hz Shock Operating Half sine 1500G/0.5ms Operating Non-Operating 80,000 feet Max. 80,000 feet Max. Temperature Humidity Altitude Reliability Type Value MTBF 2,000,000 hours Notes: 1. The Mean Time Between Failures (MTBF) is calculated using a prediction methodology, Telcordia SR-332, which based on reliability data of the individual components in the SSD. It assumes nominal voltage, with all other parameters within specified range. TBW (Total Bytes Written) TBW (total bytes written) is an index of how many TB (Terabytes) can be used for written under product life time. This value varies from SSD density Type Value (TB=Tera-Bytes, Decimal) 30GB 900TB 60GB 1800TB 120GB 3600TB 240GB 7200TB Performance Type Value Host Interface Speed SATA 1.5Gb/s, 3.0Gb/s and 6.0Gb/s Sequential Read: up to 500MB/s Data Transfer Rate Sequential Write: up to 500MB/s Random Read IOPS1 4KB Random Read: up to 60,000 IOPS Notes: 1:IOPS: Input/Output Operations per Second Your Ultimate Memory Solution! 8 ATP Confidential & Proprietary Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification ATA Feature Set Feature 48-Bit Address feature set Advanced Power Management (APM) feature set General feature set General Purpose Logging (GPL) feature set Long Logical Sector (LLS) feature set non-512 Native Command Queuing (NCQ) feature set Power Management feature set Power-Up In Standby (PUIS) feature set Security feature set S.M.A.R.T. feature set Software Settings Preservation (SSP) feature set Write-Read-Verify feature set Support YES YES YES YES YES YES YES YES YES YES YES YES ATA Command Set Command NOP DATA SET MANAGEMENT RECALIBRATE READ SECTORS READ SECTORS WITHOUT RETRY READ LONG READ LONG WITHOUT RETRY READ SECTOR(S) EXT READ DMA EXT READ NATIVE MAX ADDRESS EXT READ MULTIPLE EXT READ LOG EXT WRITE SECTORS WRITE SECTORS WITHOUT RETRY WRITE LONG WRITE LONG WITHOUT RETRY WRITE SECTORS(S) EXT WRITE DMA EXT SET MAX ADDRESS EXT WRITE MULTIPLE EXT WRITE DMA FUA EXT WRITE LOG EXT READ VERIFY SECTOR(S) READ VERIFY SECTOR(S) (without Retry) READ VERIFY SECTOR(S) EXT WRITE UNCORRECTABLE EXT READ LOG DMA EXT WRITE LOG DMA EXT READ FPDMA QUEUED WRITE FPDMA QUEUED SEEK EXECUTE DEVICE DIAGNOTIC Your Ultimate Memory Solution! 9 ATP Confidential & Proprietary OpCode 00h 06h 10h 20h 21h 22h 23h 24h 25h 27h 29h 2Fh 30h 31h 32h 33h 34h 35h 37h 39h 3Dh 3Fh 40h 41h 42h 45h 47h 57h 60h 61h 70h 90h Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification Command INITIALIZE DEVICE PARAMETERS DOWNLOAD MICROCODE DOWNLOAD MICROCODE DMA SMART READ MULTIPLE WRITE MULTIPLE SET MULTIPLE MODE READ DMA READ DMA WITHOUT RETRIES WRITE DMA WRITE DMA WITHOUT RETRIES WRITE MULTIPLE FUA EXT STANDBY IMMEDIATE IDLE IMMEDIATE STANDBY IDLE READ BUFFER CHECK POWER MODE SLEEP FLUSH CASH WRITE BUFFER READ BUFFER DMA FLUSH CACHE EXT WRITE BUFFER DMA IDENTIFY DEVICE SET FEATURES SECURITY SET PASSWORD SECURITY UNLOCK SECURITY ERASE PREPARE SECURITY ERASE UNIT SECURITY FREEZE LOCK SECURITY DISABLE PASSWORD READ NATIVE MAX ADDRESS SET MAX ADDRESS Your Ultimate Memory Solution! 10 ATP Confidential & Proprietary OpCode 91h 92h 93h B0h C4h C5h C6h C8h C9h CAh CBh CEh E0h E1h E2h E3h E4h E5h E6h E7h E8h E9h EAh EBh ECh EFh F1h F2h F3h F4h F5h F6h F8h F9h Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification Power Management Support ATA Power Modes ACTIVE IDLE STANDBY SLEEP SATA Link Power States ACTIVE – PHY Ready, full power, Tx & Rx operational PARTIAL – Reduced power, resumes in under 10 usec SLUMBER – Reduced power, resumes in under 10 msec HIPM – Host-Initiated Power Management DIPM – Device-Initiated Power Management AUTO-SLUMBER – Automatically transition to partial slumber Your Ultimate Memory Solution! 11 ATP Confidential & Proprietary Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification SMART Command Set Command Reserved SMART read attributes SMART enable/disable attribute autosave SMART execute off-line immediate SMART read log sector SMART write log sector SMART enable operations SMART disable operations SMART return status Reserved (Vendor Specific) Value (Hex) 00-CF D0 D2 D4 D5 D6 D8 D9 DA DC-FF SMART Attribute ID 1 5 9 13 171 172 174 177 181 182 187 194 195 196 201 204 230 231 241 242 Value (Hex) 0x01 0x05 0x09 0x0C 0xAB 0xAC 0xAE 0xB1 0xB5 0xB6 0xBB 0xC2 0xC3 0xC4 0xC9 0xCC 0xE6 0xE7 0xF1 0xF2 Attribute Name Raw Read Error Rate Retired RBlock Count Power-On Hours (POH) Device Power Cycle Count Program Fail Count Erase Fail Count Unexpected Power Loss Count Wear Range Delta Program Fail Count Erase Fail Count Reported Uncorrectable Errors Temperature On-the-Fly ECC Uncorrectable Error Count Reallocation Event Count Uncorrectable Soft Read Error Rate Soft ECC Correction Rate Drive Life Protection Status SSD Life Left Lifetime Writes from Host Lifetime reads from Host Your Ultimate Memory Solution! 12 ATP Confidential & Proprietary Version 1.1 ATP Velocity SI Pro 2.5” SATA SSD Specification Physical Dimension Specifications Type Form factor Length Width Thickness Value 2.5” 100 mm +/- 0.25mm 69.85 mm +/- 0.25mm 9.5 mm +/- 0.25mm Mechanical Form Factor (Units in mm) Standard Profile Mechanicals: Your Ultimate Memory Solution! 13 ATP Confidential & Proprietary