Preview only show first 10 pages with watermark. For full document please download

Attention!! Important Information!!

   EMBED

Share

Transcript

Attention!! Important Information!! (Read the information listed below before using this product.) 1. For the X6DHR-X8G/XiG boards: Jumpers J4F4/J4F5 (PLLSEL Select): These jumpers allow the user to select PLLSEL (Memory Speed). Make sure that the jumper settings are set correctly according to your memory speed before you power on the system. (*Warning!! If these jumpers are not set correctly according to your memory speed, video display failure may occur!!!) PLLSEL Select Jumper Settings (J4F4/J4F5) (*Notes: 1. The default setting is “Closed” for both jumpers to enable DDR Memory at 333MHz. However, if your memory speed is 266MHz, please make sure to set both jumpers to “Open”. If Reg. ECC DDR 333 ((-PC2700)) DDR J4F4 J4F5 *333 MHz Closed Closed 266MHz Open Open memory modules are used, 4 pieces of double banked memory and 6 pieces of single banked memory are supported. ) (*Default:Closed-333MHz) J4F4/J4F5 DIMM 1A DIMM 1B J34 CPU1 J16 DIMM 2B COM1 DIMM 3A DIMM 3B FP CTRL JF1 USB 0/1 DIMM 2A DIMM 4A J14 J4F5 DIMM 4B E7520 Memory Speed J 4 F 4(*Note:4) Mouse 4-Pin 8-Pin CPU PW J 3 8 J1D1 20-PinPW J1B1 JP9 PW FAN1 Fail PW SMB J32 KB J33 FAN2 CPU2 (North Bridge) IDE #1 IDE #2 IPMI 2.0 Floppy BIOS PCI-X GLAN2 SATA0 SATA1 FAN4 FAN5 J11 SMB PCI-X GLAN1 RAGEX Force PW-On WOR ICH5R (South Bridge) PXH S P K R JPL1(LAN Enable) JPG1(VGA Enable) J12 J6 J5 SCSI Ter. B Firmware JPA3 7902 Hub SCSI SCSI E n a b l e JPA1 C T R L JA1 JBT1 Fan3 CH CLR CMOS JP10 Int JP11 J WOH JD2 D JL1 JD1 WOL Alarm S P K P W W D FPUSB0/1 SW LED SW JPA2 COM2 Battery S I/O PXH SCSI Ch A GLAN CTRL SCSI Ter. A J14 VGA LG5 SCSI Ch B ZCR J1D1 (12V 8-pin PWR) and J38 (12 V 4-pin PWR): Make sure that both PWR Connectors are used to ensure adequate power supply to the system and the CPU. Add-X6DHR-8G-07/30/04